Search results for "germani"
showing 10 items of 488 documents
Electronic Band Transitions in γ-Ge3N4
2021
This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the Euratom research and training programme 2014-2018 and 2019-2020 under grant agreement No 633053. The views and opinions expressed herein do not necessarily reflect those of the European Commission. Support from Estonian Research Council grant PUT PRG 619 is gratefully acknowledged. The multi-anvil experiments at LMV were supported by the French Government Laboratory of Excellence initiative no ANR-10-LABX-0006, the Région Auvergne and the European Regional Development Fund (ClerVolc Contribution Number 478).
Two-terminal nanoelectromechanical devices based on germanium nanowires.
2009
A two-terminal bistable device, having both ON and OFF regimes, has been demonstrated with Ge nanowires using an in situ TEM-STM technique. The function of the device is based on delicately balancing electrostatic, elastic, and adhesion forces between the nanowires and the contacts, which can be controlled by the applied voltage. The operation and failure conditions of the bistable device were investigated, i.e. the influence of nanowire diameter, the surface oxide layer on the nanowires and the current density. During ON/OFF cycles the Ge nanowires were observed to be more stable than carbon nanotubes, working at similar conditions, due to the higher mechanical stability of the nanowires. …
Chalcogenide Glasses Based on Germanium Disulfide for Second Harmonic Generation
2007
International audience; High second-order susceptibilities are created by thermal poling in bulk germanium disulfide based chalcogenide glasses. Experimental conditions of the poling treatment (temperature, voltage, time) were optimized for each glass composition. The second-order nonlinear signals were recorded by using the Maker fringes experiment and a second-order coefficient χ(2) up to 8 pm V-1 was measured in the Ge25Sb10S65 glass. This value is obtained using a simulation based on accurate knowledge of the thickness of the nonlinear layer. Two mechanisms are proposed to explain the creation of a nonlinear layer under the anode: the formation and the migration of charged defects towar…
Structural investigation of crystallized Ge-Ga-Se chalcogenide glasses
2018
H. Klym thanks to the Ministry of Education and Science of Ukraine for support and Dr. P. Demchenko for the assistance in XRD experiments.
Structural Principles and Thermoelectric Properties of Polytypic Group 14 Clathrate-II Frameworks
2013
We have investigated the structural principles and thermoelectric properties of polytypic group 14 clathrate-II frameworks using quantum chemical methods. The experimentally known cubic 3C polytype was found to be the energetically most favorable framework, but the studied hexagonal polytypes (2 H, 4 H, 6 H, 8 H, 10 H) lie energetically close to it. In the case of germanium, the energy difference between the 3C and 6H clathrate-II polytypes is ten times smaller than the difference between the experimentally known 3C-Ge (α-Ge) and 4H-Ge polytypes. The thermoelectric properties of guest-occupied clathrate-II structures were investigated for compositions Na-Rb-Ga-Ge and Ge-As-I. The clathrate-…
Reverse Monte Carlo modeling of thermal disorder in crystalline materials from EXAFS spectra
2012
Abstract In this work we present the Reverse Monte Carlo (RMC) modeling scheme, designed to probe the local structural and thermal disorder in crystalline materials by fitting the wavelet transform (WT) of the EXAFS signal. Application of the method to the analysis of the Ge K-edge and Re L3-edge EXAFS signals in crystalline germanium and rhenium trioxide, respectively, is presented with special attention to the problem of thermal disorder and related phenomena.
Isotopic Effect In Extended X-Ray-Absorption Fine Structure of Germanium
2008
Extended x-ray absorption fine structure has been measured on two powdered samples of 70Ge and 76Ge as a function of temperature from 20 to 300 K. The effect of isotopic mass difference on the amplitude of relative atomic vibrations is neatly evidenced by the temperature dependence of the difference of Debye-Waller factors. The isotopic effect is also detected on the difference of nearest-neighbor average ineratomic distances, thanks to a resolution better than 10 fm. (DOI: 10.1103/PhysRevLett.100.055901)
Molecular dynamics simulations of EXAFS in germanium
2011
AbstractClassical molecular dynamics simulations have been performed for crystalline germanium with the aim to estimate the thermal effects within the first three coordination shells and their influence on the single-scattering and multiple-scattering contributions to the Ge K-edge extended x-ray absorption fine structure (EXAFS).
Exfoliation of Alpha-Germanium: A Covalent Diamond-Like Structure
2021
2D materials have opened a new field in materials science with outstanding scientific and technological impact. A largely explored route for the preparation of 2D materials is the exfoliation of layered crystals with weak forces between their layers. However, its application to covalent crystals remains elusive. Herein, a further step is taken by introducing the exfoliation of germanium, a narrow-bandgap semiconductor presenting a 3D diamond-like structure with strong covalent bonds. Pure α-germanium is exfoliated following a simple one-step procedure assisted by wet ball-milling, allowing gram-scale fabrication of high-quality layers with large lateral dimensions and nanometer thicknesses.…
Planar Array Technology for the Fabrication of Germanium X-Ray Microcalorimeters
2008
Several technologies are presently competing for measuring the temperature increase in cryogenic micro-calorimeters used as high resolution energy-dispersive X-ray detectors. Doped germanium, whose resistivity depends on temperature, is a promising material for this purpose, because of its comparatively low specific heat and the possibility of making wafers with high doping uniformity by neutron transmutation. Presently, Ge-based microcalorimeters are still micro-machined and manually assembled. Here we present a planar approach to the fabrication of 2-D arrays of microcalorimeters and show the preliminary technological results.