Search results for "layer"

Cationic Au Nanoparticle Binding with Plasma Membrane-like Lipid Bilayers: Potential Mechanism for Spontaneous Permeation to Cells Revealed by Atomis…

2014

Despite being chemically inert as a bulk material, nanoscale gold can pose harmful side effects to living organisms. In particular, cationic Au nanoparticles (AuNP+) of 2 nm diameter or less permeate readily through plasma membranes and induce cell death. We report atomistic simulations of cationic Au nanoparticles interacting with realistic membranes and explicit solvent using a model system that comprises two cellular compartments, extracellular and cytosolic, divided by two asymmetric lipid bilayers. The membrane-AuNP+ binding and membrane reorganization processes are discovered to be governed by cooperative effects where AuNP+, counterions, water, and the two membrane leaflets all contr…

Investigation of Adsorption behaviour of Acetone Vapour towards a Surface Plasmon Resonance Sensing Layer using Adsorption Isotherm Models

2021

Abstract Surface plasmon resonance (SPR) sensors are widely explored due their ultra-sensitivity to even a minute alteration of refractive index. Knowledge of adsorption processes could be exploited to explain the performance and interaction mechanism of an SPR sensor. Here in, we report the fitting of the experimental SPR sensing data during the detection of low concentrations of acetone vapour (0.5-5 ppm) using the linearized and non-linearized format of the Langmuir and the Freundlich isotherm models. The sensing layer is made from a ternary composite material of doped polyaniline, reduced graphene oxide and chitosan. The objective is to find the best model, understand the interaction me…

Evidence for the formation of sodium hassate(VIII)

2004

SummaryHassium, element 108, was produced in the fusion reaction between26Mg and248Cm. The hassium recoils were oxidizedin-situto a highly volatile oxide, presumably HsO4, and were transported in a mixture of He and O2to a deposition and detection system. The latter consisted of 16 silicon PIN-photodiodes facing a layer of NaOH, which served, in the presence of a certain partial pressure of water in the transport gas, as reactive surface for the deposition of the volatile tetroxides. Six correlated α-decay chains of Hs were detected in the first 5 detectors centred around detection position 3. In analogy to OsO4, which forms Na2[OsO4(OH)2], an osmate(VIII), with aqueous NaOH, HsO4presumably…

Separation of Enantiomers in a Monolayer of Racemic 3-Hexadecyl-oxy-propane-1,2-diol

1993

Monolayers of a racemic mixture and of the pure S enantiomer of 3-hexadecyloxy-propane-1,2-diol have been characterized by thermodynamic measurements at the air/water interface as well as by fluorescence microscopy. The critical temperatire T c , the limiting molecular area at high pressure and the pressure π c corresponding to the observed main phase transition, derived from the isotherms, slightly depend on chiral purity

1981

Thin-layer chromatography of chlorinated catechols on a silica gel 60 layer

1981

Vitrification in restricted geometry: dry films of colloidal particles

2007

We prepared dry films of colloidal particles from surfactant co-stabilized polystyrene and poly(methyl methacrylate) latex spheres of moderate polydispersity. The film thickness was varied from monolayer to some 20 μm. The average structure and the influence of polydispersity was analyzed by small-angle X-ray scattering. An analysis of local microscopic structures was performed by force microscopy on the least polydisperse sample. Irrespective of the thickness, we observe the formation of only short-ranged order which is rather pronounced but changes its qualitative character in the vicinity of the substrate. The observations suggest a bulk structure of small, defect-rich and stacking fault…

Cation-induced self-assembly of an amphiphilic perylene diimide derivative in solution and Langmuir–Blodgett films

2015

Abstract A novel amphiphilic perylenetetracarboxylic diimide (PDI) derivative, N-(4′-benzo-15-crown-5-ether)-N-hexyl-1,7-di(4-tert-butyl-phenoxy)perylen-3,4,9,10-tetracarboxylic diimide (15C5PDI), has been synthesized and characterized. Dimerization of 15C5PDI is induced in CHCl 3 solution with the present of K + , resulting in the formation of the slipped co-facial J -aggregates, as revealed by absorption and fluorescence spectroscopies. Analysis of the surface pressure–area ( π – A ) isotherms and spectral change for the monolayer formed at the air/water interface, disclosed that 15C5PDI molecules adopted the H -type aggregation mode with a face-to-face configuration and edge-on orientati…

Influence of a hydrophilic spacer on the structure of a phospholipid monolayer

1994

We present the results of thermodynamical and X-ray grazing incidence diffraction experiments performed on Langmuir monolayers of ether lipids with hydrophilic spacers between the glycerol backbone and the phosphatidylcholine head group: DHPC, DH-E01-PC, and DH-E02-PC. As a spacer the oxy-ethylene group is used, which is a typical hydrophilic unit of non-ionic tensides. It turns out that the introduction of the hydrophilic spacers leads to a fluidization of the monolayer and reduces the tilt angle of the chains.

Block copolymers in giant unilamellar vesicles with proteins or with phospholipids

2013

Biocompatible, highly water-soluble, nonionic, amphiphilic block copolymers having different hydrophobic blocks and architectures, but similar molecular size and chemical nature of the hydrophilic blocks, were investigated to check for their ability to form hybrid giant unilamellar vesicles with proteins, and for their interactions with giant unilamellar phospholipid vesicles (GUV). PGM14-b-PPO34-b-PGM14 (PGM-PPO-PGM) consists of a poly(propylene oxide) middle block and outer poly(glycerol monomethacrylate) blocks. Ch-PEG32-b-lPG18 (Ch-PEG-lPG) and Ch-PEG30-b-hbPG17 (Ch-PEG-hbPG) have a linear poly(ethylene glycol) block, linked to a cholesterol end group and to a linear (lPG) or hyperbranc…