Search results for "fume"
showing 10 items of 50 documents
Heusler compounds as ternary intermetallic nanoparticles: Co2FeGa
2009
This work describes the preparation of ternary nanoparticles based on the Heusler compound Co2FeGa. Nanoparticles with sizes of about 20?nm were synthesized by reducing a methanol impregnated mixture of CoCl2 ? 6H2O, Fe(NO3)3 ? 9H2O and Ga(NO3)3 ? xH2O after loading on fumed silica. The dried samples were heated under pure H2 gas at 900??C. The obtained nanoparticles?embedded in silica?were investigated by means of x-ray diffraction (XRD), transmission electron microscopy, temperature dependent magnetometry and M??bauer spectroscopy. All methods clearly revealed the Heusler-type L21 structure of the nanoparticles. In particular, anomalous XRD data demonstrate the correct composition in addi…
Near-Infrared Emission of O2 Embedded in Amorphous SiO2 Nanoparticles
2011
We report an experimental study on the emission properties of O2 molecules loaded by a thermal diffusion process at 200 °C into high-purity silica nanoparticles with mean diameters of 7 and 40 nm. The embedded O 2 features a singlet to triplet emission band peaked at 1272 nm in agreement with the band observed for bulk silica materials. The photoluminescence excitation spectra have been determined in the visible and in the infrared range and are characterized by narrow bands peaked at 691, 764, and 1069 nm, respectively. By comparison of the transition energies, the vibrational quanta have been determined for the ground and for both the excited states; the values found are lower than the co…
Structure of amorphous SiO 2 nanoparticles probed through the E′ γ centers
2011
We report an experimental investigation by electron paramagnetic resonance (EPR) spectroscopy on the properties of the E′ γ centers induced by β-ray irradiation in nanoparticles of amorphous SiO 2 (fumed silica) with mean diameters from 7 up to 40 nm. We found that the E′ γ centers are induced in all the fumed silica types in the dose range 4-400 kGy. They are characterized by an EPR line shape similar to that observed in common bulk silica materials independently on the particle diameter. Moreover, the E′ γ center concentration decreases on decreasing of the particle size for each given dose. Our findings are interpreted in terms of a shell-like model of nanoparticles in which it is assume…
Effect of Hydration Procedure of Fumed Silica Precursor on the Formation of Luminescent Carbon Centers in SiO 2 :C Nanocomposites
2019
The effect of hydration procedure of fumed silica precursor on photoluminescent properties of carbonized silica (SiO2:C) nanocomposite after chemo/thermal treatments is studied. Main structural effect is the formation of chemical bonding of phenyl groups to silica surface via multiple CSiO bonding bridges. Synthesized samples demonstrate very broad photoluminescence (PL) bands in near ultraviolet and visible ranges with maximum intensity dependent on temperature of thermal annealing. Two main trends in luminescence properties are: 1) hydration-induced blue shift of PL in comparison with PL of unhydrated series; 2) red shift of PL bands with increasing synthesis temperature regardless hydr…
Multiband light emission and nanoscale chemical analyses of carbonized fumed silica
2018
Fumed silica with a specific area of 295 m2/g was carbonized by successive phenyltrimethoxysilane treatments followed by annealing in inert atmosphere up to 650 °C. Emission, excitation, kinetics, and photo-induced bleaching effects were investigated by steady state and time-resolved photoluminescence spectroscopies. The local chemistry was also studied by infrared transmission spectroscopy. Strong ultraviolet and visible photoluminescence was observed in the samples after the chemical treatments/modifications and thermal annealing. It has been shown that ultraviolet photoluminescence in chemically modified fumed silica is associated with phenyl groups, while near ultraviolet and visible em…
Entrapping of O2 Molecules in Nanostructured Silica Probed by Photoluminescence
2013
We studied the emission of the O2 molecules embedded in fumed silica (amorphous silicon dioxide) nanoparticles differing for diameters and specific surface. By using a 1064 nm laser as a source we recorded both the O2 emission and the Raman signal of silica. Our experimental data show that the O2 emission/Raman signal (at 800cm-1) ratio decreases with increasing the specific surface both for the as received and the loaded samples. By performing a thermal treatment (600 °C for 2h) we modified the structure and the water content of the smallest nanoparticles without observing any significant change in the O2 emission/Raman signal ratio. Our data are explained by a shell model showing that the…
Investigation on the Properties and on the Photo-Oxidation Behaviour of Polypropylene/Fumed Silica Nanocomposites
2021
This work investigates the effects of very small amounts of fumed silica on the morphology and on the rheological and mechanical behaviour of polypropylene nanocomposites and on their photo-oxidation behaviour. Polypropylene nanocomposites were prepared using a twin-screw corotating extruder with 0, 1 and 2 wt/wt% of SiO2. Morphological, mechanical, thermomechanical and rheological properties were examined. It was found that the viscosity of the matrix is reduced by the presence of the silica nanoparticles, suggesting a poor adhesion between the two phases and probably some lubricating effect. On the contrary, the mechanical and, in particular, the thermomechanical properties of the matrix …
Atomic force microscopy and Raman investigation on the sintering process of amorphous SiO2 nanoparticles
2010
We report an experimental investigation on the sintering process induced in fumed silica powders by isochronal thermal treatments at T=1270 K. Three types of fumed silica are considered, consisting of amorphous SiO2 (a-SiO2) particles with mean diameters 7, 14, and 40 nm. The study is performed by atomic force microscopy (AFM), to follow the morphological changes, and by Raman scattering, to obtain information on the concomitant structural modifications. The former method indicates that the sintering process proceeds by aggregation of single particles into larger grains, whose sizes increase with the thermal treatment duration. Furthermore, for each fumed silica type considered, the quantit…
Full inhibition of enzymatic browning in the presence of thiol-functionalised silica nanomaterial
2018
[EN] Darkening processed fruits and vegetables is caused mainly by enzymatic browning through polyphenol oxidase (PPO) action. Accordingly, we explored the potential of four silica-based materials (MCM-41 nanometric size, MCM-41 micrometric size, UVM-7 and aerosil), non-functionalised and functionalised with thiol groups, to inhibit PPO activity in the model system and apple juice. All materials showed relevant performance when immobilising and inhibiting PPO in model systems, and support topology is a main factor for enzyme immobilisation and inhibition. Thiol-containing silica UVM7-SH showed the greatest inactivation, and similar browning values to those obtained by acidification. The enz…
Performance of porous silica layers in open-tubular columns for liquid chromatography
1989
Abstract Progress has been made in the preparation of porous silica layers in fused-silica capillaries for open-tubular liquid chromatography. The porous silica layer is prepared by (i) static coating of the silica precursor, polyethoxysiloxane (PES), followed by (ii) converting the PES film into a porous silica layer with ammonia solution. The porous silica layer can be easily modified by silane reagents commonly used in packed column high-performance liquid chromatography. The performance of the silica layer with the different phase systems was tested with polyaromatic hydrocarbons and derivatized amino acids as samples.