Search results for "superlattice"
showing 10 items of 83 documents
Photoemission of spinpolarized electrons from strained GaAsP
1996
Strained layer GaAs.95P.05 photo cathodes are presented, which emit electron beams spinpolarized to a degree of P = 75% typically. Quantum yields around QE = 0.4% are observed routinely. The figure of merit P2 × QE = 2.3 × 10−3 is comparable to that of the best strained layer cathodes reported in literature. The optimum wavelength of irradiating light around 830 nm is in convenient reach of Ti:sapphire lasers or diode lasers respectively. The cathodes are produced using MOCVD-techniques. A GaAs.55P.45-GaAs.85P.15 superlattice structure prevents the migration of dislocations from the substrate and bottom layers to the strained overlayer. The surface is protected by an arsenic layer so that n…
2D photonic defect layers in 3D inverted opals on Si platforms
2006
Dielectric spheres synthesised for the fabrication of self-organized photonic crystals such as opals offer large opportunities for the design of novel nanophotonic devices. In this paper, we show a hexagonal superlattice monolayer of dielectric spheres inscribed on a 3D colloidal photonic crystal by e-beam lithography. The crystal is produced by a variation of the vertical drawing deposition method assisted by an acoustic field. The structures were chosen after simulations showed that a hexagonal super-lattice monolayer in air exhibits an even photonic band gap below the light cone if the refractive index of the spheres is higher than 1.93.
Interfaces as design tools for the InAs/GaSb/InSb short-period superlattice for mid-infrared emission
2011
We use a standard 8 × 8 envelope-function approximation (EFA) formalism taking into account the effect of anisotropic and other interface (IF) interactions to investigate the electronic and optical properties of short-period superlattice laser structures (InAs/GaSb/InSb)×N grown on a GaSb substrate. We find that the band gaps numerically calculated at different temperatures give a good fitting with the experimental data confirming the model used. The calculated modal gain demonstrates that it is possible to achieve lasing operation at room temperature for N > 12 and for a reasonable total optical loss αt = 25 cm−1. Therefore, the 8 × 8 EFA formalism with IF design serves as a tool to model…
Calorimetric Behavior of Phosphatidylcholine/Phosphatidylethanolamine Bilayers is Compatible with the Superlattice Model
2012
Differential scanning calorimetry was used to study the phase behavior of binary lipid bilayers consisting of phosphatidylcholine (PC) and phosphatidylethanolamine (PE) of varying acyl chain length. A two-state transition model was used to resolve the individual transition components, and the two-state transition enthalpy, the relative enthalpy, and the transition temperature of each component were plotted as a function of composition. Intriguingly, abrupt changes in these thermodynamic parameters were observed at or close to many "critical" X(PE) values predicted by the superlattice model proposing that phospholipids with different headgroups tend to adopt regular rather than random latera…
Probing Nanoscale Ferroelectricity by Ultraviolet Raman Spectroscopy
2006
We demonstrated that ultraviolet Raman spectroscopy is an effective technique to measure the transition temperature ( T c ) in ferroelectric ultrathin films and superlattices. We showed that one-unit-cell-thick BaTiO 3 layers in BaTiO 3 /SrTiO 3 superlattices are not only ferroelectric (with T c as high as 250 kelvin) but also polarize the quantum paraelectric SrTiO 3 layers adjacent to them. T c was tuned by ∼500 kelvin by varying the thicknesses of the BaTiO 3 and SrTiO 3 layers, revealing the essential roles of electrical and mechanical boundary conditions for nanoscale ferroelectricity.
Direction-dependent elastic properties and phononic behavior of PMMA/BaTiO 3 nanocomposite thin films
2017
Determination of the anisotropic mechanical properties of nanostructured hybrid films is of great importance to improve fabrication and to enable reliable utility. Here, we employ spontaneous Brillouin light spectroscopy to record the phononic dispersion relation along the two symmetry directions in a supported PMMA (poly(methylmethacrylate))-BaTiO3 hybrid superlattice (SL) with a lattice constant of about 140 nm. Several dispersive elastic modes are resolved for in-plane wave propagation, whereas along the periodicity direction the SL opens a wide propagation stop band for hypersonic phonons and near UV photons both centered at about 280 nm. A thorough theoretical analysis based on the fin…
Surface waves in plasmonic anisotropie media
2012
We investigate the spatial dispersion of hybrid-polarized surface waves excited at the boundary of a semi-infinite layered metal-dielectric nanostructure. We put emphasis in the case that the thickness of a metal layer becomes of the order of the metal skin depth. We demonstrate that the use of the so-called effective medium approximation (EMA) is not justified, in general. For that purpose, we compare the results using the EMA model and numerical simulations based on the finite-element method. We include an analysis of the influence of metallic losses.
Room-temperature efficient light detection by amorphous Ge quantum wells
2013
In this work, ultrathin amorphous Ge films (2 to 30 nm in thickness) embedded in SiO2 layers were grown by magnetron sputtering and employed as proficient light sensitizer in photodetector devices. A noteworthy modification of the visible photon absorption is evidenced due to quantum confinement effects which cause both a blueshift (from 0.8 to 1.8 eV) in the bandgap and an enhancement (up to three times) in the optical oscillator strength of confined carriers. The reported quantum confinement effects have been exploited to enhance light detection by Ge quantum wells, as demonstrated by photodetectors with an internal quantum efficiency of 70%. © 2013 Cosentino et al.
Void superlattice formation in electron irradiated CaF2: Theoretical analysis
2010
Abstract CaF2 is widely adopted as deep-UV window material and thin film optical coating. The void superlattice was observed experimentally under electron irradiation at room temperature. We performed kinetic Monte Carlo (kMC) simulations of the initial stages of the process when short- and intermediate-range order of defects in small Ca colloids and larger interstitial aggregates (F2 gas voids) is created. The kMC model includes fluorine interstitial–vacancy pair creation, defect diffusion, similar defect attraction and dissimilar defect recombination. Special attention is paid to the statistical analysis of the defect aggregate distribution functions under different conditions (dose rate,…
Void lattice formation in electron irradiated CaF 2 : Statistical analysis of experimental data and cellular automata simulations
2016
Abstract Calcium fluoride (CaF2) is an important optical material widely used in both microlithography and deep UV windows. It is known that under certain conditions electron beam irradiation can create therein a superlattice consisting of vacancy clusters (called a void lattice). The goal of this paper is twofold. Firstly, to perform a quantitative analysis of experimental TEM images demonstrating void lattice formation, we developed two distinct image filters. As a result, we can easily calculate vacancy concentration, vacancy cluster distribution function as well as average distances between defect clusters. The results for two suggested filters are similar and demonstrate that experimen…