Search results for "Vapo"
showing 10 items of 1217 documents
Sintering of copper nanopowders under hydrogen: an in situ X-ray diffraction analysis.
2003
Abstract The reduction by hydrogen gas of the cuprite layer on copper nanocrystals and the subsequent sintering of the nano-particles were studied using in-situ X-ray diffraction and dilatometry. Spherical nanocrystals produced by evaporation and condensation have an average size of 35 nm, exhibiting a large surface curvature. Each nanoparticle is coated with a 3.5 nm layer of Cu 2 O, which is rough and disordered, as revealed by high-resolution electron microscopy. Reduction by hydrogen of this curved cuprite layer occurs at 363 K, which is ≈65 K lower than is observed on a layer supported by micrometer-sized or bulk copper with a flat surface. The reduction process and its effect on the s…
Template electrosynthesis of aligned Cu2O nanowires
2008
Abstract Large arrays of aligned copper oxide nanowires were produced by electrodeposition, using anodic alumina membranes as template. We have studied the effect of two fundamental parameters involved in fabrication process: potential perturbation and bath composition. Performing electrodeposition from a copper acetate/sodium acetate bath (pH 6.5), we found that chemical composition of nanowires varied in dependence on the shape of the applied potential perturbation: pure copper oxide nanowires were produced by pulsed potential, whilst continuous electrodeposition resulted in a co-deposition of Cu and Cu 2 O. In a copper lactate bath, buffered at pH 10, the shape of perturbation did not in…
Trace detection of plutonium by three-step photoionization with a laser system pumped by a copper vapor laser
1985
Laser photoionization has been used to detect trace amounts of plutonium. A high sensitivity and selectivity has been achieved by applying three-step excitation and ionization of the plutonium atoms with high pulse-repetition rates and additional mass determination by time-of-flight measurements. A laser system was developed which consists of a copper vapor laser pumping three dye lasers simultaneously. Samples containing between 1010 and 1012 atoms of239Pu on Re filaments were measured yielding strong resonance signals with maximum ion count rates of several kHz at a vanishingly low background. A detection efficiency of 10−7 was determined allowing the detection of about 108 plutonium atom…
EVASPA (EVapotranspiration Assessment from SPAce) tool: an overview
2013
International audience; Evapotranspiration (ET) is a fundamental variable of the hydrological cycle and its estimation is required for irrigation management, water resources planning and environmental studies. Remote sensing provides spatially distributed cost-effective information for ET maps production at regional scale. We have developed EVASPA too for mapping ET from remote sensing data at spatial and temporal scales relevant to hydrological or agronomica studies. EVASPA includes several algorithms for estimating evapotranspiration and various equations for estimating the required input information (net radiation, ground heat flux, evaporative fraction…), which provides a way to assess …
A simple model to estimate the daily value of the regional maximum evapotranspiration from satellite temperature and albedo images
1987
Abstract We have tried an adaptation of the radiation model proposed by FAO, applicable in any area, for the estimation of the regional maximum evapotranspiration, ET, from temperature and albedo images obtained from a satellite. This model is based on the relationships ETm = k cETo ETo = A + BR g + CR g Ta max where k c is the crop coefficient, ETo is the maximum evapotranspiration of the reference crop (green grass), Rg is the global radiation obtained from satellite albedo images, T a max is the maximum temperature of the air obtained from the near-midday satellite temperature and A, B and C are the empirical coefficients characteristic of each zone calculated for different intervals of …
Determination of Evapotranspiration and Crop Coefficient of Cactus Pear (Opuntia ficus-indica Mill.) with an Energy Balance Technique
2013
A micrometeorological approach based on surface renewal technique was adopted to estimate evapotranspiration fluxes and crop coefficient data from an irrigated cactus pear (Opuntia ficus-indica Mill.) orchard under Mediterranean climatic conditions. High-frequency temperature readings were taken above the canopy top in order to get surface renewal sensible heat flux values (HSR). These values were compared against eddy covariance sensible heat fluxes (HEC) for calibration. Latent heat flux (or evapotranspiration, ET) was obtained as the residual of the energy balance equation using HSR. In field measurements of biophysical crop features, physiological characteristic and soil hydraulic compo…
Detecting crop irrigation status in orchard canopies with airborne and ASTER thermal imagery
2007
This work provides a description of the research conducted to assess if ASTER satellite data enable the detection of the water status in orchard tree crops. Summer and winter TERRA-ASTER images were acquired over a study area of Seville in southern Spain over a 6-year period. 1076 olive orchards were monitored in this area, obtaining field location, area, tree density, and irrigation status information. Surface temperature images were obtained using the TES method and 0.5 m resolution panchromatic ortho-rectified imagery collected over the entire area to obtain vegetation cover. A comparison study of the temperature difference between orchards under different irrigation schemes is presented…
Study of the MOCVD growth of ZnO on GaAs substrates: Influence of the molar ratio of the precursors on structural and morphological properties
2007
Abstract ZnO thin films were grown by metal-organic chemical vapour deposition (MOCVD) on GaAs(100) and GaAs(111)A substrates. The growth experiments were performed at temperatures ranging from 290 to 500 ∘C and atmospheric pressure. Diethylzinc (DEZn) and tertiary butanol (tBuOH) were used as Zn and O precursors, respectively. The crystallinity of the grown films was studied by X-Ray Diffraction (XRD) and the thickness and morphology were investigated by Scanning Electron Microscopy (SEM). The influence of substrate orientation and molar ratio of the precursors on the crystalline orientation and morphology of the ZnO grown films was analysed.
The onset of the Messinian salinity crisis: Insights from Cyprus sections.
2009
International audience
A liquid alkoxide precursor for the atomic layer deposition of aluminum oxide films
2020
For large-scale atomic layer deposition (ALD) of alumina, the most commonly used alkyl precursor trimethylaluminum poses safety issues due to its pyrophoric nature. In this work, the authors have investigated a liquid alkoxide, aluminum tri-sec-butoxide (ATSB), as a precursor for ALD deposition of alumina. ATSB is thermally stable and the liquid nature facilitates handling in a bubbler and potentially enables liquid injection toward upscaling. Both thermal and plasma enhanced ALD processes are investigated in a vacuum type reactor by using water, oxygen plasma, and water plasma as coreactants. All processes achieved ALD deposition at a growth rate of 1-1.4 angstrom/cycle for substrate tempe…