Search results for "atomic"
showing 10 items of 27529 documents
Investigation of Coating Impact on OFDR Optical Remote Fiber-Based Sensors Performances for Their Integration in High Temperature and Radiation Envir…
2016
The response of optical frequency-domain reflectometry-based temperature sensors is here investigated in harsh environments (high temperature, high radiation dose) focusing the attention on the impact of the fiber coating on the sensor performances in such conditions. Our results demonstrate that the various coating types evolve differently under thermal treatment and/or radiations, resulting in a small (<5%) change in the temperature coefficient of the sensor. The identified procedure, consisting of a prethermal treatment of the fiber at its maximum coating operating temperature, is here verified up to 150 °C for higherature acrylate and up to 300 °C for polyamide coating. This method allo…
Measurement of nonlinear and chromatic dispersion parameters of optical fibers using modulation instability
2006
International audience; We present a simple method for the measurement of Kerr, second- and third-order dispersion coefficients in optical fibers using power and dispersion dependences of modulation instability near the zero-dispersion wavelength. We also complete the analysis by the accurate determination of the zero-dispersion wavelength of the fiber using the phase-matched four wave mixing process which occurs near this specific wavelength.
Efficient interrogation method of forward Brillouin scattering in optical fibers using a narrow bandwidth long-period grating
2020
A new technique, to the best of our knowledge, for the characterization of the effective refractive index modulation in optical fibers due to transverse acoustic mode resonances excited by electrostriction is reported. The resonances excited by an optical pulse are probed by a narrow bandwidth long-period grating (LPG) inscribed in the fiber, which is interrogated by a continuous wave (CW) beam. The LPG used in this experiment has a narrow bandwidth and high sensitivity to small mode index perturbations, allowing the measurement of index variations from below 10 − 9 to 10 − 6 . Radial and torsional-radial acoustic modes were characterized up to 1.1 GHz. The linewidth of resonances was found…
Measurement of the soliton number in guiding media through continuum generation.
2020
No general approach is available yet to measure directly the ratio between chromatic dispersion and the nonlinear coefficient, and hence the soliton number for a given optical pulse, in an arbitrary guiding medium. Here we solve this problem using continuum generation. We experimentally demonstrate our method in polarization-maintaining and single-mode fibers with positive and negative chromatic dispersion. Our technique also offers new opportunities to determine the chromatic dispersion of guiding media over a broad spectral range while pumping at a fixed wavelength. (C) 2020 Optical Society of America
Simultaneous polarization attraction and Raman amplification of a light beam in optical fibers
2012
International audience; In this paper, we demonstrate that it is possible to combine both Raman amplification and polarization attraction of a signal wave in a single optical fiber by means of a counterpropagating scheme. Experiments were performed near 1550 nm in a continuous wave regime and by means of a 10 Gbit ∕ s return-to-zero signal injected in a 20 kmlong low polarization mode dispersion optical fiber. Complete repolarization and 6.7 dB amplification of the signal wave was achieved by injecting a 850 mW, 1480 nm counterpropagating polarized pump wave.
Photoluminescence time decay of surface oxygen deficient centers in un‐doped and Ge‐doped silica
2005
We report a study of the emission decay from the singlet excited state of two fold coordinated Si and Ge centers stabilized on the surface of silica and Ge-doped silica. The PL lifetimes are of the order of nanoseconds and increase on decreasing the temperature. The results suggest that, for the surface centers, the phonon assisted intersystem-crossing process linking the excited states affects the decay rates, is effective down to low temperatures and is distributed because of the inhomogeneity of the defects. (© 2005 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim)
Even harmonic pulse train generation by cross-polarization-modulation seeded instability in optical fibers
2012
International audience; We show that, by properly adjusting the relative state of polarization of the pump and of a weak modulation, with a frequency such that at least one of its even harmonics falls within the band of modulation instability, one obtains a fully modulated wave at the second or higher even harmonic of the initial modulation. An application of this principle to the generation of a 80-GHz optical pulse train with high extinction ratio from a 40-GHz weakly modulated pump is experimentally demonstrated using a nonzero dispersion shifted fiber in the telecom C band.
Silver Sulfide Nanoclusters and the Superatom Model
2015
The superatom model of electron-shell closings has been widely used to explain the stability of noble-metal nanoclusters of few nanometers, including thiolate-protected Au and Ag nanoclusters. The presence of core sulfur atoms in silver sulfide (Ag–S) nanoclusters renders them a class of clusters with distinctive properties as compared to typical noble-metal clusters. Here, it is natural to ask whether the superatom model is still applicable for the Ag–S nanoclusters with mixed metal and nonmetal core atoms. To address this question, we applied density functional simulations to analyze a series of Ag–S nanoclusters: Ag14S(SPh)12(PPh3)8, Ag14(SC6H3F2)12(PPh3)8, Ag70S16(SPh)34(PhCO2)4(triphos…
Structural and optical characterization of ZnS ultrathin films prepared by low-temperature ALD from diethylzinc and 1.5-pentanedithiol after various …
2019
The structural and optical evolution of the ZnS thin films prepared by atomic layer deposition (ALD) from the diethylzinc (DEZ) and 1,5-pentanedithiol (PDT) as zinc and sulfur precursors was studied. A deposited ZnS layer (of about 60 nm) is amorphous, with a significant S excess. After annealing, the stoichiometry improved for annealing temperatures &ge
Mechanical and optical properties of as-grown and thermally annealed titanium dioxide from titanium tetrachloride and water by atomic layer deposition
2021
Funding Information: This work was carried out within the MECHALD project funded by Business Finland (Tekes) and is linked to the Finnish Centers of Excellence in Atomic Layer Deposition (ref. 251220) and Nuclear and Accelerator Based Physics (refs. 213503 and 251353) of the Academy of Finland. Funding Information: This work was carried out within the MECHALD project funded by Business Finland (Tekes) and is linked to the Finnish Centers of Excellence in Atomic Layer Deposition (ref. 251220 ) and Nuclear and Accelerator Based Physics (refs. 213503 and 251353 ) of the Academy of Finland. Publisher Copyright: © 2021 The use of thin-films made by atomic layer deposition (ALD) is increasing in …