Search results for "analytical"
showing 10 items of 9586 documents
An improved cathode for alkaline fuel cells
2010
Abstract The use of nickel foam as an electrode substrate in alkaline fuel cells (AFCs) has been investigated for bipolar cells incorporating an electrically conducting gas diffusion layer (GDL). Improved performance, compared to a previous design, was obtained by adding an extra active layer (AL) composed of manganese (IV) oxide (MnO2) deposited onto carbon black. This new cathode design performed significantly better (130 mA cm−2 at 0.8 V and 25 °C) than the previous design (35 mA cm−2 under the same condition), especially at higher potential. It has been shown that the GDL is a key component of the gas diffusion electrode for both performance and durability, especially with liquid electr…
Cytotoxic Activity and Composition of Petroleum Ether Extract from Magydaris tomentosa (Desf.) W. D. J. Koch (Apiaceae)
2015
The petroleum ether extract of Magydaris tomentosa flowers (Desf.) W. D. J. Koch has been analyzed by GC-MS. It is mainly constituted by furanocoumarins such as xanthotoxin, xanthotoxol, isopimpinellin, and bergaptene. Other coumarins such as 7-methoxy-8-(2-formyl-2-methylpropyl) coumarin and osthole also occurred. The antiproliferative activity of Magydaris tomentosa flower extract has been evaluated in vitro on murine monocye/macrophages (J774A.1), human melanoma (A375) and human breast cancer (MCF-7) tumor cell lines, showing a major activity against the latter.
Liquid gas techniques for GC trace analysis
1990
Liquid gases (LG), i.e. low boiling compounds with vapor pressures below 5 bar at room temperature, are introduced as solvents for trace analyses. A system for preparin, diluting and handling LG solutions safely and conveniently in 5 to 500 μl amounts was developed as well as a syringe for direct injection of μl-LG samples into capillary GC. Even technical grade LG are of high purity. GC/FID of LG solutions (starting at −60°C) allows the separation of volatile traces from the solvent peak: e.g., dichloromethane can be measured in the picogram range.
Monolayers of dipalmitoylphosphatidylcholine at the oil-water interface
1995
Abstract Monolayers of dipalmitoylphosphatidylcholine at the interfaces waterbicylohexyl, waterdodecane and waterhexadecane were studied by fluorescence microscopy and thermodynamic measurements. The experiments show that the oil also partitions in the liquid condensed (LC) monolayer phase with concentration depending on the type of oil and the lateral pressure. In contrast to monolayers of dipalmitoylphosphatidylethanolamine the larger molecular area per head group enables oil partitioning in the LC phase even if there is a mismatch between the aliphatic tails of liquid and alkane.
Group contributions to the infinite dilution partial molar volumes of alkanes, alcohols, and glycols in polar organic solvents
1997
Densities of binary mixtures of polar organic solvents with alcohols were measured at 25‡C. The solvents studied were N,N-dimethylformamide, dimethylsulfoxide, and formamide while alcohols were butanol, pentanol, hexanol, and 1,4-butanediol. Density measurements of hydrocarbons (from pentane to dodecane and some heptane isomers) + N,N-dimethylformamide were also performed. From these data the apparent molar volumes of alcohols and hydrocarbons as functions of concentration were calculated. The standard partial molar volumes were obtained by extrapolation to infinite dilution and are discussed in terms of group contributions.
Characterization and quantitation of mixtures of alkyl ether sulfates and carboxylic acids by capillary electrophoresis with indirect photometric det…
2003
The separation, characterization, and determination of mixtures of alkyl ether sulfates (AES) and fatty acids (C10-C16) in background electrolytes (BGEs) containing acetonitrile (ACN)-water mixtures is addressed. Due to inhibition of the ionization of the carboxylate groups, the migration time and the resolution between the fatty acids decreased when the water content of the BGE was reduced, but efficiency and resolution between the AES oligomers improved. The migration times increased and resolution improved by substituting 5% ACN by an equivalent amount of dioxane. A complete separation of the two surfactant classes, up to the AES oligomers with 8 ethylene oxide units (EOs) with respect t…
Nucleophilic benzoylation using a mandelic acid dioxolanone as a synthetic equivalent of the benzoyl carbanion. Oxidative decarboxylation of α-hydrox…
2004
The synthesis of alkyl aryl ketones using a mandelic acid dioxolanone as a synthetic equivalent (Umpolung) of the benzoyl carbanion is reported. The methodology involves alkylation of the mandelic acid dioxolanone, hydrolysis of the dioxolanone moiety in the alkylated products and oxidative decarboxylation of the resulting alpha-hydroxyacids. The last step is carried out in a catalytic aerobic way using a Co (III) complex in the presence of pivalaldehyde under very mild conditions.
Analytical methods for the characterization and determination of nonionic surfactants in cosmetics and environmental matrices
2013
Nonionic synthetic surfactants, constituted of an assortment of classes, are common ingredients of industrial, household and body-care products. Alone or in combination with anionic surfactants, they perform a variety of functions including cleaning action, emulsification, skin conditioning, appearance and consistency modification, solubilization and dispersing agents. By far fatty alcohol ethoxylates (AEs) and alkylphenol ethoxylates (APEs) are more extensively used than any other nonionic surfactant class; however, works appearing in the literature making reference to the analysis of other nonionic surfactant classes have also been collected in this review. The production volume worldwide…
A Refractive Index Sensor Based on the Resonant Coupling to Cladding Modes in a Fiber Loop
2013
We report an easy-to-build, compact, and low-cost optical fiber refractive index sensor. It consists of a single fiber loop whose transmission spectra exhibit a series of notches produced by the resonant coupling between the fundamental mode and the cladding modes in a uniformly bent fiber. The wavelength of the notches, distributed in a wavelength span from 1,400 to 1,700 nm, can be tuned by adjusting the diameter of the fiber loop and are sensitive to refractive index changes of the external medium. Sensitivities of 170 and 800 nm per refractive index unit for water solutions and for the refractive index interval 1.40-1.442, respectively, are demonstrated. We estimate a long range resolut…
Sensitivity optimization with cladding-etched long period fiber gratings at the dispersion turning point
2016
This work presents a refractive index sensor based on a long period fiber grating (LPFG) made in a reduced cladding fiber whose low order cladding modes have the turning point at large wavelengths. The combination of these parameters results in an improved sensitivity of 8734 nm/refractive index unit (RIU) for the LP0,3 mode in the 1400-1650 wavelength range. This value is similar to that obtained with thin-film coated LPFGs, which permits to avoid the coating deposition step. The numerical simulations are in agreement with the experimental results. This work was supported in part by the Spanish Ministry of Education and Science-FEDER TEC2013-43679-R. J.L. Cruz also acknowledges financial s…