Search results for "electron microscopy"
showing 10 items of 706 documents
Interfacial disorder of graphene grown at high temperatures on 4H-SiC(000-1)
2016
This paper presents an investigation of the morphological and structural properties of graphene (Gr) grown on SiC(000-1) by thermal treatments at high temperatures (from 1850 to 1950 °C) in Ar at atmospheric pressure. Atomic force microscopy and micro-Raman spectroscopy showed that the grown Gr films are laterally inhomogeneous in the number of layers, and that regions with different stacking-type (coupled or decoupled Gr films) can coexist in the same sample. Scanning transmission electron microscopy and electron energy loss spectroscopy shoed that a nm-thick C-Si-O amorphous layer is present at the interface between Gr and SiC. Basing on these structural results, the mechanisms of Gr grow…
Influence of the high energy ball milling on structure and reactivity of the Ni+Al powder mixture
2013
Abstract Investigation of the micro- and atomic structures for the planetary ball-milled Ni + Al mixtures has revealed existence of intermediate nano-crystalline and amorphous phases, which are not detectable by XRD analysis, but can be observed by means of HRTEM. Annealing of the milled mixtures at moderate temperature, 205–280 °C, transforms the nano-phases into crystal state and makes them XRD-detectable. These nano-scale structures may serve as nucleus for the intermetallic phases produced via reaction between Ni and Al and, therefore, decrease the activation energy of this reaction and diminish the temperature of the reaction initiation. Apparently, the active nano-phases are formed du…
THz nanocrystal acoustic vibrations from ZrO2 3D supercrystals
2013
International audience; We report sharp low-frequency Raman spectral features of supercrystals synthesized via the "benzyl alcohol route" and consisting of either yttrium-stabilized or pure zirconia (ZrO2) nanocrystals. In situ formed benzoate species control the nanocrystal growth and act as organic glue leading to the assembly of the nanocrystals in highly ordered 3D supercrystals. We attribute some Raman peaks to THz acoustic vibrations of individual nanocrystals which are only weakly coupled due to the strong acoustic mismatch between the capping ligands and the nanocrystals. Peak positions are consistent with nanocrystal sizes estimated from transmission electron microscopy and X-ray p…
Mesosynthesis of ZnO-SiO(2) porous nanocomposites with low-defect ZnO nanometric domains.
2011
Silica-based ZnO-MCM-41 mesoporous nanocomposites with high Zn content (5≤Si/Zn≤50) have been synthesized by a one-pot surfactant-assisted procedure from aqueous solution using a cationic surfactant (CTMABr = cetyltrimethylammonium bromide) as structure-directing agent, and starting from molecular atrane complexes as inorganic hydrolytic precursors. This preparative technique allows optimization of the dispersion of the ZnO nanodomains in the silica walls. The mesoporous nature of the final materials is confirmed by x-ray diffraction (XRD), transmission electron microscopy (TEM) and N(2) adsorption-desorption isotherms. The ZnO-MCM-41 materials show unimodal pore size distributions without …
Enhanced thermoelectric properties of lightly Nb doped SrTiO3 thin films
2021
Novel thermoelectric materials developed for operation at room temperature must have similar or better performance along with being as ecofriendly as those commercially used, e.g., BiTe, in terms of their toxicity and cost. In this work, we present an in-depth study of the thermoelectric properties of epitaxial Nb-doped strontium titanate (SrTiNbO) thin films as a function of (i) doping concentration, (ii) film thickness and (iii) substrate type. The excellent crystal quality was confirmed by high resolution transmission electron microscopy and X-ray diffraction analysis. The thermoelectric properties were measured by the three-omega method (thermal conductivity) and van der Pauw method (el…
The structural properties of GaN insertions in GaN/AlN nanocolumn heterostructures.
2009
The strain state of 1 and 2.5 nm thick GaN insertions in GaN/AlN nanocolumn heterostructures has been studied by means of a combination of high resolution transmission electron microscopy, Raman spectroscopy and theoretical modeling. It is found that 2.5 nm thick GaN insertions are partially relaxed, which has been attributed to the presence of dislocations in the external AlN capping layer, in close relationship with the morphology of GaN insertions and with the AlN capping mechanism. The observed plastic relaxation in AlN is consistent with the small critical thickness expected for GaN/AlN radial heterostructures.
Design of a reactor operating in supercritical water conditions using CFD simulations. Examples of synthesized nanomaterials
2011
International audience; Direct information about fluids under supercritical water conditions is unfeasible due to the engineering restrictions at high pressure and high temperature. Numerical investigations based on computational fluid dynamics (CFD) calculations are widely used in order to get extensive information on the fluid behavior, particularly to help the design of a new reactor. This paper presents the numerical investigations performed on an original supercritical water device, especially in the level of the reactor. CFD calculations allow to design and optimize the present reactor described in this study. Currently, this process produces some nanometric oxide powders in continuou…
Mechanical properties of sol–gel derived SiO2 nanotubes
2014
The mechanical properties of thick-walled SiO2 nanotubes (NTs) prepared by a sol–gel method while using Ag nanowires (NWs) as templates were measured by using different methods. In situ scanning electron microscopy (SEM) cantilever beam bending tests were carried out by using a nanomanipulator equipped with a force sensor in order to investigate plasticity and flexural response of NTs. Nanoindentation and three point bending tests of NTs were performed by atomic force microscopy (AFM) under ambient conditions. Half-suspended and three-point bending tests were processed in the framework of linear elasticity theory. Finite element method simulations were used to extract Young’s modulus values…
MCM-41-CdS nanoparticle composite material: Preparation and characterization
2010
The preparation and characterization of a hierarchical material constituted by a mesoporous silica MCM-41 whose mesochannels contain CdS nanoparticles capped with both bis(2-ethylhexyl) amine and bis(2-ethylhexyl) sodium sulfosuccinate is reported. MCM-41 powder was synthesized by using the LCT methodology. CdS nanoparticles were obtained within the inversed micelle core of a water/ AOT/n-heptane microemulsion. Nanoparticles growth was followed by means of UV–Vis spectroscopy and was inhibited by BEA addition. The CdS-capped nanoparticles were separated by centrifugation, washed with water and ethanol and finally dispersed in n-heptane. The insertion of CdS nanoparticles into MCM-41 mesocha…
Soluble IF-ReS2 nanoparticles by surface functionalization with terpyridine ligands.
2010
A major drawback in the application of layered chalcogenide nanoparticles/tubes is their inertness to chemical and biological modification and functionalization. Their potential use in composite materials might be greatly enhanced by improving the chalcogenide/matrix interface bonding. A novel modification strategy for layered chalcogenide nanoparticles based on the chalcophilic affinity of metals and the chelating terpyridine is reported. The terpyridine anchor group can be conjugated to fluorescent tags or hydrophilic/hydrophobic groups that confer solubility in various solvents to the otherwise insoluble chalcogenide nanoparticles. The functionalized particles are characterized using TEM…