Search results for "low frequency"
showing 10 items of 97 documents
Transformation Algorithm of Dielectric Response in Time-Frequency Domain
2014
Published version of an article in the journal: Mathematical Problems in Engineering. Also available from the publisher at: http://dx.doi.org/10.1155/2014/547105 A transformation algorithm of dielectric response from time domain to frequency domain is presented. In order to shorten measuring time of low or ultralow frequency dielectric response characteristics, the transformation algorithm is used in this paper to transform the time domain relaxation current to frequency domain current for calculating the low frequency dielectric dissipation factor. In addition, it is shown from comparing the calculation results with actual test data that there is a coincidence for both results over a wide …
Reduction of low-frequency 1/f noise in Al-AlOx-Al tunnel junctions by thermal annealing
2010
We report that annealing Al-AlOx-Al tunnel junctions in a vacuum chamber at temperature of 400C reduces the characteristic 1/f noise in the junctions, in some cases by an order of magnitude. Both ultra high vacuum and high vacuum fabricated samples demonstrated a significant reduction in the 1/f noise level. Temperature dependence of the noise was studied between 4.2 and 340 Kelvin, with a linear dependence below 100 K, but a faster increase above. The results are consistent with a model where the density of charge trapping two level-systems within the tunneling barrier is reduced by the annealing process.
Electrical Transport Properties of Lead−Free (Na0.5Bi0.5)1-xBaxZr0.04Ti0.96O3Ceramics (x = 0.06, 0.085, 0.1)
2011
Lead-free ceramics (Na0.5Bi0.5)1-xBaxZr0.04Ti0.96O3 were prepared by solid phase hot pressing sintering process. Density values of obtained samples are higher than 95% of the theoretical ones. Samples with x = 0.06, 0.085 and 0.1 were investigated in the present work. For these samples both ac and dc electric conductivity were studied. A low frequency (100 Hz-100 kHz) ac conductivity obeys the power law, characteristic for disordered materials. The dc conductivity has a thermally activated character. A barrier hopping model is found to explain the mechanism of charge transport in these materials. The (Na0.5Bi0.5)1-xBaxZr0.04Ti0.96O3 system is expected to be a new and promising candidate for…
Electrical and optical low frequency noises in multimodal vertical cavity surface emitting lasers
2006
Experimental investigations of the low frequency noise of multimode 780 nm vertical cavity surface emitting lasers are reported. Electrical noise, optical noise and their correlation have been measured in the frequency range 1 Hz–95 kHz. The results show that the main contribution to the electrical noise is located in the distributed Bragg reflector layers of the laser. The optical power and pump current noise sources are strongly correlated below and around the threshold, while are weakly correlated above threshold. It is argued that the noise in the optical power is due to both free injection carrier noise and optical gain fluctuations.
Sensor Applications Of Optical Fibre Resonant Rings Based On Polarisation Sensitive Couplers
1989
Optical fibre resonant rings based on polarisation sensitive couplers give rise to a set of new resonant configurations. Two of them exhibit interesting sensor applications since small changes of the polarisation state produce large effects on the output, due to the resonant characteristics of the system. The sensor arrangements proposed have the advantage of requiring no drift compensation of the optical fibre interferometer against environmental fluctuations, since the parameters used to determine the measurand are the finesse and the visibility but not a phase change. Thus, the system can be used to sense low frequency measurands. Among the particular sensor applications that can be sugg…
Numerical study of surface waves generated by low frequency EM field for silicon refinement
2018
One of the most perspective methods to produce solar grade silicon is refinement via metallurgical route. The most critical part of this route is refinement from boron and phosphorus due to high segregation coefficients. One possible approach to remove boron is use of reactive gas on surface of silicon melt. An approach of creating surface waves on silicon melt's surface is proposed in order to enlarge its area and accelerate removal of boron via chemical reactions. This paper focuses on numerical analysis of surface wave creation by means of low frequency magnetic field. Frequency of magnetic field and its amplitude significantly change the character of surface waves with most changes occu…
Extremely low frequency magnetic fields in residences in Germany. Distribution of measurements, comparison of two methods for assessing exposure, and…
2001
We examined the results of 1,835 magnetic field measurements in German residences conducted between November 1997 and September 1999. The measurements were part of an epidemiological study on the relationship between magnetic fields and childhood leukemia. We performed a fixed-location measurement of the magnetic field at 50 Hz and 16 2/3 Hz (frequency of the German railway system) over 24 h in the child's bedroom in the residence of each study participant. In addition, we conducted a second 24 h-measurement in the living room at 50 Hz, and spot measurements while walking through all rooms of the respective dwelling. Median 50 Hz magnetic fields above 0.2 muT were found to be infrequent in …
Characterization of MEMS accelerometer self-noise by means of PSD and Allan Variance analysis
2017
In this paper, we have studied the sources of error of a low-cost 3-axis MEMS accelerometer by means of Power Spectral Density and Allan Variance techniques. These techniques were applied to the signals acquired from ten identical devices to characterize the variability of the sensor produced by the same manufacturer. Our analysis showed as identically produced accelerometer have somehow variable behavior in particular at low frequency. It is therefore of paramount importance before their use in Inertial Navigation or Earthquakes Monitoring System, a complete characterization of each single sensors.
Study of high spins in $^{173}$Os
1991
High-spin states in 173Os have been studied by γγ-coincidence measurements following the 146Nd(32S, 5n)173Os reaction. Additional information has also been extracted from the reaction 144Sm(32S, 2pn)173Os. Four main sequencies have been identified as the two signature branches of the bands built on the [642]52+ and [523]52− Nilsson states. The band features have been analysed within the framework of the cranked shell model. The positive-parity band provides evidence for a v(i132)2 crossing at low frequency and a π(h112)2 and/or π(h92)2 cross In the negative-parity band the upbend starts at relatively low frequency indicating, presumably, an early v(i132)2 alignment. There is evidence for an…
Pressure dependence of the low-frequency dielectric constant of KNbO_3
1997
The effect of pressure on the low-frequency dielectric constant, $\epsilon_0$, of single crystals of KNbO_3 is investigated by means of capacitance measurements. The dielectric constant increases with pressure up to 22.5 kbar, where it exhibits a large value ($\epsilon_0$ = 5000), and then decreases. This change in its behaviour is related to a phase transition induced by pressure. On decompression, the samples do not revert back to the ambient pressure phase.