Search results for "element"
showing 10 items of 13601 documents
Development of a test station for accurate in situ I-V curve measurements of photovoltaic modules in Southern Norway
2011
The development of an outdoor test station for accurate in situ I-V curve measurements of photovoltaic (PV) modules is described. The modules are installed in an open-rack configuration at the University of Agder in Southern Norway. Seven new and three aged PV modules of different type and make are being tested, including mono-and multicrystalline silicon from differing manufacturing routes, triple-junction amorphous silicon, and CIS. Data acquisition is controlled with a multichannel electronic load system and LabVIEW software, recording high-resolution I-V curves at one-minute intervals. Between I-V curve sweeps, each module is operated at the maximum power point. Characteristic electrica…
Cooling of Hot Electrons in Amorphous Silicon
1997
ABSTRACTMeasurements of the cooling rate of hot carriers in amorphous silicon are made with a two-pump, one-probe technique. The experiment is simulated with a rate-equation model describing the energy transfer between a population of hot carriers and the lattice. An energy transfer rate proportional to the temperature difference is found to be consistent with the experimental data while an energy transfer independent of the temperature difference is not. This contrasts with the situation in crystalline silicon. The measured cooling rates are sufficient to explain the difficulty in observing avalanche effects in amorphous silicon.
ASE narrow‐band noise pulsing in erbium‐doped fiber amplifier and its effect on self‐phase modulation
2019
In this paper, we report a study of the features of polarized and unpolarized narrow-band amplified spontaneous emission (ASE) in a low-doped erbium fiber at 976-nm pumping. We demonstrate that ASE noise can be treated as a train of Gaussian-like pulses with random magnitudes, widths, and inter-pulse intervals. ASE noise can also provide a statistical analysis of these three parameters. We also present the data that reveal ASE noise’s role in optical spectrum broadening through self-phase modulation of light propagating in a communication fiber. In particular, the data show that the ASE noise derivative defines the broadening’s spectral shape.
Er-doped photonic crystal fibre characterization method based on McCumber theory
2009
Characterization and modeling of Er-doped fibres [1] allowed in the past years fruitful developments of amplifiers and lasers. Since in a conventional fibre monomodal propagation of light is achieved in a very short length (once energy of other modes has been radiated) the cutback technique has been successfully used to determine absorption cross sections at the pump and gain band wavelengths. Emission cross sections have been usually determined instead from the measurement of gain or amplified spontaneous emission (ASE) spectrum together with the use of theoretical models. In a photonic crystal fibre (PCF) the limited size of the air-holes lattice originates energy radiation from the highe…
Emerging contributions of formyl peptide receptors to neurodegenerative diseases.
2021
Abstract Inflammation is a central element of many neurodegenerative diseases. Formyl peptide receptors (FPRs) can trigger several receptor-dependent signal transduction pathways that play a key role in neuroinflammation and neurodegeneration. They are chemotactic receptors that help to regulate pro- and anti-inflammatory responses in most mammals. FPRs are primarily expressed in the immune and nervous systems where they interact with a complex pattern of pathogen-derived and host-endogenous molecules. Mounting evidence points towards a contribution of FPRs – via neuropathological ligands such as Amyloid beta, and neuroprotective ligands such as Humanin, Lipoxin A4, and Annexin A1 – to mult…
Negative staining across holes: application to fibril and tubular structures.
2007
The negative staining technique, when used with holey carbon support films, presents superior imaging conditions than is the case when samples are adsorbed to continuous carbon films. A demonstration of this negative staining approach is presented, using ammonium molybdate in combination with trehalose, applied to several fibrillar and tubular samples. Fibrils formed from the amyloid-beta peptide and the protease inhibitor pepstain A spread very well unsupported across holes and the different polymorphic fibril forms can be readily assessed. However, tubular forms of amyloid-beta have a tendency to be flattened, due to surface tension forces prior to and during specimen drying. Sub-fibril a…
Structural analysis of copper(I) interaction with amyloid β peptide
2019
Abstract The N-terminal fragment of Aβ (β = beta) peptide is able to bind essential transition metal ions like, copper, zinc and iron. Metal binding usually occurs via the imidazole nitrogens of the three His residues which play a key role in the coordination chemistry. Among all the investigated systems, the interaction between copper and Amyloid β assume a biological relevance because of the interplay between the two copper oxidation states, Cu(II) and Cu(I), and their involvement in redox reactions. Both copper ions share the ability to bind Amyloid β. A huge number of investigations have demonstrated that Cu(II) anchors to the N-terminal amino and His6, His13/14 imidazole groups, while …
La Cupola del Teatro Massimo: Il contemporaneo nel 1876
2011
High-pressure flow-injection assembly. Indirect determination of glycine by atomic absorption spectrometry.
1991
A procedure for the determination of glycine is described. The method is based on the reaction of the analyte with finely powdered, solid copper(II) carbonate in a continuous-flow assembly. The optimum experimental conditions of pH, temperature, sample volume, flow-rate, column length and internal diameter, and the linear range of calibration, were studied. Interference from foreign substances that accompany this amino acid in pharmaceutical formulations was studied, and the method was applied to the determination of glycine.
Determination of antimony, arsenic, bismuth and copper by inductively coupled plasma atomic emission spectrometry in the electrorefining of copper
1996
Inductively coupled plasma atomic emissionspectrometry (ICP-AES) has been applied as a rapid and routine method for the analysis of process electrolytes in the electrorefining of copper. Antimony, arsenic, bismuth and copper have been selected as major electrolyte constituents. For these elements profound statistical studies of spectral and interelement effects have been carried out. For As, Bi and Sb two analyte wavelengths have been selected, and for Cu one relatively insensitive analyte line has been chosen due to the high Cu concentration in samples. Best analytical lines were: As at 193.759 nm, Bi at 306.772 nm, Sb at 206.833 nm and Cu at 216.953 nm. Multiple linear regression proved t…