Search results for "pine"
showing 10 items of 2022 documents
Experimental set up for determining the temperature-oxygen partial pressure conditions during synthesis of spinel oxide nanoparticles
1997
Abstract Nanometric spinel oxide powders, Fe 3− x M x O 4 , where M is a transition element, have been synthetized by soft chemistry. This method generally leads to a non-stoichiometric phase, Fe 3− x M x O 4+δ where δ is the deviation from stoichiometry so that further annealing at low temperatures around 450°C and low oxygen partial pressure around 10 −25 Pa given by N 2 /H 2 /H 2 O gas mixtures is required: this enables a stoichiometric compound to be obtained and a nanometric size to be maintained. The complete set up consisting of a gas mixer, a thermogravimetric apparatus and a preparative furnace is described. Some results concerning the conditions of temperature and oxygen partial p…
Room Temperature Magnetism in Layered Double Hydroxides due to Magnetic Nanoparticles
2013
Some recent reports claiming room temperature spontaneous magnetization in layered double hydroxides (LDHs) have been published; however, the reported materials cause serious concern as to whether this cooperative magnetic behavior comes from extrinsic sources, such as spinel iron oxide nanoparticles. The syntheses of crystalline Fe(3+)-based LDHs with and without impurities have been developed, highlighting the care that must be taken during the synthetic process in order to avoid misidentification of magnetic LDHs.
Surface composition analysis during the oxidation of ferrites: A necessity
1998
The cationic composition of a titanium ferrite (Fe 2.5 Ti 0.5 O 4 ) has been followed by XPS during its oxidation in cation deficient phases (without crystallographic transformation) in order to reveal a dynamic segregation phenomenon. Indeed, during this oxidation, an important modification of the chemical composition of the first layers of the material has been revealed: below 350 °C, the titanium ferrites surface becomes richer in iron and poorer in titanium. But, if the reaction is extended above 400 °C, some titanium can move to the surface. This phenomenon has been interpreted on the basis of the differences of mobility of the different ions which are present in the material. Finally,…
Synthesis and radiosynthesis of N5-[18F]fluoroethyl-Pirenzepine and its metabolite N5-[18F]fluoroethyl-LS 75
2009
The well established M1 selective muscarinergic antagonist Pirenzepine 11-[2-(4-methyl-piperazin-1-yl)-acetyl]-5,11-dihydro-benzo[e]pyrido[3,2-b][1,4]diazepin-6-one (1) exhibits an unusual behaviour in vivo, which cannot be explained with M1 antagonism exclusively. One of the aspects discussed is a specific interaction with poly ADP-ribose polymerase (PARP-1). 1 undergoes metabolism to form LS 75 5,11-dihydro-benzo[e]pyrido[3,2-b][1,4]diazepin-6-one (2). In order to study deviations in Pirenzepine efficacy from pure M1 binding in vivo using PET, appropriate positron emitter labelled analogues of 1 and 2 were synthesised. Non-radioactive reference compounds 3 and 4 were tested for PARP-1 inh…
An ESCA and Mössbauer study of the oxide layer formed on steel in water containing chromate and chloride ions
1983
Abstract The formation of oxidic layers on steel in chromate solutions was studied by photo-electron and Mossbauer spectroscopy. To simulate more aggressive realistic systems, some chloride ions were added to the solution. The layers formed under these conditions were found to be thicker by an order of magnitude than those formed in the absence of chloride ions. They probably consist of ferric and chromic oxides of the corundum type (Fe 1−2 Cr x ) 2 O 3 , with the Cr : Fe ratio being depth dependent. The oxide layer is subdivided into small regions behaving superparamagnetically. This heterogeneity of the layer is ascribed to the attack by the chloride ions. The structure of the oxides foun…
Volatile compounds of flowers and leaves of Sideritis italica (Miller)Greuter et Burdet (Lamiaceae), a plant used as mountain tea
2010
Sideritis italica (Miller) Greuter et Burdet (Lamiaceae), widely used in ethnopharmacological medicine, occurs in Southern Italy and Sicily. The phytochemical composition of the essential oils of S. italica flowers and leaves, harvested in Piano Battaglia (Sicily), was analysed by GC and GC-MS. Of the 51 compounds, 43 in the oil from flowers and 29 in the oil from leaves were identified. Kaur-15-ene (20.0%) was recognised as the main constituent of the oil from flowers, together with beta-cubebene (12.1%), beta-pinene (8.5%), (Z)-nuciferol (6.5%), tricyclene (4.5%) and alpha-bisabolol (4.0%). In the oil from leaves, p-methoxyacetophenone (26.0%) prevailed, as did hexadecanoic acid (21.3%), …
Spectrophotometric determination of adrenaline with an oxidative column in a FIA assembly
1990
Abstract A single channel FIA assembly is proposed for the spectrophotometric determination of adrenaline, the aqueous sample solution is directly injected into the carrier stream leading the sample through a manganese dioxide column at 80°C, and on to the spectrophotometer flow-cell. The calibration graph is linear up to 17 ppm of adrenaline. The influence of other substances has been studied and the method has been applied to the determination of adrenaline in a pharmaceutical formulation.
Photochemical derivatization and fluorimetric determination of reserpine in a flow-injection assembly
1991
Abstract The fluorimetric flow-injection determination of reserpine was achieved with the drug being derivatized on-line by photoreaction. PTFE tubing was helically coiled around a germicide lamp located between the injection valve and detector. Two analytical procedures are proposed using either dilute acetic acid or pure methanol as the carrier stream. The influence of foreign compounds was studied and the method was applied to the determination of reserpine in pharmaceutical formulations.
Spectrophotometric Determination of Hydralazine with 2-Hydroxy-1-naphthaldehyde in Pharmaceuticals
1991
Abstract A new extraction-spectrophotometric method for the determination of hydralazine, based on its reaction with 2-hydroxy-1-naphthaldehyde at 25 °C, is described. The calibration curve was linear between 0.4 and 6 mg/mL of hydralazine. The molar absorbtivity of the product at 408 nm is 40 900 L · mol − 1 · cm − 1 . The method described was applied to the analysis of hydralazine in pharmaceutical preparations containing reserpine, hydrochlorothiazide, bendrofluorthiazine, propranolol, and other substances. The agreement with the U.S.P. XXI method was satisfactory for tablets and injections, but not for pellets.
Atropine-resistant effects of the muscarinic agonists McN-A-343 and AHR 602 on cardiac performance and the release of noradrenaline from sympathetic …
1974
Abstract 1 The effects of 4-(m-chlorophenylcarbamoyloxy)-2-butynyltrimethylammonium chloride (McN-A-343) and N-benzyl-3-pyrrolidyl acetate methobromide (AHR 602) on cardiac performance and noradrenaline release from terminal sympathetic fibres were measured in isolated perfused hearts of rabbits. 2 In the presence of sufficient atropine to block muscarinic receptors, high concentrations of McN-A-343 and AHR 602 caused no cardiac stimulation and there was no increase in the resting output of noradrenaline into the perfusates. 3 McN-A-343 and AHR 602 increased both the mechanical responses and the transmitter overflow evoked by electrical stimulation of the sympathetic nerves (SNS) but inhibi…