Search results for "XPS"
showing 10 items of 66 documents
Fabrication and characterization of barium silicate ultrathin films as an alternative gate oxide
2008
Down-scaling of elementary CMOS elements requires the replacement of SiO2 as a gate oxide. By the identification of the formation conditions of barium silicate in direct contact of a silicon substrate, this study revealed a potential candidate. First of all, a reaction between Ba and SiO2 leading to the formation of barium silicate as been evidenced by in-situ XPS and SR-PES analyses. Then, barium silicate films have been elaborated by oxygen and barium co-deposition at 580 °C. Thermal treatments under vacuum showed that barium silicate was thermally stable up to 900 °C. TEM and SIMS ex-situ analyses revealed a sharp interface with the substrate. Finally, an experimental setup dedicated to …
Identification of the contaminants present on the surface of lactose for pharmaceutical use and analysis of the impact of their presence on the inter…
2018
The discovery of the problem will go through training techniques at the nanoscale characterization and chemical analysis, the discovery of the industrial problem in society Armor Proteins, the validation of a pharmaceutical lactose. With the aim to increase our knowledge on powders for food or pharmaceutical use, we propose to study the effect of manufacturing processes, shaping, granulation on the reactivity of powders. The first part is devoted to the effect of purity on interactions-Lactose Lactose and Lactose-API measured / quantified by near-field techniques (AFM, SMM, MSAFM) under ambient atmosphere and under stressful conditions storage. Deriving a second portion of the preceding par…
Partial cation-substitution in the sulphide kesterite: Absorber and heterojunction engineering
2019
International audience; The kesterite-based solar cells still suffer from a low conversion efficiency due to the large defect of the open circuit voltage Voc. This defect is mainly due to several problems related to the absorber material and the device interfaces. It has been reported that the partial cation substitution in the kesterite structure, can improve many properties of the absorbent layer and the device, i.e. improve the grain size, minimise the anti-site defects and disorder in the Cu-Zn plane, ameliorate the charge separation at the buffer/absorber interface. In this work, thin films of suphide kesterite are made by substituting copper (Cu) with silver (Ag) and zinc with mangane…
New technologies getting informations on repartition, orientation and identification of biomolecules on SPR chip
2008
We present herein an original approach, consisting to lead in parallel a global analysis (SPR) and nanoscale characterizations (AFM, mass spectrometry, TOF-SIMS) of bio-molecules on the biochip surface. The questions we want to answer concern especially the organization, orientation and identification of immobilized and captured biomolecules. In order to characterize the sensing layer in terms of molecular structure and orientation, we engaged a SPR-TOF SIMS first set of experiments (collaboration: Pr Aoyagi, Japan). Our results demonstrated that analysis of orientation of the immobilized cytochrome b5 is possible (ref2&3) and help to optimize and develop our sensing layer. We also recently…
Changes in surface stress, morphology and chemical composition of silica and silicon nitride surfaces during the etching by gaseous HF acid
2007
International audience; HF acid attack of SiO2 and Si3N4 substrates is analyzed to improve the sensitivity of a sensor based on inicrocantilever. Ex situ analysis of the etching using XPS, SIMS and AFM show significant changes in the anisotropy and the rate of the etching of the oxides on SiO2 and Si3N4 surface. Those differences influence the kinetic evolution of the plastic bending deflection of the cantilever coated with SiO2 and Si3N4 layer, respectively. The linear dependence between the HF concentration and the Si3N4 cantilever bending corresponds to a deep attack of the layer whereas the nonlinear behavior observed for SiO2 layer can be explained by a combination of deep and lateral …
Uptake of actinides by calcium silicate hydrate (C-S-H) phases
2018
Abstract The sorption of actinides (Th, U – Am) was studied in dependence of the solid-to-liquid (S/L) ratio (0.5–20.0 g/L) and the calcium-to-silicon (C:S) ratio. The C:S ratio was varied between 1.80 and 0.70 to simulate the changing composition of the C-S-H phases during cement degradation from high to low C:S ratios. The decrease of the calcium content in the C-S-H phases by time is accompanied by a decrease in pH in the corresponding suspensions from 12.6 to 10.2. X-ray photoelectron spectroscopy (XPS) of the C-S-H phases showed an increasing depletion of Ca on the surface with increasing C:S ratio in comparison to the composition of the solid phase as a whole. The sorption experiments…
Structural characterization of U(VI) surface complexes on kaolinite in the presence of humic acid using EXAFS spectroscopy.
2007
To determine the influence of humic acid (HA), pH, and presence of atmospheric CO2 on the sorption of U(VI) onto kaolinite, the structure of the surface complexes was studied by U L III-edge extended X-ray absorption fine structure (EXAFS) spectroscopy. The best fits to the experimental EXAFS data were obtained by including two uranium coordination shells with two axial (O ax) and five equatorial (O eq) oxygen atoms at 1.77+/-0.02 and 2.34+/-0.02 A, respectively, and two coordination shells with one Al/Si atom each at 3.1 and 3.3 A. As in the case of the binary system U(VI)-kaolinite, uranium forms inner-sphere surface complexes by edge sharing with aluminum octahedra and/or silicon tetrahe…
Tablas y gráficos con R y R Studio
2021
¿Por qué este libro? es que no hay libros dedicados a ilustrar y mostrar cómo hacer tablas de contingencia y gráficos a partir de esas tablas usando R; hablando más específicamente usando expss y highcharter. Por otro lado, a partir de mi experiencia y de muchos años dedicado al mundo de la investigación y la docencia (mi hobbie personal) encontré el tiempo y la motivación para escribirlo. Quería crear un recurso que fuera diferente del resto de textos con el mismo contenido aproximado y porque creo que para que las ideas se difundan y adopten ampliamente, deben percibirse de manera amigable y fácil de entender, lo que tiene por qué estar reñido con una baja calidad científica y teórica. Si…
Structural Characterization of Surfactant-Coated Bimetallic Cobalt/Nickel Nanoclusters by XPS, EXAFS, WAXS, and SAXS
2011
Cobalt nickel bimetallic nanoparticles were synthesized by changing the sequence of the chemical reduction of Co(II) and Ni(II) ions confined in the core of bis(2-ethylhexyl)phosphate (2)., and Ni(DEHP)(2). The reduction was carried out by mixing, sequentially or contemporaneously, fixed amounts of n-heptane solution of Co(DEHP)2 and Ni(DEHP)2 micelles with a solution of sodium borohydride in ethanol at a fixed (reductant)/(total metal) molar ratio. This procedure involves the rapid formation of surfactant-coated nanoparticles, indicated as Co/Ni (Co after Ni), Ni/Co (Ni after Co), and Co + Ni (simultaneous), followed by their slow separation as nanostructures embedded in a sodium bis(2-eth…
Study of the role of sulfur functionalities in humic acids for uranium(VI) complexation
2009
Humic substances influence the speciation and migration behavior of toxic and radiotoxic metal ions, such as actinides, in the environment. Depending on their origin, humic substances contain different amounts of sulfur ranging from 0.1 to 3.6% and 0.5 to 1.43% in soil and aquatic humic substances, respectively [1]. Reduced, intermediately oxidized and highly oxidized sulfur functionalities occur in humic substances [1]. Although sulfur functionalities occur in small concentrations, they can play an important role in the complexation of selected metal ions. Knowledge about the impact of sulfur functionalities on the metal ion complexation by humic substances and their significance compared …