Search results for "thin film"
showing 10 items of 1200 documents
Preparation and photoactivity of nanostructured anatase, rutile and brookite TiO2 thin films
2006
Photoactive films consisting of pure anatase, brookite or rutile TiO2 were prepared by dip coating from water dispersions obtained by using TiCl4 as the precursor under similar mild experimental conditions
Thermal effects on the growth by metal organic chemical vapour deposition of TiO2 thin films on (100) GaAs substrates
2002
Abstract TiO 2 thin films were deposited on (100) GaAs substrates by LP-MOCVD with deposition temperatures ( T d ) ranking from 450 to 750 °C. The structure of these layers was studied by X-ray diffraction (XRD) and Raman spectroscopy. The growth of the TiO 2 anatase phase was observed for T d T d >600 °C. Finally, X-ray photoelectron spectrometry (XPS) and secondary ion mass spectroscopy (SIMS) experiments showed the presence of small quantities of Ga and As through the whole film thickness, slightly increasing at the surface of the layers. This result was related to the SEM observations and explained by considering the growth conditions.
TiO2 anatase films obtained by direct liquid injection atomic layer deposition at low temperature
2014
International audience; TiO2 thin films were grown by direct liquid injection atomic layer deposition (DLI-ALD) with infrared rapid thermal heating using titanium tetraisopropoxide and water as precursors. This titanium tetraisopropoxide/water process exhibited a growth rate of 0.018 nm/cycle in a self-limited ALD growth mode at 280 degrees C. Scanning electron microscopy and atomic force microscopy analyses have shown a smooth surface with a low roughness. XPS results demonstrated that the films were pure and close to the TiO2 stoichiometric composition in depth. Raman spectroscopy revealed that the films were crystallized to the anatase structure in the as-deposited state at low temperatu…
Preparation and Characterization of Nanostructured Fe-TiO2 Thin Films Produced by Electrophoretic Deposition
2013
Fe-TiO2 thin films have been produced by a sol-electrophoretic deposition method on metallic Ti foil substrates. X-ray diffractograms and Raman spectra confirms the anatase structure of deposited and annealed Fe-TiO2 films. Obtained Fe-TiO2 thin films demonstrate photoactivity under visible light radiation due to the doping with Fe3+ ions. Open circuit potential results shows that increase of the film thickness and surface area improves the photoactivity of Fe-TiO2.
Removal of Surface Oxygen Vacancies Increases Conductance Through TiO(2) Thin Films for Perovskite Solar Cells
2019
[Image: see text] We report that UV–ozone treatment of TiO(2) anatase thin films is an efficient method to increase the conductance through the film by more than 2 orders of magnitude. The increase in conductance is quantified via conductive scanning force microscopy on freshly annealed and UV–ozone-treated TiO(2) anatase thin films on fluorine-doped tin oxide substrates. The increased conductance of TiO(2) anatase thin films results in a 2% increase of the average power conversion efficiency (PCE) of methylammonium lead iodide-based perovskite solar cells. PCE values up to 19.5% for mesoporous solar cells are realized. The additional UV–ozone treatment results in a reduced number of oxygen…
Photocatalytic thin films of TiO2 formed by a sol-gel process using titanium tetraisopropoxide as the precursor
2008
Abstract Thin TiO 2 films were prepared with the dip-coating technique by using sols deriving from titanium tetraisopropoxide. TiO 2 films were formed on glass substrates previously covered by a SiO 2 layer obtained from a tetraethylortosilicate sol. The films, after a thermal treatment at 673 K, mainly consisted of TiO 2 anatase. The samples were characterised by X-ray diffraction, UV–Vis spectroscopy, scanning electron microscopy and atomic force microscopy. The photoactivity of the various films was tested by using as probe reaction the photo-oxidation of 2-propanol in gas-solid regime. The photoreactivity results indicated that the TiO 2 films were efficient for degrading 2-propanol und…
Preparation and photoactivity of electrophoretic TiO2coating film
2012
TiO2 thin films have been obtained by a sol-electrophoretic deposition method on metallic Ti and Pt substrates. X-ray diffraction, Raman spectroscopy and scanning electron microscopy were used to investigate the structure and morphology of plated materials. Annealed TiO2 films mainly are formed in anatase structure with different morphology depending on substrate material. Light induced potential measurements indicate that the morphology substantially have an impact on photoactivity of TiO2 thin films.
EFFECT OF ANNEALING PROCESS ON CIGS FILMS PREPARED BY ONE-STEP ELECTRODEPOSITION
2013
Dimensionless Analysis Of Slurry Photocatalytic Reactors Using Two-Flux And Six-Flux Radiation Absorption-Scattering Models
2007
Photocatalytic oxidation (PCO) over titanium dioxide (TiO2) is a "green" sustainable process for the treatment and purification of water and wastewater. However,the application of PCO for wastewater treatment on an industrial scale is currently hindered by a lack of simple mathematical models that can be readily applied to reactor design. Current models are either too simplistic or too rigorous to be useful in photocatalytic reactor design, scale-up, and optimization. In this paper a simple mathematical model is presented for slurry, annular, photocatalytic reactors that still retains the essential elements of a rigorous approach while providing simple solutions. The model extends the appli…
Effect of molecular geometry and extended conjugation on the performance of hydrogen-bonded semiconductors in organic thin-film field-effect transist…
2021
A general synthetic method has been used for the condensation of the 7-azaindole substructure at both extremes of centrosymmetric fused polyheteroaromatic systems. Four different aromatic spacers (benzene, naphthalene, anthracene and pyrene) that modify the molecular geometry and the π-conjugated surface have proved the ability of 7-azaindole to work as a building block that can control the crystal packing through reciprocal hydrogen bond interactions. Two possible self-assembled columnar arrangements have been observed as a result of the π–π interactions between hydrogen-bonded ribbon-like supramolecular structures. A detailed comparative analysis of the molecular organisation driven by hy…