Search results for "fluid"

Measurement of t ¯ t production with a veto on additional central jet activity in pp collisions at √ s = 7 TeV using the ATLAS detector

2012

A measurement of the jet activity in t[bar over t] events produced in proton–proton collisions at a centre-of-mass energy of 7 TeV is presented, using 2.05 fb[superscript −1] of integrated luminosity collected by the ATLAS detector at the Large Hadron Collider. The t[bar over t] events are selected in the dilepton decay channel with two identified b-jets from the top quark decays. Events are vetoed if they contain an additional jet with transverse momentum above a threshold in a central rapidity interval. The fraction of events surviving the jet veto is presented as a function of this threshold for four different central rapidity interval definitions. An alternate measurement is also perfor…

Chromatography with dense gases

1992

A capillary restrictor for supercritical fluid chromatography (SFC) with CO2 was made by using a micro torch and fine emery cloths or grinding blocks. This restrictor could be drawn out either directly from the end of the analytical capillary column, or from a short piece of any capillary, which was then connected to the analytical column by standard techniques. It was found that the base current of a flame ionisation detector (FID) depends strongly on the position of the capillary end with respect to the FID flame tip and on the CO2 grade, of course. Best results have been achieved at around 5 to 7 mm distance between the restrictor and the flame tip ends, and using SFC grade CO2.

Erratum: “Nonadiabatic orientation, toroidal current, and induced magnetic field in BeO molecules” [J. Chem. Phys. 129, 164303 (2008)]

2009

Whispering gallery mode resonator sensors referenced to saturated absorption lines in rubidium atoms and a fs frequency comb

2019

Optical Whispering Gallery Mode Resonators (WGMR) can be produced by many methods, for example, by flame melting of silica fibers [1], by polishing of crystals [2], by optical lithography, by solidifying transparent materials, or using commercially available microspheres. They confine light by the total internal reflection and do not need mirror coatings. A part of radiation is traveling outside the WGMR as an evanescent wave and it is used for sensing applications. WGMRs are becoming increasingly popular as biosensors [3] when their surface is covered with antibodies to provide selectivity. Advantage is that light circulates in the resonator and interacts many times with a few molecules at…

Tuneable multicoloured patterns from photonic cross-communication between cholesteric liquid crystal droplets

2014

Monodisperse droplets of planar-aligned cholesteric (N*) liquid crystal exhibit an intriguing capacity for photonic cross-communication, giving rise to colourful patterns that depend sensitively on the N* pitch, droplet positions and illuminated area. The phenomenon results from a combination of omnidirectional selective reflection of N* droplets—which thus act as spherically symmetric self-assembled photonic crystals—and total internal reflection at the continuous phase surface. We outline how the unique optical properties can be employed in numerous applications.

Back-scattering of whispering-gallery-modes resonances of cylindrical microcavities: Refractometric applications

2009

Whispering-gallery modes (WGM) resonances of microcapillaries are directly compatible with microfluidic systems and have demonstrated its suitability for refractometric applications [1]. Microcapillaries with a submicrometric wall exhibit very large wavelength shifts as a function of the refractive index of the liquids that fill the inside of the capillary [2]. The spatial separation between the surface where the total internal reflection takes place (the outer surface) and the sensing surface (the inner surface) where the wave interacts with the analyte is a unique property that can be exploited to deal with analytes with a refractive index higher than that of the capillary [2].

Direct Bragg grating writing in a hybrid PDMS/silica photonic crystal fiber

2011

Infiltration of materials into the air holes of the PCFs can potentially manipulate their optical properties creating a new category of fibers termed as hybrid PCFs [1] and many devices based on hybrid PCFs have been developed [2–5]. Recently, a hybrid PCF with poly-dimethylsiloxane (PDMS) elastomer inclusions has been demonstrated [6]. PDMS is widely used in the area of photonics and optofluidics. It is highly transparent with a refractive index ∼1.41, conserving the total internal reflection guiding mechanism of the hybrid PCF. When PDMS is irradiated with UV light its refractive index increases [7]. In this paper we present the first example of a Bragg grating directly written using UV l…

Lipid and fatty acid variations inCiona intestinalis ovary after tri-n-butyltin(IV)chloride exposure

2005

Reduction of total lipids (TL) content and significant variations of triglyceride (TG) and phospholipid (PL) fractions were observed as a consequence of exposure of Ciona intestinalis ovaries to tributyltin chloride (TBTCL) solutions. In particular, an evident TG decrease and a PL increase were observed, which probably provoked an increment in membrane fluidity, because of the high concentration of long chain fatty acids and, as a consequence, PL. This could be a cell adaptive standing mechanism towards the pollutants, as observed in Saccharomyces cerevisiae. Also the increase in the content of the polyunsaturated fatty acids (PUFA), important in the synthesis of compounds such as prostagla…

Trace element behavior in the fluidized bed gasification of solid recovered fuels

2013

Gasification of biomass and recycled fuels is of particular interest for the efficient production of power and heat. Trace elements present as impurities in the product gas should be removed very efficiently. The objective of this work has been to develop and test thermodynamic models for the reactions of trace elements with chlorine and sulfur in the gasification processes of recycled fuels. In particular, the chemical reactions of trace elements with main thermochemical conversion products, main ash components, and bed and sorbent material are implemented into the model. The possibilities of gas cleaning devices in condensing and removing the trace element compounds are studied by establi…

Blood Component Therapy and Coagulopathy in Trauma: A Systematic Review of the Literature from the Trauma Update Group

2016

Background Traumatic coagulopathy is thought to increase mortality and its treatment to reduce preventable deaths. However, there is still uncertainty in this field, and available literature results may have been overestimated. Methods We searched the MEDLINE database using the PubMed platform. We formulated four queries investigating the prognostic weight of traumatic coagulopathy defined according to conventional laboratory testing, and the effectiveness in reducing mortality of three different treatments aimed at contrasting coagulopathy (high fresh frozen plasma/packed red blood cells ratios, fibrinogen, and tranexamic acid administration). Randomized controlled trials were selected alo…