Search results for "Toe"
showing 10 items of 3824 documents
High frequency microwave signal generation using dual-wavelength emission of cascaded DFB fiber lasers with wavelength spacing tunability
2010
[EN] A dual wavelength fiber laser source based on two cascaded phase-shifted fiber Bragg gratings is presented The gratings are written in an erbium-doped fiber each configuring the cavity of a distributed feedback fiber laser The spacing between lasing modes is controlled dynamically by the use of piezoelectric actuators A continuous tuning range of 5-724 pm of the wavelength difference which is equivalent to a photodetected 072-92 GHz range is obtained Efficient generation from the L to the W microwave and millimeter bands has been achieved by heterodyne photodetection of the dual-wavelength optical signal (C) 2010 Elsevier BV All rights reserved
Frequency tunable polarization and intermodal modulation instability in high birefringence holey fiber
2009
International audience; We present an experimental analysis of polarization and intermodal noise-seeded parametric amplification, in which dispersion is phase matched by group velocity mismatch between either polarization or spatial modes in birefringent holey fiber with elliptical core composed of a triple defect. By injecting quasi-CW intense linearly polarized pump pulses either parallel or at 45 degrees with respect to the fiber polarization axes, we observed the simultaneous generation of polarization or intermodal modulation instability sidebands. Furthermore, by shifting the pump wavelength from 532 to 625 nm, we observed a shift of polarization sidebands from 3 to 8 THz, whereas int…
Profiling of traps in SiO2/Al2O3 gate stack by the charge pumping technique
2006
In this paper, we present our results on the distribution and generation of traps in a SiO 2 /A1 2 O 3 transistor. The investigation has been carried out by using charge pumping measurements, both variable voltage and frequency techniques, and constant voltage stress. By increasing the amplitude of the gate pulse we observe an increase of the charge recombined per cycle closely related to the contribution of shallow traps near the SiO 2 /Al 2 O 3 interface. By reducing the pulse frequency we measure an increase in the charge pumping current due to traps located deeper in the Al 2 O 3 . By combining charge pumping and constant voltage stress measurements, we found that the traps are mostly g…
Interface Effects in Ferroelectric Thin Films
1998
Dielectric, ferroelectric and piezoelectric characteristics in sol-gel derived and pulsed laser deposited (PLD) lead zirconate titanate (PZT), La modified lead titanate (PLT) and zirconate titanate (PLZT) ferroelectric thin films are investigated focusing on maintenance of thin film ferroelectric (FE) properties in a variety of thin film-electrodesubstrate interfaces. Interferometric studies of piezoelectric response of the heterostructures were performed with respect to a DC electrical bias and AC measurement frequency. The asymmetry of piezoelectric coefficient (d33) hysteresis, diminished values of d33, frequency-displacement and spot size — deformation behaviour in the ferroelectric het…
CMOS Photodiode Design for Gamma Camera Application
2008
We designed new photodiodes sensors including current mirror amplifiers. These photodiodes have been fabricated using a CMOS 0.6 micrometers process from Austria Micro System (AMS). The photodiode areas are respectively 1 mm × 1 mm and 0.4 mm × 0.4 mm with fill factor 98% and total chip area is 2 square millimetres. The sensor pixels show a logarithmic response in illumination and are capable of detecting very low blue light (less than 0.5 lux) . These results allow to use our sensor in new gamma camera solid-state concept.
Plano-concave microlenses with epsilon-near-zero surface-relief coatings for efficient shaping of nonparaxial optical beams
2017
Abstract Epsilon-near-zero (ENZ) materials, including artificial metamaterials, have been advanced to mold laser beams and antenna-mediated radiated waves. Here we propose an efficient method to control Ohmic losses inherent to natural ENZ materials by the assembly of subwavelength structures in a nonperiodic matrix constituting an ENZ metacoating. Implemented over plano-concave transparent substrates whose radius can be of only a few wavelengths, ENZ surface-relief elements demonstrate to adequately shape a plane wave into highly localized fields. Furthermore, our proposal provides an energy efficiency even higher than an ideally-lossless all-ENZ plano-concave lens. Our procedure is satisf…
Influence of ZnO/graphene nanolaminate periodicity on their structural and mechanical properties
2018
International audience; Structural, electronic and mechanical properties of ZnO/Graphene (ZnO/G) nanolaminates fabricated by low temperature atomic layer deposition (ALD) and chemical vapor deposition (CVD) were investigated. We performed scanning and transmission electron microscopy (SEM/TEM), X-ray diffraction (XRD), electron energy loss spectroscopy (EELS), Raman spectroscopy, X-Ray photoelectron spectroscopy (XPS) and nanoindentation to characterize the ZnO/G nanolaminates. The main structural and mechanical parameters of ZnO/G nanolaminates were calculated. The obtained results were analyzed and interpreted taking into account mechanical interaction and charge effects occurring at the …
Phase mixture in MOCVD and reactive sputtering TiOxNy thin films revealed and quantified by XPS factorial analysis.
2006
Abstract Titanium oxynitride thin films have been deposited by low-pressure metalorganic chemical vapour deposition and reactive sputtering. The growth temperature for chemical vapour-deposited films and water vapour partial pressure for sputter-deposited films have been used to modulate the chemical composition. Both series have been analysed using X-ray photoelectron spectroscopy (XPS) in order to describe the structure of the materials using a factorial analysis approach. Titanium and metalloid concentrations have also been determined and compared to an elemental analysis performed using Rutherford backscattering spectroscopy and nuclear reaction analysis. The two deposition methods led …
Investigation of Acetone Vapour Sensing Properties of a Ternary Composite of Doped Polyaniline, Reduced Graphene Oxide and Chitosan Using Surface Pla…
2020
This work reports the use of a ternary composite that integrates p-Toluene sulfonic acid doped polyaniline (PANI), chitosan, and reduced graphene oxide (RGO) as the active sensing layer of a surface plasmon resonance (SPR) sensor. The SPR sensor is intended for application in the non-invasive monitoring and screening of diabetes through the detection of low concentrations of acetone vapour of less than or equal to 5 ppm, which falls within the range of breath acetone concentration in diabetic patients. The ternary composite film was spin-coated on a 50-nm-thick gold layer at 6000 rpm for 30 s. The structure, morphology and chemical composition of the ternary composite samples were character…
Surface characterization of functional poly(diacetylene) and poly(butadiene) mono- and multilayers
1982
The surface properties of Langmuir-Blodgett mono- and multilayers of a variety of amphiphilic poly(diacetylene)s and poly(butadiene)s were investigated by contact angle, streaming potentialζ, ellipsometry, and X-ray photoelectron spectroscopic (XPS) measurements. Captive air and octane angles varied between approximately 60° and 105° for hydrophobicx-layers and 31° to 46° for hydrophilic surfaces depending on the particular head group, whereas advancing angles determined via the vertical plate method are considerably higher. Negative streaming potentials were obtained for all surfaces. Positively charged monolayers yielded less negativeζ- potential values (−28 mV) than negatively charged (−…