Search results for "electronics"

Atomic scale surface modification of TiO2 3D nano-arrays: plasma enhanced atomic layer deposition of NiO for photocatalysis

2021

Here we report the development of a new scalable and transferable plasma assisted atomic layer deposition (PEALD) process for the production of uniform, conformal and pinhole free NiO with sub-nanometre control on a commercial ALD reactor. In this work we use the readily available nickel precursor nickelocene in conjunction with O2 plasma as a co-reagent (100 W) over a temperature range of 75–325 °C. An optimised growth per cycle of 0.036 nm was obtained at 250 °C with uniform thickness and coverage on scale-up to and including an 6 inch Si wafer (with a 200 nm thermal SiO2 top layer). The bulk characteristics of the NiO thin films were comprehensively interrogated by PXRD, Raman spectrosco…

Octave-spanning ultraflat supercontinuum with soft-glass photonic crystal fibers

2009

We theoretically identify some photonic-crystal-fiber structures, made up of soft glass, that generate ultrawide (over an octave) and very smooth supercontinuum spectra when illuminated with femtosecond pulsed light. The design of the fiber geometry in order to reach a nearly ultraflattened normal dispersion behavior is crucial to accomplish the above goal. Our numerical simulations reveal that these supercontinuum sources show high stability and no significant changes are detected even for fairly large variations of the incident pulse. Ministerio de Ciencia e Innovación (TEC2008-05490) and Generalitat Valenciana (GV/2007/043).

Corrigendum to “Far-infrared and THz spectroscopy of 0.4PMN–0.3PSN–0.3PZN relaxor ferroelectric ceramics” [J. Eur. Ceram. Soc. 27 (2007) 3713–3717]

2007

Aluminum oxide nucleation in the early stages of atomic layer deposition on epitaxial graphene

2020

In this work, the nucleation and growth mechanism of aluminum oxide (Al2O3) in the early stages of the direct atomic layer deposition (ALD) on monolayer epitaxial graphene (EG) on silicon carbide (4H-SiC) has been investigated by atomic force microscopy (AFM) and Raman spectroscopy. Contrary to what is typically observed for other types of graphene, a large and uniform density of nucleation sites was observed in the case of EG and ascribed to the presence of the buffer layer at EG/SiC interface. The deposition process was characterized by Al2O3 island growth in the very early stages, followed by the formation of a continuous Al2O3 film (2.4 nm thick) after only 40 ALD cycles due to the isla…

Influence of corona poling procedures on linear and non-linear optical properties of polymer materials containing indandione derivatives as a cromoph…

2008

SHG efficiency of the poled guest - host polymer system is proportional to the concentration and orientation degree of NLO active molecules (chromophores). Corona poling realized at elevated temperatures could cause concentration decrease of NLO- active molecules due to centrosymmetric crystallization. Our studies showed that number density of crystallites is depending on orientation procedure. To obtain the best orientation procedure for guest - host systems containing four different chromophores based on dimethylaminobenzylidene 1, 3 - indandione we have compared optical images and SHG efficiency of corona poled films. According to our observations external poling electric field applied f…

Enhancement of photoconversion efficiency in dye-sensitized solar cells exploiting pulsed laser deposited niobium pentoxide blocking layers

2015

Abstract Among all the photovoltaic technologies developed so far, dye-sensitized solar cells are considered as a promising alternative to the expensive and environmentally unfriendly crystalline silicon-based solar cells. One of the possible strategies employed to increase their photovoltaic efficiency is to reduce the charge recombination at the cell conductive substrate through the use of a compact blocking layer. In this paper, we report on the fabrication and characterization of dye-sensitized solar cells employing niobium pentoxide (Nb 2 O 5 ) thin film blocking layer deposited through the pulsed laser deposition technique on conductive substrates. The careful selection of the optimal…

Influence of hole transport material ionization energy on the performance of perovskite solar cells

2019

Halide perovskites have shown excellent photophysical properties for solar cell applications which led to a rapid increase of the device efficiency. Understanding the charge carrier dynamics within the active perovskite absorber and at its interfaces will be key to further progress in their development. Here we present a series of fully evaporated devices employing hole transport materials with different ionization energies. The open circuit voltage of the devices, along with their ideality factors, confirm that the former is mainly determined by the bulk and surface recombination in the perovskite, rather than by the energetic offset between the valence band of the perovskite and the highe…

Integrated plasmonic nanotweezers for nanoparticle manipulation.

2016

We numerically demonstrate that short gold nanoparticle chains coupled to traditional SOI waveguides allow conceiving surface plasmon-based nanotweezers. This configuration provides for jumpless control of the trapping position of a nano-object as a function of the excitation wavelength, allowing for linear repositioning. This novel feature can be captivating for the conception of compact integrated optomechanical nanoactuators.

Dispersion managed self-similar parabolic pulses

2008

International audience; We describe the propagation of a parabolic self-similar pulse in an anomalous dispersive nonlinear fibre. Given the capacity of a linearly chirped parabolic pulse to retain its typical shape over a short propagation distance, we introduce the concept of dispersion managed self-similar pulses and outline potential benefits in terms of spectral broadening enhancement.

Continuous Broadband MWP True-Time Delay with PbS-PMMA and -SU8 waveguides

2016

[EN] A new microwave true-time delay (TTD) photonic unit based on the dispersion of PbS colloidal quantum dots (QDs) in a Polymethyl methacrylate (PMMA) and the SU8 photoresist is presented. With this aim, the PbS-PMMA and PbS-SU8 nanocomposites are integrated on a silicon platform in the form of a planar and ridge waveguides, respectively. When PbS QDs on those structures are pumped below their band-gap, a phase shift and a temporal delay in an optically conveyed (at 1550 nm) microwave signal is performed. The results of these devices show potential benefits over current TTD technologies, since the proposed photonic waveguide structures allows real-time adjustment of the temporal delay by …