Search results for "lini"

showing 10 items of 40981 documents

Pressure-induced instability of the fergusonite phase of EuNbO4 studied by in situ Raman spectroscopy, x-ray diffraction, and photoluminescence spect…

2020

In this article, we present high-pressure experimental investigations on EuNbO4, an interesting technologically important material, using synchrotron based x-ray powder diffraction, Raman spectroscopy, and europium photoluminescence measurements up to 39.2, 31.6, and 32.4 GPa, respectively. All three techniques show the stability of the ambient monoclinic phase until 20 GPa. Beyond that, a pressure-induced structural phase transition takes place with the coexistence of two phases over a wide pressure range. The structure of the high-pressure phase has been determined as orthorhombic (space group: Imma) with a volume discontinuity of nearly 9% at the transition indicating the nature of trans…

010302 applied physicsBulk modulusMaterials scienceAnalytical chemistryGeneral Physics and Astronomychemistry.chemical_element02 engineering and technology021001 nanoscience & nanotechnologyFergusonite01 natural sciencessymbols.namesakechemistry0103 physical sciencessymbolsOrthorhombic crystal system0210 nano-technologySpectroscopyEuropiumRaman spectroscopyPowder diffractionMonoclinic crystal systemJournal of Applied Physics
researchProduct

The α and γ plasma modes in plasma-enhanced atomic layer deposition with O2-N2 capacitive discharges

2017

Two distinguishable plasma modes in the O2–N2 radio frequency capacitively coupled plasma (CCP) used in remote plasma-enhanced atomic layer deposition (PEALD) were observed. Optical emission spectroscopy and spectra interpretation with rate coefficient analysis of the relevant processes were used to connect the detected modes to the α and γ modes of the CCP discharge. To investigate the effect of the plasma modes on the PEALD film growth, ZnO and TiO2 films were deposited using both modes and compared to the films deposited using direct plasma. The growth rate, thickness uniformity, elemental composition, and crystallinity of the films were found to correlate with the deposition mode. In re…

010302 applied physicsMaterials scienceAcoustics and UltrasonicsCapacitive sensingAnalytical chemistry02 engineering and technologyPlasma021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesSpectral lineSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsAtomic layer depositionCrystallinity0103 physical sciencesDeposition (phase transition)plasma modesCapacitively coupled plasmaRadio frequency0210 nano-technologyplasma-enhanced atomic layer deposition
researchProduct

The effects of thermal treatment on structural, morphological and optical properties of electrochemically deposited Bi2S3 thin films

2017

Abstract Thin films of bismuth sulfide (Bi 2 S 3 ) have been electrochemically deposited on indium–doped tin oxide substrates from aqueous solutions of Bi(NO 3 ) 3 , ethylene diamine tetraacetic acid (EDTA) and Na 2 S 2 O 3 . The structural properties of the films were characterized using X–ray diffraction and high–resolution transmission electron microscopy analyses. The film crystallizes in an orthorhombic structure of Bi 2 S 3 along with metallic bismuth. Thermal annealing of the prepared film in sulfur atmosphere improves its crystallinity and cohesion. The band gap values of the deposited film before and after annealing at 400 °C were found to be 1.28 and 1.33 eV, respectively.

010302 applied physicsMaterials scienceAnnealing (metallurgy)Band gapInorganic chemistryMetals and Alloyschemistry.chemical_element02 engineering and technologySurfaces and InterfacesThermal treatment021001 nanoscience & nanotechnologyTin oxide01 natural sciencesSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsBismuthCrystallinitychemistryChemical engineeringTransmission electron microscopy0103 physical sciencesMaterials ChemistryThin film0210 nano-technologyThin Solid Films
researchProduct

Flash annealing influence on structural and electrical properties of TiO2/TiO/Ti periodic multilayers

2014

Abstract Multilayered structures with a 40 nm period composed of titanium and two different titanium oxides, TiO and TiO 2 , were accurately produced by DC magnetron sputtering using the reactive gas pulsing process. These multilayers were sputtered onto Al 2 O 3 sapphire to avoid substrate compound diffusion during flash annealing (ranging from 350 °C to 550 °C). Structure and composition of these periodic TiO 2 /TiO/Ti stacks were investigated by X-ray diffraction, X-ray photoemission spectroscopy and transmission electronic microscopy techniques. Two crystalline phases α-Ti and fcc-TiO were identified in the metallic-rich sub-layers whereas the oxygen-rich ones were composed of a mixture…

010302 applied physicsMaterials scienceAnnealing (metallurgy)Metals and Alloyschemistry.chemical_element02 engineering and technologySurfaces and InterfacesSputter deposition021001 nanoscience & nanotechnology01 natural sciencesSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsAmorphous solidCrystallinitychemistryChemical engineeringRutileElectrical resistivity and conductivity0103 physical sciencesMaterials Chemistry[ SPI.NANO ] Engineering Sciences [physics]/Micro and nanotechnologies/Microelectronics[SPI.NANO]Engineering Sciences [physics]/Micro and nanotechnologies/Microelectronics0210 nano-technologyHigh-resolution transmission electron microscopyTitanium
researchProduct

Acoustic vibrations of monoclinic zirconia nanocrystals

2011

International audience; Polarized low-frequency Raman spectra originating from confined acoustic vibrations are reported for monoclinic ZrO2 nanoparticles with a narrow size distribution synthesized from a continuous supercritical water process. The monoclinic lattice structure is taken into account for the interpretation of the spectra by comparing with isotropic and anisotropic continuum elasticity calculations for monodomain nanocrystals. The various mechanisms leading to the broadening of the Raman peaks are discussed. We demonstrate that an accurate determination of the size distribution of the nanoparticles is possible using the Raman peak due to the fundamental breathing vibration wh…

010302 applied physicsMaterials scienceCondensed matter physicsIsotropy[ PHYS.COND.CM-MS ] Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]02 engineering and technologyCrystal structure021001 nanoscience & nanotechnology01 natural sciencesSpectral lineSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsCrystallographysymbols.namesakeGeneral Energy0103 physical sciencessymbols[PHYS.COND.CM-MS]Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]Cubic zirconiaPhysical and Theoretical ChemistryElasticity (economics)0210 nano-technologyAnisotropyRaman spectroscopyMonoclinic crystal system
researchProduct

Preparation and Characterization of Nanocrystalline Gadolinium Oxide Powders and Films

2020

Due to its magnetic, electrical, absorption, and emission properties, nanoscale gadolinium oxide is widely used in various fields. In this research, nanocrystalline Gd2O3 powders and films on glass substrates have been produced by the extraction-pyrolytic method. X-ray diffraction analysis revealed the formation of single phase Gd2O3 with cubic crystal structure and the mean crystallite size from 9 to 25 nm in all produced materials. The morphology of samples has been characterized by scanning electron microscopy and transmission electron microscopy.

010302 applied physicsMaterials scienceMorphology (linguistics)Mechanical Engineering02 engineering and technology021001 nanoscience & nanotechnology01 natural sciencesNanocrystalline materialCharacterization (materials science)Chemical engineeringMechanics of MaterialsLiquid–liquid extraction0103 physical sciencesGeneral Materials ScienceGadolinium oxide0210 nano-technologyPyrolysisKey Engineering Materials
researchProduct

Comparing the luminescence processes of YVO4:Eu and core-shell YVO4@YF3 nanocrystals with bulk-YVO4:Eu

2017

Abstract Comparative analysis of bulk, non-coated and core-shelled nanocrystalline YVO4:Eu was performed by means of time-resolved luminescence and VUV excitation luminescence spectroscopy techniques. Nanocrystalline YVO4:Eu samples – both as-prepared and YF3 core-shelled – have been synthesized by means of a microwave-assisted synthesis in ionic liquids, which allows to obtain 10–12 nm nanoparticles with high crystallinity. The results show noticeable differences between bulk and nanocrystalline YVO4:Eu in photoluminescence experimental data, which explains by influence of the nanocrystal surface. A YF3 core-shell layer around YVO4:Eu nanoparticles partially recovers the intensity of the E…

010302 applied physicsMaterials sciencePhotoluminescencePassivationAnalytical chemistryNanoparticle02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesNanocrystalline materialElectronic Optical and Magnetic MaterialsCrystallinityNanocrystal0103 physical sciencesElectrical and Electronic Engineering0210 nano-technologyLuminescenceSpectroscopyPhysica B: Condensed Matter
researchProduct

X-ray diffraction Warren–Averbach mullite analysis in whiteware porcelains: influence of kaolin raw material

2018

ABSTRACTCompositional and microstructural analysis of mullites in porcelain whitewares obtained by the firing of two blends of identical triaxial composition using a kaolin B consisting of ‘higher-crystallinity’ kaolinite or a finer halloysitic kaolin M of lower crystal order was performed. No significant changes in the average Al2O3 contents (near the stoichiometric composition 3:2) of the mullites were observed. Fast and slow firing at the same temperature using B or M kaolin yielded different mullite contents. The Warren–Averbach method showed increase of the D110 mullite crystallite size and crystallite size distributions with small shifts to greater values with increasing firing temper…

010302 applied physicsMaterials scienceStoichiometric compositionMullite02 engineering and technologyRaw material021001 nanoscience & nanotechnology01 natural sciencesCrystalGeochemistry and Petrology0103 physical sciencesX-ray crystallographyKaoliniteCrystalliteThickeningComposite material0210 nano-technologyClay Minerals
researchProduct

Correlation between in situ structural and optical characterization of the semiconductor-to-metal phase transition of VO2 thin films on sapphire

2020

A detailed structural investigation of the semiconductor-to-metal transition (SMT) in vanadium dioxide thin films deposited on sapphire substrates by pulsed laser deposition was performed by in situ temperature-dependent X-ray diffraction (XRD) measurements. The structural results are correlated with those of infrared radiometry measurements in the SWIR (2.5-5 μm) and LWIR (8-10.6 μm) spectral ranges. The main results indicate a good agreement between XRD and optical analysis, therefore demonstrating that the structural transition from monoclinic to tetragonal phases is the dominating mechanism for controlling the global properties of the SMT transition. The picture that emerges is a SMT tr…

010302 applied physicsPhase transitionMaterials scienceTransition temperatureAnalytical chemistryPulsed laser depositionphase change material; VO202 engineering and technologyVO2 thin films021001 nanoscience & nanotechnology01 natural sciencesSettore ING-INF/01 - ElettronicaPulsed laser depositionTetragonal crystal systemVO20103 physical sciencesSapphireThermal hysteresisGeneral Materials ScienceCrystalliteThin film0210 nano-technologyphase change materialMonoclinic crystal systemSemiconductor-to-metal (SMT) transition
researchProduct

Control flow strategy in a receiver coil for nuclear magnetic resonance for imaging

2020

A mathematical discussion is introduced to describe the receiver coil characterizing a nuclear magnetic resonance for imaging, starting from a general shape of the conductor. A set of different inductance calculations have been introduced, varying the shape of the conductor. The inductance calculation led to a general expression of the magnetic field of a single coil characterized by a rectangular shape. A dynamic model of the receiver coil has been developed to represent the natural frequencies that characterize the operational bandwidth. A nonstationary control strategy is implemented to make a real time changing of the operational bandwidth. The frequency response of the coil generates …

010302 applied physicsPhysicsmedicine.diagnostic_testMechanical EngineeringAerospace EngineeringMagnetic resonance imaging01 natural sciencesTransfer function030218 nuclear medicine & medical imagingMagnetic fieldConductorInductanceReceiver coil03 medical and health sciences0302 clinical medicineNuclear magnetic resonanceControl flowMechanics of Materials0103 physical sciencesAutomotive EngineeringmedicineGeneral Materials ScienceJournal of Vibration and Control
researchProduct