Search results for "modi"
showing 10 items of 2178 documents
CCDC 1429014: Experimental Crystal Structure Determination
2016
Related Article: Balasubramaniam Arul Prakasam, Anssi Peuronen, Manu Lahtinen, Manickavachagam Muruganandham, Erkki Kolehmainen, Esa Haapaniemi, Mika Sillanpää|2017|Polyhedron|123|453|doi:10.1016/j.poly.2016.11.027
The Greenland shark Somniosus microcephalus—Hemoglobins and ligand-binding properties
2017
A large amount of data is currently available on the adaptive mechanisms of polar bony fish hemoglobins, but structural information on those of cartilaginous species is scarce. This study presents the first characterisation of the hemoglobin system of one of the longest-living vertebrate species (392 +/- 120 years), the Arctic shark Somniosus microcephalus. Three major hemoglobins are found in its red blood cells and are made of two copies of the same a globin combined with two copies of three very similar beta subunits. The three hemoglobins show very similar oxygenation and carbonylation properties, which are unaffected by urea, a very important compound in marine elasmobranch physiology.…
Atomic layer deposition of aluminum oxide on modified steel substrates
2016
Abstract Al 2 O 3 thin films were grown by atomic layer deposition to thicknesses ranging from 10 to 90 nm on flexible steel substrates at 300 °C using Al(CH 3 ) 3 and H 2 O as precursors. The films grown to thicknesses 9–90 nm covered the rough steel surfaces uniformly, allowing reliable evaluation of their dielectric permittivity and electrical current densities with appreciable contact yield. Mechanical behavior of the coatings was evaluated by nanoindentation. The maximum hardness values of the Al 2 O 3 films on steel reached 12 GPa and the elastic modulus exceeded 280 GPa.
Correlation between surface engineering and deformation response of some natural polymer fibrous systems
2018
Surfaces of bamboo derived cellulosic fibrous systems have been modified by air-plasma treatment. Their deformational response was studied to establish the relationship between their three-dimensional profile and permanent deformation as a measure of their comfort properties since the fibrous system made of natural polymer comes into contact with the skin. The composite should have a permanent deformation close to zero, in order to be, in terms of dimensions, as stable as possible. By analyzing the area of 1 cm2 using a Universal Surface Tester (UST), different 3D surface diagrams and surface roughness values were obtained. This type of surface investigation provides relevant information a…
9,10-Phenanthrenedione as Visible-Light Photoredox Catalyst: A Green Methodology for the Functionalization of 3,4-Dihydro-1,4-Benzoxazin-2- Ones thro…
2018
A visible-light photoredox functionalization of 3,4-dihydro-1,4-benzoxazin-2-ones through a Friedel-Crafts reaction with indoles using an inexpensive organophotoredox catalyst is described. The reaction uses a dual catalytic system that is formed by a photocatalyst simple and cheap, 9,10-phenanthrenedione, and a Lewis acid, Zn(OTf)2. 5W white LEDs are used as visible-light source and oxygen from air as a terminal oxidant, obtaining the corresponding products with good yields. The reaction can be extended to other electron-rich arenes. Our methodology represents one of the most valuable and sustainable approach for the functionalization of 3,4-dihydro-1,4-benzoxazin-2-ones, as compared to th…
Direct Difluorination–Hydroxylation, Trifluorination, and C(sp2)–H Fluorination of Enamides
2018
A direct double functionalization involving both difluorination and hydroxylation of enamides is reported. With the appropriate combination of an electrophilic fluorinating reagent and H2O, the most convenient and ecofriendly hydroxylating agent, the preparation of 3-(difluoroalkyl)-3-hydroxyisoindolin-1-ones was achieved under basic or Bronsted acidic conditions. Suitable conditions for trifluorination as well as C(sp2)–H fluorination were also identified. Subsequent asymmetric functionalization of the obtained gem-difluorinated products has also been demonstrated.
Copper-Catalyzed Aerobic Oxidative Alkynylation of 3,4-Dihydroquinoxalin-2-ones
2019
Herein, we described a ligand-free copper-catalyzed aerobic oxidative functionalization of 3,4-dihydroquinoxalin-2(1H)-ones with terminal alkynes using visible-light and oxygen as terminal oxidant to give 3-ethynyl-3,4-dihydroquinoxalin-2(1H)-one, cyclic propargylic amines, in moderate to good yields. Moreover, we demonstrate the versatility of the 3-ethynyl-3,4-dihydroquinoxalin-2(1H)-ones obtained by preparing several 3,4-dihydroquinoxalin-2-one derivatives.
Multispectral high resolution sensor fusion for smoothing and gap-filling in the cloud
2020
Remote sensing optical sensors onboard operational satellites cannot have high spectral, spatial and temporal resolutions simultaneously. In addition, clouds and aerosols can adversely affect the signal contaminating the land surface observations. We present a HIghly Scalable Temporal Adaptive Reflectance Fusion Model (HISTARFM) algorithm to combine multispectral images of different sensors to reduce noise and produce monthly gap free high resolution (30 m) observations over land. Our approach uses images from the Landsat (30 m spatial resolution and 16 day revisit cycle) and the MODIS missions, both from Terra and Aqua platforms (500 m spatial resolution and daily revisit cycle). We implem…
Comparison and Evaluation of the TES and ANEM Algorithms for Land Surface Temperature and Emissivity Separation over the Area of Valencia, Spain
2017
Land Surface temperature (LST) is a key magnitude for numerous studies, especially for climatology and assessment of energy fluxes between surface and atmosphere. Retrieval of accurate LST requires a good characterization of surface emissivity. Both quantities are coupled in a single radiance measurement; for this reason, for N spectral bands available in a remote sensor, there will always be N + 1 unknowns. To solve the indeterminacy, temperature-emissivity separation methods have been proposed, among which the Temperature Emissivity Separation (TES) algorithm is one of the most widely used. The Adjusted Normalized Emissivity Method (ANEM) was proposed as a modification of the Normalized E…
Landsat and Local Land Surface Temperatures in a Heterogeneous Terrain Compared to MODIS Values
2016
Land Surface Temperature (LST) as provided by remote sensing onboard satellites is a key parameter for a number of applications in Earth System studies, such as numerical modelling or regional estimation of surface energy and water fluxes. In the case of Moderate Resolution Imaging Spectroradiometer (MODIS) onboard Terra or Aqua, pixels have resolutions near 1 km 2 , LST values being an average of the real subpixel variability of LST, which can be significant for heterogeneous terrain. Here, we use Landsat 7 LST decametre-scale fields to evaluate the temporal and spatial variability at the kilometre scale and compare the resulting average values to those provided by MODIS for the same obser…