Search results for "extracellular polymeric substance"
showing 10 items of 34 documents
Dewaterability of CAS and MBR Sludge: Effect of Biological Stability and EPS Composition
2018
The dewaterability of sludge from two conventional activated sludge (CAS) and three membrane bioreactor (MBR)-based wastewater treatment plants is investigated prior to and after anaerobic digestion. The concentration and composition of extracellular polymeric substances (EPS) mostly affect the dewaterability of all raw sludge samples. Better sludge dewaterability is observed when the concentration of proteins, carbohydrates, uronic acids, and humic acids is below approximately 400, 250, 200, and 40 mg/L, respectively. In contrast, the specific resistance to filtration (SRF) increases in the sludge samples with a higher EPS concentration. The MBR results in a lower EPS production and a uron…
Effect of extended famine conditions on aerobic granular sludge stability in the treatment of brewery wastewater
2017
Results obtained from three aerobic granular sludge reactors treating brewery wastewater are presented. Reactors were operated for 60 d days in each of the two periods under different cycle duration: (Period I) short 6 h cycle, and (Period II) long 12 h cycle. Organic loading rates (OLR) varying from 0.7 kg COD m-3 d-1 to 4.1 kg COD m-3 d-1 were tested. During Period I, granules successfully developed in all reactors, however, results revealed that the feast and famine periods were not balanced and the granular structure deteriorated and became irregular. During Period II at decreased 12 h cycle time, granules were observed to develop again with superior structural stability compared to the…
Foaming in membrane bioreactors: Identification of the causes
2012
Membrane bioreactors (MBRs) represent by now a well established alternative for wastewater treatment. Their increasing development is undoubtedly related to the several advantages that such technology is able to guarantee. Nevertheless, this technology is not exempt from operational problems; among them the foaming still represents an "open challenge" of the MBR field, due to the high complexity of phenomenon. Unfortunately, very little work has been done on the foaming in MBRs and further studies are required. Actually, there is not a distinct difference between conventional activated system and MBR: the main difference is that the MBR plants can retain most Extracellular Polymeric Substan…
Pilot scale experiment with MBR operated in intermittent aeration condition: analysis of biological performance.
2014
The effect of intermittent aeration (IA) on a MBR system was investigated. The study was aimed at ana- lyzing different working conditions and the influence of different IA cycles on the biological performance of the MBR pilot plant, in terms of organic carbon and ammonium removal as well as extracellular poly- meric substances (EPSs) production. The membrane modules were placed in a separate compartment, continuously aerated. This configuration allowed to disconnect from the filtration stage the biological phenomena occurring into the IA bioreactor. The observed results highlighted good efficiencies, in terms of organic carbon and ammonium removal. It was noticed a significant soluble micr…
The role of EPS in the foaming and fouling for a MBR operated in intermittent aeration conditions
2016
Abstract This work investigates the causes of foaming and fouling in an Intermittent Aerated – Membrane BioReactor (IA-MBR) used for wastewater treatment. The experiment was divided into three periods with different aerated regimes expressed with different t aeration /t cycle ratio (Period I: 60 min/180 min, Period II: 80 min/180 min, Period III: 30 min/90 min). The advanced foaming tests used allow the study of the role of extracellular polymeric substances (EPSs) on foaming and fouling. In general, in the Periods I and II, good correlations between the EPSs and the Modified Scum Index without purification (MSI 0 ) and the Foam Power were observed. The results shown that the filamentous mi…
Insights on mechanisms of excess sludge minimization in an oxic-settling-anaerobic process under different operating conditions and plant configurati…
2022
In the present research, insights about the mechanisms of excess sludge minimization occurring in an oxic-settling-anaerobic (OSA) were provided. The investigation involved two systems operating in parallel. In particular, a conventional activated sludge (CAS) system as control and a system implementing the OSA process both having a pre-denitrification scheme were considered. Five periods (P1-P5) were studied, during which several operating conditions and configurations were tested. Specifically, the hydraulic retention time (HRT) in the anaerobic reactor of the OSA system (P1 8 h, P2-P3 12 h, P4 8 h, P5 12 h) and the return sludge from the anaerobic to the anoxic (scheme A) (P1-P2) or aero…
The role of EPS in fouling and foaming phenomena for a membrane bioreactor
2013
In contraposition to conventional activated sludge processes, the foaming phenomenon in membrane bioreactor (MBR) is still in its infancy. On the other hand, although several studies have been carried out for better understanding the fouling phenomenon in MBR there are still some gaps in the up-to-date knowledge. The extracellular polymeric substances (EPSs) may have a primary role in fouling and foaming phenomena which in turn can be crucial for MBRs. The aim of this study is to detect a possible relationship that EPSs may have with fouling and foaming in an MBR for wastewater treatment. Foaming phenomenon is monitored by performing specific foam-tests: Foam Power, Scum Index, Foam Rating …
Microbiological analysis and metagenomic profiling of the bacterial community of an anthropogenic soil modified from typic haploxererts
2022
This work aimed to characterize the microbial communities of an anthropogenic soil originating from application of pedotechniques to Vertisols in a Mediterranean environment. Bare soil profiles were sampled at three depths (0–10 cm, 10–30 cm, and 30–50 cm) and compared with the original soil not transformed at the same depths. The anthropogenic soils were characterized by a higher CaCO3 concentration (360–640 g/kg) than control soil (190–200 g/kg), while an opposite trend was registered for clay, where control soil showed a higher concentration (465 g/kg on average) than anthropogenic soil (355 g/kg on average). Organic carbon content was much higher in the unt…
Sequential batch membrane bio-reactor for wastewater treatment: The effect of increased salinity
2016
In this work, a sequential batch membrane bioreactor pilot plant is investigated to analyze the effect of a gradual increase in salinity on carbon and nutrient removal, membrane fouling and biomass kinetic parameters. The salinity was increased by 2 g NaCl L-1 per week up to 10 g NaCl L-1. The total COD removal efficiency was quite high (93%) throughout the experiment. A gradual biomass acclimation to the salinity level was observed during the experiment, highlighting the good recovery capabilities of the system. Nitrification was also influenced by the increase in salinity, with a slight decrease in nitrification efficiency (the lowest value was obtained at 10 g NaCl L-1 due to lower nitri…
Treatment of Oily Wastewater with Membrane Bioreactor Systems
2017
The aim of the present work was to investigate the behavior of a membrane bioreactor (MBR) system for the treatment of oily wastewater. A bench scale MBR was fed with synthetic wastewater containing diesel fuel. Organic carbon, hydrocarbon and ammonium removal, kinetic constants, extracellular polymeric substances production, and membrane fouling rates were monitored. The MBR plant was operated for more than 200 days, and the results highlighted good carbon removal and nitrification, suggesting a sort of biomass adaptation to hydrocarbons. Membrane fouling analysis showed an increase in total resistance, likely due to hydrocarbons, which caused an irreversible fouling (pore blocking) mainly…