Search results for "sulphate"

Changes in Cement Paste and Mortar Fluidity after mixing induced by PCP: A parametric study

2006

International audience; The interaction mechanism between polycarboxylate-type superplasticizer (PCP) and cement hydration is not fully understood and incompatibilities between concrete and additive are sometimes observed. In some cases, the fluidity tends to increase (“overfluidification”) few minutes after mixing. This is a problem because the overfluidification leds to bleeding of the concrete which could be critical on job site. Our study consisted first in highlighting the phenomenon of “over-fluidification” by slump flow tests on mortar. Next, the time evolution of the rheological behaviour of cement pastes in the presence of PCP was analysed thanks to a rheometry protocol in order to…

In situ analysis of suspensions of calcium silicate hydrate : application to the study of ionics interactions at the surface of the particules

2014

This project aims to study the interactions between calcium silicate hydrate (C-S-H) and different anions (chlorides, bromides, nitrates and sulfates) in order to build a thermodynamic model and then be predictable. The simplified system CaO-SiO2-H2O is studied by synthesizing C-S-H suspensions and mixing them with different kind of salts (calcium salt or alkali salt). The influence of the temperature and the presence of aluminum in the structure of the C-S-H is also examined.A classical way to investigate this kind of system is to separate the liquid phase from the solid phase in order to analyze them separately. Nevertheless, this step has a large influence on the system, and the experime…

Influence of sodium lauryl sulphate on the in vitro percutaneous absorption of compounds with different lipophilicity

1997

Abstract The effects of sodium lauryl sulphate (SLS) at different concentrations on the “in vitro” percutaneous absorption of a number of compounds (5-fluorouracil, antipyrine, pentoxifylline, salicylamide, 4-ethylaniline, 4-n-butylaniline and indomethacin) with a wide range of lipophilicity values (log POCT from −0.95 to 4.42) through rat skin were analysed. After pretreatment of the skin with SLS (1% and 5%, w/w) the permeability coefficients increased only for compounds having a log POCT

Degradation study of XVIII century graffiti on the walls of Chiaramonte Palace (Palermo, Italy)

2010

A systematic investigation of the original materials and the degradation phenomena induced by soluble salts on the wall matrix and on the graffiti of the Inquisition jails of Chiaramonte Palace in Palermo (Italy) was carried out. Built in the XIV century, Chiaramonte Palace was used as Inquisition court during the XV–XVI centuries. The ancient graffiti, recently discovered, represent a unique historical witness of the prisoners that lived during that terrible period. In order to study the nature, the amount and the distribution of the salts in the masonry, stone materials sampled at different depth from the wall matrix and saline efflorescences were analysed. Different physical techniques w…

Components of Connective Tissue

1975

Interaction of diazepam with surfactants. Spectrophotometric and spectrofluorometric study

1986

Abstract The interaction of diazepam with non-ionic, anionic and cationic surfactants has been studied spectrophotometrically and fluorometrically. It has been verified that the absorption spectrum of diazepam is not modified in micellar medium. However, a dramatic five-fold increase in fluorescence sensitivity is observed in the presence of sodium lauryl sulphate (SDS). The experimental conditions, temperature, pH and surfactant concentration have been optimized to improve the fluorometric determination of diazepam and a detection limit of 0,04 ppmhas been obtained.

Treatment of a submerged anaerobic membrane bioreactor (SAnMBR) effluent by an activated sludge system: the role of sulphide and thiosulphate in the …

2014

This work studies the use of a well-known and spread activated sludge system (UCT configuration) to treat the effluent of a submerged anaerobic membrane bioreactor (SAnMBR) treating domestic waste-water. Ammonia, phosphate, dissolved methane and sulphide concentrations in the SAnMBR effluent were around 55 mg NH4-N L-1, 7 mg PO4-P L-1, 30 mg non-methane biodegradable COD L-1, and 105 mg S2- L-1 respectively. The results showed a nitrification inhibition caused by the presence of sulphur compounds at any of the solids retention time (SRT) studied (15,20 and 25 days). This inhibition could be overcome increasing the hydraulic retention time (HRT) from 13 to 26 h. Among the sulphur compounds, …

Methane recovery efficiency in a submerged anaerobic membrane bioreactor (SAnMBR) treating sulphate-rich urban wastewater: Evaluation of methane loss…

2012

The present paper presents a submerged anaerobic membrane bioreactor (SAnMBR) as a sustainable approach for urban wastewater treatment at 33 and 20 C, since greenhouse gas emissions are reduced and energy recovery is enhanced. Compared to other anaerobic systems, such as UASB reactors, the membrane technology allows the use of biogas-assisted mixing which enhances the methane stripping from the liquid phase bulk. The methane saturation index obtained for the whole period (1.00 ± 0.04) evidenced that the equilibrium condition was reached and the methane loss with the effluent was reduced. The methane recovery efficiency obtained at 20 C (53.6%) was slightly lower than at 33 C (57.4%) due to …

Sulphate Removal from Water by Carbon Residue from Biomass Gasification: Effect of Chemical Modification Methods on Sulphate Removal Efficiency

2016

Sulphate removal from mine water is a problem because traditional chemical precipitation does not remove all sulphates. In addition, it creates lime sediment as a secondary waste. Therefore, an inexpensive and environmental-friendly sulphate removal method is needed in addition to precipitation. In this study, carbon residues from a wood gasification process were repurposed as precursors to a suitable sorbent for SO42- ion removal. The raw material was modified using ZnCl2, BaCl2, CaCl2, FeCl3, or FeCl2. Carbon residues modified with FeCl3 were selected for further consideration because the removal efficiency toward sulphate was the highest. Batch sorption experiments were performed to eval…

Water Depollution by Advanced Oxidation Technologies

2020

This chapter deals with water treatments by advanced oxidation processes (AOPs) based on chemical and photochemical reactions. The most used processes are described, and for each of them, the main reaction mechanisms, principles, advantages, drawbacks, performances and formation of by-products, coupled with technologies and their applications to waters and wastewater depollution, have been analysed, supporting the main results of studies published in the pertinent literature.