Search results for "Surfaces"
showing 10 items of 2837 documents
Structural characterization of TiNxOy/TiO2 single crystalline and nanometric multilayers grown by LP-MOCVD on (110)TiO2
2001
TiO2/TiNxOy superlattices were grown by Low Pressure-Metal-Organic Vapor Phase Epitaxy (LP-MOVPE) technique at deposition temperatures ranking from 650 to 750°C. The growth was performed on top of TiO2(110) rutile substrates. Intense peaks observed in the X-rays rocking curves and θ-2θ diffraction patterns show the presence of crystalline epilayers. The TiNxOy layers were grown in a (200) cubic structure on the (110) quadratic TiO2 epilayer structure. Transmission electron microscopy confirmed the XRD results and showed the formation of periodic and well structured epilayers.
Preparation of photocatalytic brookite thin films
2007
Pure brookite films were deposited from a brookite dispersion obtained by peptizing a mixture brookite–rutile prepared by thermolysis of TiCl4 in a HCl solution. The films were characterised by X-ray diffraction and Raman spectroscopy. The photoactivity of the samples was tested by using the photo-oxidation of 2-propanol in gas–solid regime as a probe reaction. The brookite films efficiently degraded 2-propanol under UV illumination.
Holographic recording of surface relief gratings in tolyle-based azobenzene oligomers
2008
Abstract Holographic recording of surface relief gratings (SRG) in tolyle-based azobenzene oligomer films have been carried out at 514.5 nm. It was experimentally studied by spectroscopic and AFM methods. The maximum surface modulation amplitude was 35 nm. SRG formation is explained by the mean-field model and by the photodegradation of chromophores enabling the directional mass transport as the result of trans–cis transformations. The conclusion is made that SRG are stable but the diffraction efficiency (DE) changes are due to the complementary decaying amplitude-phase gratings. Strong polarization dependences of transmitted and reflected DE are found. They are explained by the diffraction…
Artificially inscribed defects in opal photonic crystals
2005
Opals are three-dimensional photonic crystals, self-assembled from dielectric spherical beads into a face-centered cubic lattice. By introducing intentional defects in the crystal lattice, one modifies features such as spontaneous emission and the directionality of diffracted light. We here present a method for the artificial introduction of a lattice of such intentional defects in self-assembled poly(methyl methacrylate) (PMMA) photonic crystals by means of electron beam lithography. The inscribed defects are of the size of an individual bead, providing a broad spectral range between adjacent resonance peaks. This opens for devices with single line transmission in the photonic band gap, as…
Assessment of the out-plane and in-plane ordering of high quality ZnO nanorods by X-ray multiple diffraction
2013
Abstract ZnO nanorods grown on buffered and non buffered sapphire substrates have been investigated by X-ray multiple diffraction using Renninger scans of the ZnO(0001) and ZnO(0003) forbidden reflections. In this technique the diffracted X-ray beam is simultaneously diffracted by several sets of planes, providing information on the broadening in different directions, as well as from nanorods, and from the layer on which they grow. The intensities and angular widths of peaks obtained by azimuthal and omega scans have been analyzed, making a direct comparison with conventional measurements of the full width at half-maximum of symmetric and asymmetric reflections. The analysis leads to establ…
Chirality effects on 2D phase transitions
1996
Monolayers of the racemate and pure enantiomers of 1-hexadecyl-glycerol were investigated by grazing incidence X-ray diffraction (GID) at 5 and 20 °C on compression from 0 mN m−1 to pressures greater than 30 mN m−1. The racemate lattice is centred-rectangular for both temperatures at all investigated pressures. However, at both temperatures, there is a sharp phase transition from a low-pressure phase, in which the molecules are tilted towards nearest neighbours (NN) and the distortion azimuth also points towards NN, to a high-pressure phase, in which the molecules are tilted towards next-nearest neighbours (NNN) and an NNN-distorted lattice is observed. At 5 °C, the transition pressure is 1…
Pressure-Driven Symmetry-Preserving Phase Transitions in Co(IO3)2
2021
[EN] High-pressure synchrotron X-ray diffraction studies of cobalt iodate, Co(IO3)(2), reveal a counterintuitive pressure-induced expansion along certain crystallographic directions. High-pressure Raman and infrared spectroscopy, combined with density-functional theory calculations, reveal that with increasing pressure, it becomes energetically favorable for certain I-O bonds to increase in length over the full range of pressure studied up to 28 GPa. This phenomenon is driven by the high-pressure behavior of iodate ion lone electron pairs. Two pressure-induced isosymmetric monoclinic-monoclinic phase transitions are observed at around 3.0 and 9.0 GPa, which are characterized by increasing o…
Structural and vibrational properties of CdAl2S4 under high pressure: Experimental and theoretical approach
2014
The behavior of defect chalcopyrite CdAl2S4 at high pressures and ambient temperature has been investigated in a joint experimental and theoretical study. High-pressure X-ray diffraction and Raman scattering measurements were complemented with theoretical ab initio calculations. The equation of state and pressure dependences of the structural parameters of CdAl2S4 were determined and compared to those of other AB(2)X(4) ordered-vacancy compounds. The pressure dependence of the Raman-active mode frequencies is reported, as well as the theoretical phonon dispersion curves and phonon density of states at 1 atm. Our measurements suggest that defect chalcopyrite CdAl2S4 undergoes a phase transit…
Thickness and temperature dependent structure of Cd arachidate Langmuir-Blodgett films
1992
Abstract The structure of monolayers of Cd arachidate on water and on solid support, and the thickness dependent changes when building up a multilayer via the LB technique are studied by means of grazing incidence diffraction of X-ray. In monolayers the perpendicularly oriented amphiphilic molecules are arranged in a hexagonal lattice, whereas for thicker layers (even for three layers) they crystallize in an orthorhombic unit cell with a reduced molecular are ( A = 18.2 A 2 ) compared to that of the monolayer ( A = 19.7 A 2 ). In-plane diffraction measurements with wave vector transfer perpendicular to the surface (rod scans) could prove for multilayers a maximum tilt angle of 2°. The data …
First-Order Isostructural Phase Transition Induced by High Pressure in Fe(IO3)3
2020
The high-pressure (HP) behavior of Fe(IO3)3 was studied up to 35 GPa using powder X-ray diffraction, infrared micro-spectroscopy, and ab initio density-functional theory calculations. Fe(IO3)3 show...