Search results for "purity"
showing 10 items of 356 documents
Variable-charge method applied to study coupled grain boundary migration in the presence of oxygen
2009
International audience; One of the important differences between simulation and experiments in grain boundary (GB)-dominated metallic structures is the lack of impurities such as oxygen in computational samples. A modified variable-charge method [Elsener A, Politano O, Derlet PM, Van Swygenhoven H. Modell Simul Mater Sci Eng 2008;16:025006] based on the Streitz and Mintmire approach [Streitz FH, Mintmire JW. Phys Rev B 1994;50:11996] is used to study coupled GB motion in an Al bicrystal with a [1 1 2] symmetrical tilt GB in the presence of substitutional O, and compared with the stick–slip process identified by Cahn and Mishin [Cahn JW, Mishin Y, Suzuki A. Acta Mater 2006;54:4953]. It is found…
XUV diagnostic to monitor H-like emission from B, C, N, and O for the W7-X stellarator
2019
The “C/O Monitor” system for the Wendelstein 7-X (W7-X) stellarator is a dedicated spectrometer with high throughput and high time resolution (order of 1 ms) for fast monitoring of content of low-Z impurities in the plasma. The observed spectral lines are fixed to Lyman-α lines of H-like atoms of carbon (3.4 nm), oxygen (1.9 nm), nitrogen (2.5 nm), and boron (4.9 nm). The quality of the wall condition will be monitored by the measurements of oxygen being released from the walls during the experiments. The strong presence of carbon is an indication for enhanced plasma-wall interaction or overload of plasma facing components. The presence of nitrogen (together with oxygen) may indicate a poss…
Thermal stability of magnetic characteristics of Co/Ag/Fe and Co/Ag/Fe20Ni80 spin-valve structures
2017
Abstract We investigated the thermal stability of magnetic characteristics of Co/Ag/Fe and Co/Ag/Fe 20 Ni 80 spin-valve structures. Thin film systems were obtained with the help of sputtering method. For the first type of systems two particular thicknesses ( d ML = 3 and 20 nm) and different disposition of magnetic layers (ML) were used. For the second type different thickness of Ag ( d NML ) spacer layer was used. The research of the crystal structure was performed with the transmission electron microscope. The results demonstrate that every investigated as-deposited sample does not include solid solutions, intermetallic compounds or impurities. It has been found that among the spin-valve…
Atomic Layer Deposition of LiF Thin Films from Lithd, Mg(thd)2, and TiF4 Precursors
2013
Lithium fluoride is an interesting material because of its low refractive index and large band gap. Previously LiF thin films have been deposited mostly by physical methods. In this study a new way of depositing thin films of LiF using atomic layer deposition (ALD) is presented. Mg(thd)2, TiF4 and Lithd were used as precursors, and they produced crystalline LiF at a temperature range of 300–350 °C. The films were studied by UV–vis spectrometry, field emission scanning electron microscopy (FESEM), X-ray diffraction (XRD), atomic force microscopy (AFM), time-of-flight elastic recoil detection analysis (ToF-ERDA), and energy dispersive X-ray spectroscopy (EDX). In addition, film adhesion was t…
Ab initio modelling of the Y, O, and Ti solute interaction in fcc-Fe matrix
2018
Abstract Strengthening of the ODS steels by Y2O3 precipitates permits to increase their operation temperature and radiation resistance, which is important in construction materials for future fusion and advanced fission reactors. Both size and spatial distribution of oxide particles significantly affect mechanical properties and radiation resistance of ODS steels. Addition of the Ti species (present also as a natural impurity atoms in iron lattice) in the particles of Y2O3 powder before their mechanical alloying leads to the formation of YTiO3, Y2TiO5, and Y2Ti2O7 nanoparticles in ODS steels. Modelling of these nanoparticle formation needs detailed knowledge of the energetic interactions be…
Dielectric behaviour of BaTi1-xZrxO3ceramics obtained by means of a solid state and mechanochemical synthesis
2016
ABSTRACTIn this study the comparison of dielectric behaviour of BaTi1-xZrxO3 (BTZx) ceramic samples prepared by means of a solid state and mechanochemical synthesis was presented. A single phase of perovskite structure was identified in the samples at room temperature. No significant impurities were detected in an EDS spectrum and the samples had a good stoichiometric ratio. The morphology of the investigated samples was characterized by a scanning electron microscopy (SEM). The investigation of dielectric properties of the BTZx samples within the temperature range from 140 K to 600 K was performed by means of a dielectric spectroscopy method at the frequency ranging from 0.1 Hz to 10 MHz. …
Determination of impurity distributions in ingots of solar grade silicon by neutron activation analysis
2017
AbstractIn a series of crystallization experiments, the directional solidification of silicon was investigated as a low cost path for the production of silicon wafers for solar cells. Instrumental neutron activation analysis was employed to measure the influence of different crystallization parameters on the distribution of 3d-metal impurities of the produced ingots. A theoretical model describing the involved diffusion and segregation processes during the solidification and cooling of the ingots could be verified by the experimental results. By successive etching of the samples after the irradiation, it could be shown that a layer of at least 60 μm of the samples has to be removed to get r…
On nature of the transient IR-absorption STE-like bands at 0.15–0.36eV in alkali halides
2001
New evidence is given that two classes (A and B) of the transient IR-absorption bands: (A) with max. at 0.15-0.36 eV (in NaCl : I, NaBr, NaI, KCl : I, KBr : I, RbCl : I, RbBr : I), due to on-centre self-trapped exciton and (B) with max. at 0.27-0.36 eV (in NaCI, KCl, KBr, RbCl), due to shallow trapped electrons or bound polarons, are caused by the same defect-shallow trapped electron (e-) at the substitutional (cation: c-site) alkali impurity cation (M + ): [M - ] 0 c e - . The A- and B-class IR bands have the same location, similar shape, half-width (exactly coincide for KCl : I and KCl at 80 or 10 K with the same vibration structure). It is established that the same Mollwo-Ivey plot curve…
Optical properties of natural topaz
2013
The results of investigation of infrared, Raman and UV-Visible absorption spectra of natural topaz crystals from Ukraine before and after fast neutron irradiation are presented. We assume that the ~ 620 nm band in topaz crystals is associated with the presence of Cr 3+ , Fe 2+ and Mn 2+ impurities. The broad band with maxima at 650 cm -1 observed in Raman spectra for topaz irradiated by fast neutrons may be connected with lattice disorder. Exchange interaction between radiation defect and impurity ions during neutron irradiation leads to appearance of additional absorption band in UV-VIS spectra and bands broadening in infrared and Raman spectra of investigated crystals.
OH-related Infrared Absorption Bands in Oxide Glasses
2005
We report the infrared activity, in the spectral region of the OH stretching modes, of different composite silicate glasses whose chemical composition is established by X-ray fluorescence measurements. The analysis of the absorption line profiles is made in terms of different spectral contributions, Gaussian in shape. The comparison with analogous spectra obtained in vitreous silica samples with impurity concentrations < 100 part per million moles is evidence of the effects of the different oxides on the vibrational properties of the OH groups. In particular, for oxide glasses a red shift of the composite band at about 3670 cm(-1), assigned to the OH stretching modes of free Si-OH groups an…