Search results for "extracellular polymeric substance"

showing 10 items of 34 documents

Performance of industrial scale hollow-fibre membranes in a submerged anaerobic MBR (HF-SAnMBR) system at mesophilic and psychrophilic conditions

2013

The aim of this work was to evaluate the effect of temperature on the performance of industrial hollow-fibre (HF) membranes treating urban wastewater in a submerged anaerobic MBR system (SAnMBR). To this end, a demonstration plant with two commercial HF ultrafiltration membrane modules (PURON®, Koch Membrane Systems, PUR-PSH31) was operated at 20, 25 and 33 °C. The mixed liquor total solid (MLTS) level was a key factor affecting membrane permeability (K). K was higher under psychrophilic than mesophilic conditions when operating at similar transmembrane fluxes and MLTS, because the biomass activity of the psychrophilic mixed liquor was lower than the mesophilic mixed liquor. Thus, lower ext…

Mesophilic and psychrophilic anaerobic conditionsSoluble microbial products (SMPs)INGENIERIA HIDRAULICAMembrane permeabilityFoulingChemistryEnvironmental engineeringUltrafiltrationFiltration and SeparationPulp and paper industryAnalytical ChemistryMembraneExtracellular polymeric substanceMembrane permeabilityWastewaterExtracellular polymeric substances (EPSs)PsychrophileIndustrial hollow-fibre membranesTECNOLOGIA DEL MEDIO AMBIENTEMesophile
researchProduct

Effect of C/N shock variation on the performances of a moving bed membrane bioreactor.

2015

Abstract The effect of a sharp variation of C/N ratio in a moving bed membrane bioreactor (MB-MBR) pilot plant treating high strength wastewater has been investigated. The experimental campaign was divided into two periods, each characterized by a different C/N ratio (namely, 2.5 and 15, Period 1 and Period 2, respectively). The MB-MBR system was analyzed in terms of organic carbon removal, nitrification efficiency, biokinetic activity and fouling behavior. The results showed that the nitrification process was severely affected by lower C/N value and by high concentration of ammonia. It was noticed an extensive stress effect on the autotrophic bacteria. Furthermore, it was observed an incre…

Moving bed membrane bioreactorEnvironmental EngineeringBiofoulingNitrogenOLRBioengineeringPilot ProjectsC/N ratio; Moving bed membrane bioreactor; Nitrification; OLR; Bioengineering; Environmental Engineering; Waste Management and DisposalMembrane bioreactorWaste Disposal FluidAmmoniachemistry.chemical_compoundExtracellular polymeric substanceBiopolymersBioreactorsAmmoniaBioreactorBiomassWaste Management and DisposalBiological Oxygen Demand AnalysisChromatographyFoulingBacteriaRenewable Energy Sustainability and the EnvironmentChemistryMembranes ArtificialGeneral MedicineC/N ratioNitrificationCarbonMembraneChemical engineeringBiofilmsNitrificationOxidation-ReductionParticle depositionBioresource technology
researchProduct

Fate of aerobic granular sludge in the long-term: The role of EPSs on the clogging of granular sludge porosity

2016

This work aims to investigate the stability of aerobic granular sludge in the long term, focusing on the clogging of the granular sludge porosity exerted by the extracellular polymeric substances (EPSs). The effects of different cycle lengths (short and long-term cycle) on the granular sludge stability were investigated. Results obtained outlined that during the short duration cycle, the formation and breakage of the aerobic granules were continuously observed. During this period, the excess of EPS production contributed to the clogging of the granules porosity, causing their breakage in the long run. During the long-duration cycle, the extended famine period entailed a greater EPSs consump…

Porosity cloggingEnvironmental EngineeringPolymers0208 environmental biotechnology02 engineering and technology010501 environmental sciencesManagement Monitoring Policy and Law01 natural sciencesWater PurificationCloggingBioreactorsExtracellular polymeric substanceBreakageExtracellular polymeric substances (EPSs)BiomassLong-term stabilityPorosityWaste Management and DisposalShort durationAerobic granular sludge; Extracellular polymeric substances (EPSs); Feast/famine; Long-term stability; Porosity clogging; Environmental Engineering; Waste Management and Disposal; Management Monitoring Policy and Law0105 earth and related environmental sciencesBacteriaSewageSettore ICAR/03 - Ingegneria Sanitaria-AmbientaleChemistryEnvironmental engineeringGeneral MedicineLimitingPulp and paper industryAerobiosis020801 environmental engineeringFeast/famineAerobic granular sludgePorosity
researchProduct

Physical properties and Extracellular Polymeric Substances pattern of aerobic granular sludge treating hypersaline wastewater.

2017

The modification of the physical properties of aerobic granular sludge treating fish-canning wastewater is discussed in this paper. The structure and composition of the Extracellular Polymeric Substances (EPSs) were analyzed at different salinity levels and related to granules stability. Results outlined that the total EPSs content increased with salinity, despite the EPSs increment was not proportional to the salt concentration. Moreover, the EPSs structure was significantly modified by salinity, leading to a gradual increase of the not-bound EPSs fraction, which was close to the 50% of the total EPSs content at 75 g NaCl L-1. The increasing salt concentration modified also the EPSs compos…

SalinityEnvironmental Engineering0208 environmental biotechnologyBioengineering02 engineering and technology010501 environmental sciencesSodium ChlorideWastewater01 natural sciencesWaste Disposal FluidProtein contentExtracellular polymeric substanceBiopolymersBioreactorsFood-Processing IndustryWaste Management and Disposal0105 earth and related environmental sciencesSettore ICAR/03 - Ingegneria Sanitaria-AmbientaleSewageRenewable Energy Sustainability and the EnvironmentChemistryGranule (cell biology)General MedicineAerobiosis020801 environmental engineeringSalinityChemical engineeringWastewaterAerobic granular sludge EPS Industrial wastewater Fish-canning wastewater Hypersaline wastewaterGradual increaseHydrophobic and Hydrophilic InteractionsBioresource technology
researchProduct

The role of extracellular polymeric substances (EPS) on aerobic granules formation: comparison between a case of synthetic wastewater supply and anot…

2015

The paper focused on the evolution of extracellular polymeric substances (EPSs) content during the granulation process in two Granular Sequencing Batch Airlift Reactors (GSBAR) (3,5 L) fed with synthetic and industrial wastewater. Results showed that EPSs, in particular proteins (PN) were mainly produced during the feast phase because of high substrate availability, especially under conditions of metabolic stress. Than EPSs content reduced during the famine period. More in detail, during the granulation process, a greater polysaccharides (PS) consumption occurred in both reactors, while PN content reduced significantly only in R2. As a result PN/PS ratio increased significantly during granu…

Settore ICAR/03 - Ingegneria Sanitaria-AmbientaleAerobic granular sludge granulation extracellular polymeric substances (EPSs) feast/famine phases industrial wastewater
researchProduct

Membrane Fouling Mitigation in MBR via the Feast–Famine Strategy to Enhance PHA Production by Activated Sludge

2022

Fouling is considered one of the main drawbacks of membrane bioreactor (MBR) technology. Among the main fouling agents, extracellular polymeric substances (EPS) are considered one of the most impactful since they cause the decrease of sludge filterability and decline of membrane flux in the long term. The present study investigated a biological strategy to reduce the membrane-fouling tendency in MBR systems. This consisted of seeding the reactor with activated sludge enriched in microorganisms with polyhydroxyalkanoate (PHA) storage ability and by imposing proper operating conditions to drive the carbon toward intracellular (PHA) rather than extracellular (EPS) accumulation. For that purpos…

Settore ICAR/03 - Ingegneria Sanitaria-AmbientaleProcess Chemistry and Technologyextracellular polymeric substances (EPS) cake layer fouling control membrane bioreactor (MBR) polyhydroxyalkanoate (PHA) resistance in series (RIS) model soluble microbial products (SMP)Chemical Engineering (miscellaneous)Filtration and Separationextracellular polymeric substances (EPS); cake layer; fouling control; membrane bioreactor (MBR); polyhydroxyalkanoate (PHA); resistance in series (RIS) model; soluble microbial products (SMP)Membranes
researchProduct

Effect of E. coli biofilm formation and removal on passive films on AISI 316L during fermentation processes

2021

Abstract 316L coupons were sanitized in hot water vapour inducing iron enrichment in passive films. Coupons were then immersed in a pilot fed-batch fermenter in presence of E. coli. Sanitization causes iron enrichment in passive films. Fermentation causes the growth of biofilm on the SS, constituted by bacteria embedded in an extracellular polymeric substance. During fermentation SS open circuit potential is very negative due to low oxygen concentration on its surface, while the chelating action of siderophores induces chromium enrichment in the passive film. Disinfection in NaClO for 30 min allows removal of biofilm and formation of a protective passive film.

SiderophorebiologyChemistry020209 energyGeneral Chemical EngineeringBiofilmchemistry.chemical_elementIndustrial fermentation02 engineering and technologyGeneral Chemistry021001 nanoscience & nanotechnologybiology.organism_classificationAISI 316L Biofilm Disinfection Fermentation Passive film SanitizationCorrosionChromiumExtracellular polymeric substanceSettore ING-IND/23 - Chimica Fisica ApplicataChemical engineering0202 electrical engineering electronic engineering information engineeringGeneral Materials ScienceFermentation0210 nano-technologyBacteria
researchProduct

Impact of membrane addition for effluent extraction on the performance and sludge characteristics of upflow anaerobic sludge blanket reactors treatin…

2015

Abstract In this study, the impact of membrane incorporation for effluent extraction on the performance of an upflow anaerobic sludge blanket (UASB) reactor treating municipal wastewater was investigated in terms of system performance and sludge characteristics. A laboratory-scale system was operated in two different operational stages: (i) as a sole UASB reactor and (ii) as an anaerobic membrane bioreactor (AnMBR). Membrane incorporation induced an accumulation of fine particles and a decrease in extracellular polymeric substances (EPS), resulting in a decrease in particle size distribution (PSD) and, thus, a drop in sludge settleability. Deterioration of sludge settleability led to an inc…

Waste managementChemistryChemical oxygen demandExtraction (chemistry)Membrane foulingFiltration and SeparationBiochemistryExtracellular polymeric substanceMembraneWastewaterGeneral Materials SciencePhysical and Theoretical ChemistryEffluentTotal suspended solidsJournal of Membrane Science
researchProduct

Processing of metals and metalloids by actinobacteria: Cell resistance mechanisms and synthesis of metal(loid)-based nanostructures

2020

Metal(loid)s have a dual biological role as micronutrients and stress agents. A few geochemical and natural processes can cause their release in the environment, although most metal-contaminated sites derive from anthropogenic activities. Actinobacteria include high GC bacteria that inhabit a wide range of terrestrial and aquatic ecological niches, where they play essential roles in recycling or transforming organic and inorganic substances. The metal(loid) tolerance and/or resistance of several members of this phylum rely on mechanisms such as biosorption and extracellular sequestration by siderophores and extracellular polymeric substances (EPS), bioaccumulation, biotransformation, and me…

biogenic nanoscale materials0301 basic medicineMicrobiology (medical)Siderophore010501 environmental sciencesSettore BIO/19 - Microbiologia Generale01 natural sciencesMicrobiologycomplex mixturesActinobacteria03 medical and health sciencesmetal resistance mechanismsBioremediationExtracellular polymeric substanceBiotransformationMetal stress responseVirologyBiogenic nanoscale materialBioprocesslcsh:QH301-705.5Settore CHIM/02 - Chimica Fisica0105 earth and related environmental sciencesbiologyChemistrybiology.organism_classificationActinobacteria030104 developmental biologylcsh:Biology (General)BioaccumulationEnvironmental chemistryMetal resistance mechanismbacteriaMetalloidMetal-based nanostructures
researchProduct

Polymer-induced phase separation in Escherichia coli suspensions

2010

We studied aggregation and phase separation in suspensions of de-flagellated Escherichia coli (AB1157) in phosphate buffer induced by the anionic polyelectrolyte sodium polystyrene sulfonate. We also performed Monte Carlo simulations of this system based on the Asakura–Oosawa model of colloid–polymer mixtures. The results of these simulations, as well as comparison with previous work on synthetic colloid–polymer mixtures, demonstrate that the role of the polymer is to cause a depletion attraction between the E. coli cells. The implication of these results for understanding the role of (predominantly anionic) extracellular polymeric substances (EPS) secreted by bacteria in various natural ph…

chemistry.chemical_classificationFlocculationChromatographybiologyChemistryBiofilmGeneral ChemistryPolymerCondensed Matter Physicsmedicine.disease_causebiology.organism_classificationPolyelectrolyteExtracellular polymeric substanceChemical engineeringmedicineSodium Polystyrene SulfonateEscherichia coliBacteriaSoft Matter
researchProduct