Search results for "absorption."

Determination of cyanide by a flow injection analysis-atomic absorption spectrometric method

1999

A new flow injection analysis (FIA) procedure is proposed for the indirect atomic absorption spectrometric determination of cyanide. The FIA manifold is based on the insertion of the sample into a distilled water carrier, then the sample flows through a solid-phase reactor filled with silver iodide entrapped in polymeric resin beads. The calibration graph is linear over the range 0.2-6.0 mg l-1 of cyanide (correlation coefficient 0.9974), the detection limit is 0.1 mg l-1, the sample throughput is 193 h-1 and the RSD is 0.8%. The method is simple, quick and more selective than other published FIA procedures. The reproducibility obtained by using different solid-phase reactors and solutions …

Flow injection spectrophotometric determination of lead using 1,5-diphenylthiocarbazone in aqueous micellar

2009

A simple flow injection colorimetric procedure for determining lead was established. It is based on the reaction of lead in sulfuric acid with 1,5-diphenylthiocarbazone and sodium dodecyl sulfate, resulting in an intense red-blue complex with a suitable absorption at 500 nm. A standard or sample solution was injected into the sulfuric acid stream (flow rate of 2.0 ml min(-1)), which was then merged with sodium dodecyl sulfate stream (flow rate of 2.0 ml min(-1)) and 1,5-diphenylthiocarbazone stream (flow rate of 1.5 ml min(-1)). Optimum conditions for determining lead were investigated by univariate method. Under the optimum conditions, a linear calibration graph was obtained over the range…

Rapid on-line sample dissolution assisted by focused microwave radiation for silicate analysis employing flame atomic absorption spectrometry: iron d…

2004

An on-line automated flow injection system with microwave-assisted sample digestion was used to perform silicate rock dissolution in acid medium for iron determination. For this purpose, a continuous flow system was built up by using an automatic flow injection analysis (FIA) system coupled to a flame atomic absorption spectrometer (FAAS), including a focused microwave oven unit. Inside the microwave cavity was inserted a polytetrafluoroethylene (PTFE) reactor coil (300cm length and 0.8mm i.d.) where the dissolution takes place. Chemical and flow variables as well as iron determination parameters were studied. In the flow system, a slurry of the rock sample (50mg in 200ml of acid mixture HF…

Direct determination of calcium, magnesium, sodium and potassium in water by flow injection flame atomic spectroscopy, using a dilution chamber

1989

A simple procedure to carry out the direct analysis of calcium, magnesium, sodium and potassium in water by flow injection analysis (FIA) using flame atomic absorption spectroscopy (AAS) or flame photometry (FP) has been developed, using a well stirred dilution chamber to extend the calibration range, and both a double injector and the merging zone technique to add a lanthanum solution to samples and standards. The results obtained in the analysis of real samples agree with those found by a batch flame atomic procedure. The use of the dilution chamber makes it possible to carry out the calibration using the dilution profile of a single concentrate standard for each element, and an empirical…

Slurries Introduction in Flow Injection Atomic Absorption Spectroscopic Analysis of Sewage Sludges

1990

Abstract The direct introduction of slurries in flow Injection-flame atomic absorption spectroscopy has been studied using a single-channel manifold. The influence of flow Injection parameters on the sensitivity and accuracy of this procedure has been established. A method has been developed for the determination of copper, manganese, and lead In sewage sludge where batch digestion of the samples In a microwave oven is carried out before dilution. Both sensitivity and limit of detection of the flow Injection analysis procedure are adequate for the analysis of actual samples (the limit of detection was 0.06, 0.05, and 0.3 ppm for copper, manganese, and lead, respectively). The accuracy of th…

Use of The Eggshells in Removing Heavy Metals from Waste Water - The Process Kinetics and Efficiency

2019

Abstract Studies of the efficiency of Ni, Cu and Cd cations removal from water solutions were carried out, with the use of clay limestone, hen eggshells from eggs for consumption and hen eggshells after hatching, which main element is calcium carbonate. Hen eggshells are a waste product, which can be used as a substitute of clay limestone in removing heavy metals from wet flue gas desulphurisation installation. Mixed solutions of Ni, Cu and Cd were used in the research, with the composition similar to the waste water from wet flue gas desulphurisation installation: Ni (0.009-0.053 mmol/dm3), Cu (0.008-0.057 mmol/dm3) and Cd (0.003-0.008 mmol/dm3). The metals were determined by flame atomic …

Nanohybrid for Photodynamic Therapy and Fluorescence Imaging Tracking without Therapy

2018

Theranostic upconversion nanoparticles (UCNPs) are ideal candidates for personalized medicine. We present a smart, easy-to-prepare nanohybrid (NH) suitable for NIR-theragnosis and imaging tracking without triggering therapy simultaneously. The photophysical features of each component have been carefully selected in order to maximize the capabilities for theragnosis, in particular, the upconversion emission and the photosensitizer absorption. In addition, NH presents a fluorescent marker with one-photon absorption in the green and two-photon absorption cross-section at NIR wavelengths where the UCNP does not absorb, thus enabling innocuous tracking. Thus, the NH consists of NaYF4:Yb, Er, Tm …

Flux growth at 1230 °C of cubic Tb2O3 single crystals and characterization of their optical and magnetic properties

2015

International audience; In this work, we present the first crystal growth of cubic Tb2O3 single crystals by a controlled atmosphere flux method which uses a heavy metal free solvent working at less than half the melting temperature of this sesquioxide. Cubic millimeter-sized crystals extracted from as-grown boules are phase (powder XRD) and chemically (GDMS) pure and exhibit a Verdet constant in the visible and near-infrared spectral ranges, which is at least three times higher than that of a commercial Tb3Ga5O12 (TGG) crystal. The 1.36 mm thick crystals display a transmission coefficient higher than 77% over the 525 nm–1.38 μm spectral range. The absorption spectrum, magnetic susceptibilit…

Bioavailability and metabolism.

2002

Lemon Juice, Sesame Paste, and Autoclaving Influence Iron Bioavailability of Hummus: Assessment by an In Vitro Digestion/Caco-2 Cell Model

2020

Hummus, an iron-containing plant-based dish mainly made from chickpea pur&eacute