Search results for "Surfaces"
showing 10 items of 2837 documents
Backward transition radiation in the extreme ultraviolet region as a tool for the transverse beam profile diagnostic
2014
The present article summarizes the results of two experiments which were performed to study the radiation properties of backward transition radiation (BTR) in the extreme ultraviolet (EUV) region. This wavelength region is of particular interest for transverse beam profile imaging, because the spatial resolution is improved as a result of the reduced contribution in the imaging process of the fundamental diffraction limit. In addition, the influence of coherent effects in the transition radiation emission process, which have been observed in the visible region, might be mitigated. The first experiment, dedicated to the investigation of the BTR angular characteristics, indicates that the rad…
IMAGING OF DICHROISM IN PHOTOEMISSION ELECTRON MICROSCOPY AT NONMAGNETIC MATERIALS USING CIRCULARLY POLARIZED SOFT X-RAYS
2002
A new approach for investigations of circular dichroism in the angular distribution of photoelectrons (CDAD) is presented. The image contrast using a photoemission line of a certain material is combined with imaging of the angular distribution pattern using a photoemission electron microscope (PEEM). CDAD can be used to investigate pure scattering information by means of the same instrument in microscopically selected regions on a surface. The experiment combines angle-resolved XPS imaging with the indirect mapping of the local environment of atoms by means of CDAD holography. In a conventional photoelectron diffraction or photoelectron holography experiment, it is necessary to move the sa…
Surface plasmon assisted thermal coupling of multiple photon energies
2006
A novel optical effect can be observed in a thin gold foil due to the excitation of surface plasmons which permits a form of all-optical modulation at low pulse rates. Modulated excitation of surface plasmons by infrared photons is shown to couple to several beams at visible-photon energies. The coupling is manifested by the observation of the visible photons being pulsed by the action of the infrared pulses, and by the far field diffraction of the visible beams into concentric rings. When each visible beam also excites surface plasmons, then a quadratic dependence of the visible photon power upon the infrared incident power is measured. The decay of surface plasmons is implicated as the pr…
Liquid Structure of Trihexyltetradecylphosphonium Chloride at Ambient Temperature: An X-ray Scattering and Simulation Study
2009
We report on an experimental and simulation study done on a representative room temperature ionic liquid, namely tetradecyltrihexylphosphonium chloride, at ambient conditions. The study was conducted using small and wide angle X-ray scattering and molecular dynamics simulations. Both approaches converge in indicating that this material is characterized by the existence of strong P-Cl interactions (with characteristic distances between 3.5 and 5.0 Å) and by the occurrence of nanoscale segregation, despite the symmetric nature of the cation and similarly to other room temperature ionic liquids. A good agreement is found between the structure factor and pair correlation functions obtained from…
Vapor growth of Hg1−xCdxI2 on glass using CdTe buffer
2001
Abstract Vapor phase epitaxy (VPE) of Hg1−xCdxI2 layers on glass substrates covered by a CdTe buffer layer has been studied. The buffer layers of 2–4 μm thickness were formed by VPE using polycrystalline CdTe and Cd metal sources. The Hg1−xCdxI2 layers were grown using a (Hg1−yCdy)1−z(I2)z polycrystalline source, with a composition in the range of y=0.1–0.5 and z=0.5–0.8. Scanning electron microscopy and X-ray diffraction studies have shown that the composition and structure of Hg1−xCdxI2 layers depend strongly on the VPE conditions. Varying the growth time and source composition, it has been possible to obtain Hg1−xCdxI2 layers with the composition x in the range from approximately 0 (HgI2…
Use of positron annihilation measurements to detect the defect beneath worn surface of stainless steel 1.4301 (EN) under dry sliding condition
2012
Abstract Positron measurements were performed for detection of the subsurface zone in the stainless steel 1.4301 (EN) exposed to dry sliding. They revealed the defect profile induced by dry sliding which is extended inward the worn surface from 85 μm to 400 μm depending on the applied load during the tribo-test. This result was obtained using the positron techniques, while the microhardness profile exhibited shorter range of the microhardness depth profile, i.e., from 70 μm to 150 μm. However, at the depth of about 5 μm from the worn surface the sudden increase in the microhardness was observed. The complementary measurements of X-ray diffraction and SEM micrographs of the worn surface were…
An X-ray scattering study of lipid monolayers at the air-water interface and on solid supports
1988
Abstract Monolayers of the lipid arachidic acid (C20) and of the phospholid dimyristolyphosphatidic acid (PMDA) have been studied by X-ray reflection and diffraction technique, using a purpose-built Langmuir trough installed at the sample stage of our high-resolution X-ray diffractometer at the DORIS synchroton X-ray source in Hamburg. For comparison we also report data for monolayers of C20 on a solid support using a 10 kW rotating anode X-ray source. By the X-ray reflection method, the density profile across the interface is probe, while in-plane diffraction measurements gauge the two-dimensional crystalline properties of the monolayers. Flourescence microscopy experiments of DMPA monolay…
Ferroelastic Fingerprints in Methylammonium Lead Iodide Perovskite
2016
Methylammonium lead iodide (MAPbI3) perovskite shows an outstanding performance in photovoltaic devices. However, certain material properties, especially the possible ferroic behavior, remain unclear. We observed distinct nanoscale periodic domains in the piezoresponse of MAPbI3(Cl) grains. The structure and the orientation of these striped domains indicate ferroelasticity as their origin. By correlating vertical and lateral piezoresponse force microscopy experiments performed at different sample orientations with X-ray diffraction, the preferred domain orientation is suggested to be the a1–a2-phase. The observation of these ferroelastic fingerprints appears to strongly depend on the film t…
Coupled Semiconductor Systems for Photocatalysis. Preparation and Characterization of Polycrystalline Mixed WO3/WS2 Powders
1999
Mixed WO3/WS2 powders were prepared by oxidation of WS2. The physical properties of the samples were characterized by X-ray diffraction, diffuse reflectance spectroscopy, and scanning electron microscopy; they were strongly dependent upon the time and temperature of oxidation. The chemical state and the elemental distribution of the sample surface were investigated by X-ray photoelectron spectroscopy. The photocatalytic results have showed that the aqueous suspensions of the mixed WO3/WS2 systems have significantly higher activities than pure WS2 and WO3 for the photodegradation of phenol. The enhanced performance can be related to the presence of heterojunctions WO3/WS2 on the single parti…
Thermal effects during adsorption of n-butane on a slilicalite-1 membrane. A non-equilibrium molecular dynamics study
2007
Abstract Non-equilibrium molecular dynamic (NEMD) simulations have been used to study the kinetics of adsorption of n-butane molecules in a silicalite membrane. We have chosen this simple well-known process to demonstrate that the process is characterized by two stages, both non-isothermal. In the first stage the large chemical driving force leads to a rapid uptake of n-butane in all the membrane and a simultaneous increase in the membrane temperature, explained by the large enthalpy of adsorption, Δ H = − 61.6 kJ / mol butane. A diffusion coefficient for transport across the external surface layer is calculated from the relaxation time; a value of 3.4 × 10 −9 m 2 / s is found. During the a…