Search results for "vol"

showing 10 items of 19880 documents

Polarity reversal in HVDC joints - The effect of the axial thermal conduction

2020

It has been shown that the establishment of a thermal gradient over the radius of HVDC cables involves the accumulation of space charge within the dielectric layer. High thermal gradients over the insulation thickness of loaded cables can lead to the inversion of the radial electric field pattern. In this scenarios, transient overvoltages and polarity reversal can lead to local and transitory peaks of electric field. Since the temperature distribution plays an important role in reaching critical values of the electric field, it has been considered interesting to have a more in-depth view of the thermal behavior of HVDC systems close the discontinuities of the geometry along the cable axis. …

010302 applied physicsPolarity reversalPolarity reversalMaterials science020209 energy02 engineering and technologyMechanicsThermal conduction01 natural sciencesSpace chargeSpace chargeTemperature gradientSettore ING-IND/31 - ElettrotecnicaThermal conductivityElectric field0103 physical sciencesHeat transferHVDC joint0202 electrical engineering electronic engineering information engineeringHVDC cableVoltage
researchProduct

Positron Annihilation Lifetime Spectroscopy Insight on Free Volume Conversion of Nanostructured MgAl2O4 Ceramics

2021

H.K. and A.I.P. are grateful for the support from the COST Action CA17126. H.K. was also supported by the Ministry of Education and Science of Ukraine (project for young researchers No. 0119U100435). In addition, I.K. and H.K. were also supported by the National Research Foundation of Ukraine via project 2020.02/0217, while the research of A.I.P. was funded by the Latvian research council via the Latvian National Research Program under the topic ?High-Energy Physics and Accelerator Technologies?, Agreement No: VPP-IZM-CERN-2020/1-0002. In addition, the research of A.I.P. has been supported by the Latvian-Ukrainian Grant LV-UA/2021/5. The Institute of Solid State Physics, University of Latvi…

010302 applied physicsPositron trappingGeneral Chemical EngineeringFree-volume defectsPositron annihilationpositron annihilationnanoporespositronium decay02 engineering and technologynanostructured ceramicsfree-volume defectsnanostructured ceramics; positron annihilation; positronium decay; positron trapping; free-volume defects; nanopores021001 nanoscience & nanotechnologyPositronium decay7. Clean energy01 natural sciencesNanoporesChemistry0103 physical sciences:NATURAL SCIENCES [Research Subject Categories]positron trappingGeneral Materials Science0210 nano-technologyNanostructured ceramicsQD1-999Nanomaterials
researchProduct

Online Management of Hybrid DRAM-NVMM Memory for HPC

2019

Non-volatile main memories (NVMMs) offer a comparable performance to DRAM, while requiring lower static power consumption and enabling higher densities. NVMM therefore can provide opportunities for improving both energy efficiency and costs of main memory. Previous hybrid main memory management approaches for HPC either do not consider the unique characteristics of NVMMs, depend on high profiling costs, or need source code modifications. In this paper, we investigate HPC applications' behaviors in the presence of NVMM as part of the main memory. By performing a comprehensive study of HPC applications and based on several key observations, we propose an online hybrid memory architecture for …

010302 applied physicsProfiling (computer programming)Source codebusiness.industryComputer sciencemedia_common.quotation_subject02 engineering and technology01 natural sciences020202 computer hardware & architectureNon-volatile memoryMemory managementEmbedded system0103 physical sciencesMemory architecture0202 electrical engineering electronic engineering information engineeringKey (cryptography)businessDrammedia_common2019 IEEE 26th International Conference on High Performance Computing, Data, and Analytics (HiPC)
researchProduct

Magnetic field control of gas-liquid mass transfer in ferrofluids

2020

Abstract Gas-liquid mass transfer plays a key role in a broad range of industrial processes. The magnetic field control over the morphology of the gas-liquid interface and solute transport is an attractive feature if it can be realized efficiently. However, the magnetic properties of typical liquids and gases are rather weak. The experimental investigation is carried out to evaluate the effect of the magnetic field, which is mediated by magnetic nanoparticles, on the gas-liquid mass exchange during the sparging run through a hydrocarbon ferrofluid. The results indicate that the gradient field is especially effective at controlling the gas-liquid contact volume: the foaming of the liquid dur…

010302 applied physicsRange (particle radiation)FerrofluidMaterials science02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesElectronic Optical and Magnetic MaterialsMagnetic fieldPhysics::Fluid DynamicsCondensed Matter::Soft Condensed MatterVolume (thermodynamics)Chemical physicsMass transfer0103 physical sciencesMagnetic nanoparticlesVector field0210 nano-technologySpargingJournal of Magnetism and Magnetic Materials
researchProduct

Negative differential resistance and threshold-switching in conical nanopores with KF solutions

2021

Negative differential resistance (NDR) phenomena are under-explored in nanostructures operating in the liquid state. We characterize experimentally the NDR and threshold switching phenomena observed when conical nanopores are immersed in two identical KF solutions at low concentration. Sharp current drops in the nA range are obtained for applied voltages exceeding thresholds close to 1 V and a wide frequency window, which suggests that the threshold switching can be used to amplify small electrical perturbations because a small change in voltage typically results in a large change in current. While we have not given a detailed physical mechanism here, a phenomenological model is also includ…

010302 applied physicsRange (particle radiation)NanostructureMaterials sciencePhysics and Astronomy (miscellaneous)Condensed matter physics02 engineering and technologyConical surface021001 nanoscience & nanotechnology01 natural sciencesNanopore0103 physical sciencesPhenomenological modelCurrent (fluid)Differential (infinitesimal)0210 nano-technologyVoltageApplied Physics Letters
researchProduct

Silicon dosimeters based on Floating Gate Sensor: design, implementation and characterization

2020

A rad-hard monolithic dosimeter has been implemented and characterized in a standard 180 nm CMOS technology. The radiation sensor (C-sensor) is based on a Floating Gate (FG) MOS discharge principle. The output current is processed by a current-to-voltage (I/V) interface and then converted by a 5-bit flash ADC. The dosimeter is re-usable (FG can be recharged) and can detect a dose up to 1krad (Si) with a resolution of 30rad (Si) typical over temperature 0 to 85°C range. The ADC allows easy further signal processing for calibration and averaging, etc. The power consumption of C-sensor plus I/V interface is < 2mW from a 5 V power supply. The overall layout area is less than 0.25mm2. The Rad…

010302 applied physicsSignal processingMaterials scienceDosimeterSettore ING-IND/20 - Misure E Strumentazione Nucleari010308 nuclear & particles physicsbusiness.industryAnalog-to-digital converterHardware_PERFORMANCEANDRELIABILITYFlash ADC01 natural sciencesPower (physics)law.inventionCMOSlawAnalog-to-Digital converter current-to-voltage interfaces Dosimeter edgeless transistors (ELT) Floating Gate MOS radiation hardening by design (RHBD) total ionizing dose (TID)Absorbed dose0103 physical sciencesHardware_INTEGRATEDCIRCUITSCalibrationOptoelectronicsbusiness2020 IEEE 20th Mediterranean Electrotechnical Conference ( MELECON)
researchProduct

Determination of impurity distributions in ingots of solar grade silicon by neutron activation analysis

2017

AbstractIn a series of crystallization experiments, the directional solidification of silicon was investigated as a low cost path for the production of silicon wafers for solar cells. Instrumental neutron activation analysis was employed to measure the influence of different crystallization parameters on the distribution of 3d-metal impurities of the produced ingots. A theoretical model describing the involved diffusion and segregation processes during the solidification and cooling of the ingots could be verified by the experimental results. By successive etching of the samples after the irradiation, it could be shown that a layer of at least 60 μm of the samples has to be removed to get r…

010302 applied physicsSiliconMetallurgychemistry.chemical_elementdirectional solidification02 engineering and technologysolar silicon021001 nanoscience & nanotechnology01 natural sciencesMaterialien - Solarzellen und TechnologieKristallisation und Waferingtransition metalsSilicium-PhotovoltaikchemistryImpurityPhotovoltaik0103 physical sciencesPhysical and Theoretical ChemistryNeutron activation analysis0210 nano-technologyfeedstockneutron activation analysis
researchProduct

The Effect of the Harmonic Content Generated by AC/DC Modular Multilevel Converters on HVDC Cable Systems

2019

With the increasing penetration of renewable and decentralized energy sources into the power grid, an extended use of DC voltages is expected on both distribution and transmission levels. Generation of DC voltages by means of voltage source converters is associated with a wide spectrum of harmonic distortions at converter terminals, both on the ac and on the dc sides. This can lead to partial discharges in power cables, which deteriorate insulation material thus weakening its performance and reducing cable life-time. In the previously published paper, the effect of harmonic distortion on appearance of partial discharges in cable insulation was evaluated. Here, the study related to the PD be…

010302 applied physicsTotal harmonic distortionbusiness.industryComputer scienceripple020209 energyElectrical engineering02 engineering and technologyDC streConvertersmultilevel converter01 natural sciencesHarmonic analysisSynchronization (alternating current)partial dischargeSettore ING-IND/31 - ElettrotecnicaharmonicHarmonics0103 physical sciences0202 electrical engineering electronic engineering information engineeringHarmonicPDWaveformVoltage sourcebusiness2019 IEEE Conference on Electrical Insulation and Dielectric Phenomena (CEIDP)
researchProduct

A new technique for partial discharges measurement under DC periodic stress

2017

The aim of the present work is to recognize the type of defect in insulating materials employed in DC electrical systems. This analysis, under AC stress, is carried out by using the Phase Resolved method (PRPD). While, under constant voltage stress this method cannot be performed and measurements show complexities. In order to overcome these problems, a new technique is proposed, based on the application of a periodic continuous waveform. Simulation results, carried out by using a model based on a time-variable conductance of an air void defect, showed the PRPD pattern that can be obtain. Furthermore, compared to the constant DC stress, the measurement duration became lower and the discharg…

010302 applied physicsVoid (astronomy)Materials scienceHVDCElectronic Optical and Magnetic MaterialConductanceStress measurementMechanicsDC stre01 natural sciencesSpace chargeSettore ING-IND/33 - Sistemi Elettrici Per L'EnergiaSettore ING-IND/31 - ElettrotecnicaPartial discharge0103 physical sciencesWaveformConstant voltagePRPD patternElectrical and Electronic Engineering010306 general physics
researchProduct

Synergistic effect of fiber content and length on mechanical and water absorption behaviors of Phoenix sp. fiber-reinforced epoxy composites

2016

Phoenix sp. fiber-reinforced epoxy composites have been manufactured using compression molding technique. The effect of reinforcement volume content (0%, 10%, 20%, 30%, 40%, and 50%) and size (300 µm particles, 10 mm, 20 mm, and 30 mm fibers) on quasi-static and dynamic mechanical properties was investigated. Moreover, the water absorption properties of composites were analyzed at different environmental conditions (10℃, 30℃, and 60℃). For each reinforcement size, composites loaded with 40% in volume show highest tensile and flexural properties. Furthermore, composites with 300 µm particles present the best impact properties and the lowest water absorption, regardless of the environmental …

010302 applied physicsVolume contentAbsorption of waterMaterials sciencePolymers and PlasticsMaterials Science (miscellaneous)dynamic mechanical propertieCompression molding02 engineering and technologyEpoxy021001 nanoscience & nanotechnology01 natural sciencesIndustrial and Manufacturing Engineeringwater absorptionvolume fractionvisual_art0103 physical sciencesVolume fractionvisual_art.visual_art_mediummechanical propertieChemical Engineering (miscellaneous)FiberComposite materialPhoenix sp. fiber0210 nano-technologyJournal of Industrial Textiles
researchProduct