Search results for "Transmittance"
showing 9 items of 89 documents
Interface engineering for improved light transmittance through photonic crystal flat lenses
2010
In this paper, we present photonic crystal flat lenses with interfaces engineered to improve the light transmittance thanks to a broad angles impedance matching. The interface engineering consists in the realization of antireflection gratings on the edges of the lenses which are designed to reduce the propagative waves reflectivity over a wide range of incident angles. The fabricated structures were measured in optical near-field and a four times enhancement of the light transmission efficiency is reported.
Measurement of cloud point temperature in polymer solutions.
2013
A temperature-controlled turbidity measurement apparatus for the characterization of polymer solutions has been instrumented and set up. The main features are the coupled temperature-light transmittance measurement and the accurate temperature control, achieved by means of peltier cells. The apparatus allows to measure cloud point temperatures by adopting different cooling protocols: low rate for quasi-equilibrium measurements and high rate for detect kinetic effects. A ternary polymeric solution was adopted as case study system showing that cooling rate affects the measured cloud point temperature.
Effect of Mn Doping on the Optical Properties of Chalcogenide Compounds ZnS and ZnTe
2020
In this paper, the influence of the addition of Mn on the optical properties of the binary compounds ZnS and ZnTe deposited by a close-spaced vacuum sublimation method onto nonoriented glass at different substrate temperatures was considered. The spectral dependences of the transmittance T (λ), reflectance R (λ) and the absorption α (λ), as well as the bandgap for each material (Eg) were measured and calculated.
Contributo alla conoscenza delle proprietà termofisiche delle murature storiche palermitane
2014
This paper presents the preliminary findings of in situ measurements of thermal transmittance taken in a monumental complex in Palermo. The objective of energy efficiency, one of the main aspects of sustainable construction, is now relevant also for historic architecture. The research aims at analysing the energy performance of the stone walls of the complex, characterized by various thickness, age and construction features. Measurements are taken in accordance with the international standard ISO 9869:1994. The U-values so obtained are compared with tabular data from the Italian standard UNI/TS 11300-1:2008 and with values calculated following the UNI EN ISO 6946:2008. Nine preliminary meas…
Identification des systèmes d’acquisition d’image adaptés au phénotypage des plantes et validation des algorithmes associés
2016
L’imagerie multispectrale est très utilisé en agronomie comme, par exemple, pour l'estimation des pigments foliaires. Mais les systèmes multispectraux traditionnels, comme multi-CCD/CMOS ou filtre rotatif, ont des limites propres. LCTF (Liquid-Crystal Tunable Filter) a certains avantages : plus de bandes qui sont configurés par programme en respectant une résolution spectrale plus précise (bande passante est plus étroite), et le temps de réponse court.Dans ce projet, nous développons une méthode de calibration et comparons les performances deLCTF et filtres classiques, en termes de transmittance et précision spectrale.Enfin nous avons développé une solution pour comparer les précisions spec…
Evolution of microstructure and related optical properties of ZnO grown by atomic layer deposition.
2013
A study of transmittance and photoluminescence spectra on the growth of oxygen-rich ultra-thin ZnO films prepared by atomic layer deposition is reported. The structural transition from an amorphous to a polycrystalline state is observed upon increasing the thickness. The unusual behavior of the energy gap with thickness reflected by optical properties is attributed to the improvement of the crystalline structure resulting from a decreasing concentration of point defects at the growth of grains. The spectra of UV and visible photoluminescence emissions correspond to transitions near the band-edge and defect-related transitions. Additional emissions were observed from band-tail states near th…
Optical and structural properties of Al 2 O 3 /ZnO nanolaminates deposited by ALD method
2014
International audience; We report on the investigation of optical and structural properties of Al2O3/ZnO nanolaminates. The nanolaminates were deposited on Si and glass substrates by Atomic layer deposition method. Structural properties of nanolaminates were studied by SEM, GIXRD, and AFM. Optical characterization was performed by transmittance and photoluminescence spectroscopy. Complex analysis of monolayer properties was done by ellipsometry. Optical constants for Al2O3 and ZnO monolayer were calculated.
Optical Monitoring of Microplastics Filtrated from Wastewater Sludge and Suspended in Ethanol.
2021
The abundance of microplastics (MPs) in the atmosphere, on land, and especially in water bodies is well acknowledged. In this study, we establish an optical method based on three different techniques, namely, specular reflection to probe the medium, transmission spectroscopy measurements for the detection and identification, and a speckle pattern for monitoring the sedimentation of MPs filtrated from wastewater sludge and suspended in ethanol. We used first Raman measurements to estimate the presence and types of different MPs in wastewater sludge samples. We also used microscopy to identify the shapes of the main MPs. This allowed us to create a teaching set of samples to be characterized …
The thermal performances of historic masonry: In-situ measurements of thermal conductance on calcarenite stone walls in Palermo
2018
Abstract Rich literature explores materials and construction techniques of historic buildings, but limited information is available about the thermal and hygrometric features of their envelope. Nevertheless, accurate hygrothermal data are essential for identifying effective energy upgrade measures, which must be compatible with the conservation of the architectural heritage. In order to fill this gap, it is necessary to refer to local contexts, where the variety of historic buildings is limited and their material and construction features are comparable. This paper focuses on historic masonry walls and discusses the results of twenty in-situ measurements of thermal conductance, performed al…