Search results for "engineering.material"
showing 10 items of 2352 documents
Modified Halloysite Nanotubes: Nanoarchitectures for Enhancing the Capture of Oils from Vapor and Liquid Phases
2013
We prepared hybrid halloysite nanotubes (HNT/sodium alkanoates) in which the inner cavity of the nanoclay was selectively modified. Physicochemical studies evidenced the interactions between HNT and sodium alkanoates, ruled out clay exfoliation, quantified the amount of the loaded substance, and showed an increase of the total net negative charge, allowing us to obtain rather stable aqueous nanoclay dispersions. These dispersions were exploited as inorganic micelles to capture hydrocarbon and aromatic oils in the vapor and liquid states and were revealed to be nonfoaming but very efficient in encapsulating oils. Here, we have fabricated biocompatibile and low-cost inorganic micelles that ca…
Effect of carboxymethyl cellulose concentration on rheological behavior of milk and aqueous systems. A creep and recovery study
2009
Carboxymethyl cellulose (CMC) is an anionic polysaccharide used mainly as stabilizer and thickener agent. The purpose of this study was to investigate the effect of CMC concentration on viscoelasticity of dairy and aqueous model systems through the analysis of creep and recovery tests. The viscoelastic properties of different concentrations of CMC (0.75, 1.00, 1.25, and 1.50% w/w) in two milk systems (skimmed milk and whole milk) were compared with those of the same concentration of biopolymer in aqueous solution. Creep curves were fitted to a six parameter mechanical model (Burger + Kelvin-Voigt), whereas an empirical equation was used for recovery. The creep and recovery properties of sam…
Fast and continuous synthesis of nanostructured iron spinel in supercritical water: influence of cations and citrates
2014
International audience; Spinel iron oxide nanoparticles were obtained under supercritical water conditions in a continuous and fast (less than 10s) way by modifying the initial stoichiometric Fe II /Fe III molar ratio from (1/2) to (3/0), without base solution, and using citrates directly with iron precursors. This result opens the way of an economical and environmentally benign approach to synthesize superparamagnetic iron oxide nanoparticles (SPIONs) in important yields.
Cell Specific Targeting of Multifunctional γ-Fe2O3 Nanoparticles Through Surface Binding of dsDNA
2007
AbstractThe immobilization of polyinosinic-polycytidylic acid [poly(IC)] on ã-Fe2O3 maghemite nanoparticles via the phosphor-amidate route using a multifunctional polymer is reported. The dsRNA coupled nanoparticles were used to visualize the Toll-like (TLR3) receptors at the cell surface. The presence of TLR3 was demonstrated independently in the Caki-1 cell line by RT-PCR and immunostaining techniques
Enzyme-Mediated Deposition of a TiO2Coating onto Biofunctionalized WS2 Chalcogenide Nanotubes
2009
A chemically specific and facile method for the biofunctionalization of WS2 nanotubes (NT-WS2) is reported. The covalent modification strategy is based on the affinity of the nitrilotriacetic acid (NTA) side chain, which serves as a ligand for the surface binding to NT-WS2 and simultaneously as an anchor group for the binding of His-tagged proteins to the polymer backbone. The polymer functionalized WS2 nanotubes can be solubilized either in water or organic solvents; they are stable for at least one week. The probes were characterized by FT-IR and UV-vis spectroscopy. The immobilization of silicatein, a hydrolytic protein encountered in marine sponges, was visualized by scanning force micr…
Halloysite Nanotubes for Cleaning, Consolidation and Protection
2017
Herein, we report our recent research concerning the development of halloysite based protocols for cleaning, consolidation and protection purposes. Surface modification of halloysite cavity by anionic surfactants was explored to fabricate inorganic micelles able to solubilize hydrophobic contaminants. Hybrid dispersions based on halloysite and ecocompatible polymers were tested as consolidants for paper and waterlogged archaeological woods. Encapsulation of deacidifying and flame retardant agents within the halloysite lumen was conducted with aim to obtain nanofiller with a long-term protection ability. The results prove the suitability and versatility of halloysite nanotubes, which are per…
Solution-processed bi-layer polythiophene–fullerene organic solar cells
2013
An ionic polymer based on a polythiophene backbone with appended imidazolium moieties was successfully implemented as a donor material in fully solution-processed efficient bi-layer solar cells prepared by the low impact meniscus coating technique. High fill factors and device reproducibility were obtained, even for ultrathin polymer layers, indicating excellent film formation properties and good compatibility with solution processing techniques. The possibility of smooth counter ion exchange, allowing solubility modification and efficiency tuning, enables exploration of new functionalities and other device architectures.
Biologizing titanium alloy implant material with morphogenetically active polyphosphate
2015
As a further step towards a new generation of bone implant materials, we developed a procedure for biological functionalization of titanium alloy surfaces with inorganic calcium polyphosphate (Ca-polyP). This polymer has been demonstrated to exhibit morphogenetic activity. The coating of titanium oxidized Ti-6Al-4V scaffolds with biologically active amorphous Ca-polyP microparticles is formed by Ca2+ ion bridges to the silane coupling agent APTMS. This surface is durable and stable as an almost homogeneous Ca-polyP layer onto the metal. The homogenously coated Ca-polyP titanium scaffold was found to be biologically active and supported the growth and functional activity of bone cell-related…
QENS investigation of filled rubbers
2002
The polymer segmental dynamics is investigated in a series of silica-filled rubbers. The presence of inert fillers in polymers greatly affects the mechanical and physical performance of the final materials. For example, silica has been proposed as a reinforcing agent of elastomers in tire production. Results from quasielastic neutron scattering and Dynamic Mechanical Thermal Analysis (DMTA) measurements are presented on styrene–ran-butadiene rubber filled with silica. A clear indication is obtained of the existence of a bimodal dynamics, which can be rationalized in terms of the relaxation of bulk rubber and the much slower relaxation of the rubber adsorbed on the filler surface.
Fabrication of a Silica Coating on Magnetic γ-Fe2O3 Nanoparticles by an Immobilized Enzyme
2008
Silicatein, a hydrolytic protein encountered in marine sponges, was immobilized on maghemite (γ-Fe2O3) nanoparticles that were surface functionalized with a reactive mulfunctional polymer. This polymer carries an anchor group based on dopamine which is capable of binding to the γ-Fe2O3 surface and a reactive functional group which allows binding of various biomolecules onto inorganic nanoparticles. This functional nitrilotriacetic acid (NTA) group allows immobilization of His-tagged silicatein on the surface of the γ-Fe2O3 nanoparticles. The surface-bound protein retains its native hydrolytic activity to catalyze formation of silica through copolymerization of alkoxysilanes Si(OR)4. Functio…