0000000000001199
AUTHOR
Emmanuel Marin
showing 22 related works from this author
Radiation Hardened Optical Frequency Domain Reflectometry Distributed Temperature Fiber-Based Sensors
2015
International audience; We study the performance of Optical Frequency Domain Reflectometry (OFDR) distributed temperature sensors using radiation resistant single-mode optical fibers. In situ experiments under 10 keV X-rays exposure up to 1 MGy( SiO 2 ) were carried out with an original setup that allows to investigate combined temperature and radiation effects on the sensors within a temperature range from 30 ° C to 250 ° C. Obtained results demonstrate that optical fiber sensors based on Rayleigh technique are almost unaffected by radiation up to the explored doses. We show that a pre-thermal treatment stabilize the sensor performance increasing the accuracy on temperature measurement fro…
Coating impact and radiation effects on optical frequency domain Reflectometry fiber-based temperature sensors
2015
International audience; Temperature response of radiation-tolerant OFDR-based sensors is here investigated, with particular attention on the impact of coating on OFS. By performing consecutive thermal treatments we developed a controlled system to evaluate the performances of our distributed temperature sensor and to estimate the radiation impact. We show an important evolution of the temperature coefficient measurements with thermal treatments for non-irradiated fiber and that the amplitude of this change decreases increasing radiation dose. As final results, we demonstrate that sensor performances are improved if we performed a pre-thermal treatment on the fiber-based system permitting to…
Origins of radiation-induced attenuation in pure-silica-core and Ge-doped optical fibers under pulsed x-ray irradiation
2020
We investigated the nature, optical properties, and decay kinetics of point defects causing large transient attenuation increase observed in silica-based optical fibers exposed to short duration and high-dose rate x-ray pulses. The transient radiation-induced attenuation (RIA) spectra of pure-silica-core (PSC), Ge-doped, F-doped, and Ge + F-doped optical fibers (OFs) were acquired after the ionizing pulse in the spectral range of [∼0.8–∼3.2] eV (∼1500–∼380 nm), from a few ms to several minutes after the pulse, at both room temperature (RT) and liquid nitrogen temperature (LNT). Comparing the fiber behavior at both temperatures better highlights the thermally unstable point defects contribut…
Laser wavelength effects on the refractive index change of waveguides written by femtosecond pulses in silica glasses
2018
We investigate the influence of two fs-laser wavelengths (343 and 800 nm) on the induced refractive index change (Δn) of waveguides written in silica materials. Results show that Δn is higher for waveguides photo-inscribed with UV photons.
Vulnerability of OFDR-based distributed sensors to high γ-ray doses
2015
Vulnerability of Optical Frequency Domain Reflectometry (OFDR) based sensors to high γ-ray doses (up to 10 MGy) is evaluated with a specific issue of a radiation-hardened temperature and strain monitoring system for nuclear industry. For this, we characterize the main radiation effects that are expected to degrade the sensor performances in such applicative domain: the radiation-induced attenuation (RIA), the possible evolution with the dose of the Rayleigh scattering phenomenon as well as its dependence on temperature and strain. This preliminary investigation is done after the irradiation and for five different optical fiber types covering the range from radiation-hardened fibers to highl…
Real time monitoring of water level and temperature in storage fuel pools through optical fibre sensors
2017
AbstractWe present an innovative architecture of a Rayleigh-based optical fibre sensor for the monitoring of water level and temperature inside storage nuclear fuel pools. This sensor, able to withstand the harsh constraints encountered under accidental conditions such as those pointed-out during the Fukushima-Daiichi event (temperature up to 100 °C and radiation dose level up to ~20 kGy), exploits the Optical Frequency Domain Reflectometry technique to remotely monitor a radiation resistant silica-based optical fibre i.e. its sensing probe. We validate the efficiency and the robustness of water level measurements, which are extrapolated from the temperature profile along the fibre length, …
Influence of neutron and gamma-ray irradiations on rad-hard optical fiber
2015
We investigated point defects induced in rad-hard Fluorine-doped optical fibers using both a mixed source of neutrons (fluences from 1015 to 1017 n/cm2) and γ-rays (doses from 0.02 to 2 MGy) and by a γ-ray source (dose up to 10 MGy). By combining several complementary spectroscopic techniques such as radiation-induced attenuation, confocal micro-luminescence, time-resolved photo-luminescence and electron paramagnetic resonance, we evidenced intrinsic and hydrogen-related defects. The comparison between the two irradiation sources highlights close similarities among the spectroscopic properties of the induced defects and the linear correlation of their concentration up to 1016 n/cm2. These r…
Transient absorption with a femtosecond tunable excitation pump reveals the emission kinetics of color centers in amorphous silica.
2021
We report a set of femtosecond (fs) transient absorption (TA) measurements following the dynamics of the so-called nonbridging oxygen hole center in silica, a model color center in wide bandgap amorphous solids, characterized by a very large Stokes shift between the UV excitation and its associated red emission at 1.9 eV. The changes in the TA spectrum were probed in the UV-visible range at various delays after photoexcitation and analyzed as a function of the UV excitation energy, in single-photon absorption conditions. The combination of the experiments helps to clarify the defect photocycle, highlighting how TA measurements with tunable UV excitation could represent a powerful tool to in…
Steady state γ-ray radiation effects on Brillouin fiber sensors
2015
International audience; Brillouin optical time-domain analysis (BOTDA) sensors offer remarkable advantages for the surveillance of the planned French deep geological radioactive wastes repository, called Cigéo1,2. In this work we study the performances of Brillouin distributed sensors in harsh environment. We evaluate the radiation tolerance of different sensor classes and their responses evolution during γ-ray exposition with 1kGy/h dose rate (to reach ~0.2MGy) and after 1, 3, 6 and 10 MGy accumulated doses. Measurements on strained Ge-doped SMF are reported to highlight the variation on Brillouin scattering proprieties, both intrinsic frequency position of Brillouin shift and its dependen…
Investigation of Coating Impact on OFDR Optical Remote Fiber-Based Sensors Performances for Their Integration in High Temperature and Radiation Envir…
2016
The response of optical frequency-domain reflectometry-based temperature sensors is here investigated in harsh environments (high temperature, high radiation dose) focusing the attention on the impact of the fiber coating on the sensor performances in such conditions. Our results demonstrate that the various coating types evolve differently under thermal treatment and/or radiations, resulting in a small (<5%) change in the temperature coefficient of the sensor. The identified procedure, consisting of a prethermal treatment of the fiber at its maximum coating operating temperature, is here verified up to 150 °C for higherature acrylate and up to 300 °C for polyamide coating. This method allo…
Photoluminescence of Point Defects in Silicon Dioxide by Femtosecond Laser Exposure
2021
The nature of the radiation-induced point defects in amorphous silica is investigated through online photoluminescence (PL) under high intensity ultrashort laser pulses. Using 1030 nm femtosecond laser pulses with a repetition rate of 1 kHz, it is possible to study the induced color centers through their PL signatures monitored during the laser exposure. Their generation is driven by the nonlinear absorption of the light related to the high pulse peak powers provided by femtosecond laser, allowing to probe the optical properties of the laser exposed region. The experiment is conducted as a function of the laser pulse power in samples with different OH contents. The results highlight the dif…
Raman based distributed fiber optic temperature sensors for structural health monitoring in radiation environment
2015
Raman distributed temperature sensor (RDTS) measurements were performed during γ-radiation on three different classes of standard multimode fibers (pure, Ge-doped and F-doped). The sensor response is affected by the radiation induced attenuation phenomena leading to errors in the temperature measurements. The amplitude of this error strongly depends on the fiber type and the irradiation conditions. These results are promising in view of the integration of these RDTS into the deep geological repository for radioactive waste.
Radiation effects on optical frequency domain reflectometry fiber-based sensor
2015
International audience; We investigate the radiation effects on germanosilicate optical fiber acting as the sensing element of optical frequency domain reflectometry devices. Thanks to a new setup permitting to control temperature during irradiation, we evaluate the changes induced by 10 keV x rays on their Rayleigh response up to 1 MGy in a temperature range from −40°C up to 75°C. Irradiation at fixed temperature points out that its measure is reliable during both irradiation and the recovery process. Mixed temperature and radiation measurements show that changing irradiation temperature leads to an error in distributed measurements that depends on the calibration procedure. These results …
Multiphoton process investigation in silica by UV femtosecond laser
2022
We investigated the interaction processes between high intensity femtosecond ultraviolet laser pulses and amorphous silica, leading to permanent refractive-index changes that are at the basis of advanced manufacturing for photonics devices. The experiment, carried out as a function of the laser power, improves our understanding on the strong-field ionization process by the monitoring of the 1.9 eV and 2.65 eV emissions, related to nonbridging oxygen hole centers and self-trapped exciton, respectively, induced in the exposed glass region. Our results clearly proved that the UV laser light band-to-band absorption is allowed in the multiphoton ionization limit, whose consecutive relaxation lea…
On-Line Characterization of Gamma Radiation Effects on Single-Ended Raman Based Distributed Fiber Optic Sensor
2016
We report distributed temperature measurements based on Raman scattering performed during steady state $\gamma $ -ray irradiation at a dose rate of 1 kGy( ${\rm SiO}_{2}$ )/h and up to a total ionizing dose (TID) of $\sim 0.1\ \hbox{MGy}$ . We characterize on-line the evolution of the performances of a single-ended Raman distributed temperature sensor (RDTS) during the $\gamma $ -ray exposure of different classes of commercial multimode fibers (MMFs) acting as the sensing element. RDTS is influenced by the radiation-induced attenuation (RIA) phenomena leading to both large errors in the temperature measurements and a diminution of the useful sensing length. The amplitude of the radiation-in…
Evaluation of Distributed OFDR-Based Sensing Performance in Mixed Neutron/Gamma Radiation Environments
2017
We report the study of a radiation resistant single mode optical fiber doped with fluorine exposed to mixed neutron and $\gamma $ -radiation up to $10^{17}$ n/cm2 fluence and >2 MGy dose to evaluate its performances when used as the sensing element of a distributed Optical Frequency Domain Reflectometry (OFDR). The use of complementary spectroscopic techniques highlights some differences between the responses of solely $\gamma $ -radiation (10 MGy) or mixed neutron and $\gamma $ ( $10^{17}$ n/cm $^{2}+>2$ MGy) irradiated samples. Those differences are linked to the defect generation rather than to structural changes of the ${a}$ -SiO2 host matrix. We show that a modification of the refracti…
Near-IR- and UV-femtosecond laser waveguide inscription in silica glasses
2019
The influence of laser parameters on silica based waveguide inscription is investigated by using femtosecond laser pulses at 1030 nm (near-IR) and at 343 nm (UV). Negative phase contrast microscopy technique is used to measure the refractive index contrast for different photo-inscribed waveguides and shows the effects of both laser wavelength and scanning speed. In particular, UV photons have a higher efficiency in the waveguide production process as also confirmed by the lower optical losses at 1550 nm in these waveguides. These measurements are combined with micro-Raman and photoluminescence techniques, highlighting that laser exposure induces both structural modification of the silica an…
Radiation tolerant fiber Bragg gratings for high temperature monitoring at MGy dose levels
2014
International audience; We report a method for fabricating fiber Bragg gratings (FBG) resistant to very severe environments mixing high radiation doses (up to 3 MGy) and high temperatures (up to 230 degrees C). Such FBGs have been written in two types of radiation resistant optical fibers (pure-silica and fluorine-doped cores) by exposures to a 800 nm femtosecond IR laser at power exceeding 500 mW and then subjected to a thermal annealing treatment of 15 min at 750 degrees C. Under radiation, our study reveals that the radiation induced Bragg wavelength shift (BWS) at a 3 MGy dose is strongly reduced compared to responses of FBGs written with nonoptimized conditions. The BWS remains lower t…
Radiation Vulnerability of Fiber Bragg Gratings in Harsh Environments
2015
International audience; The difficulties encountered in the implementation of a temperature or strain sensor based on fiber Bragg grating (FBG) in a harsh radiative environment are introduced. We present the choices made to select both a radiation-resistant fiber in terms of transmission and also the grating inscription conditions necessary to write radiation tolerant FBGs in such fibers with a femtosecond laser. The radiation response of these gratings was also studied under radiation at dose up to 1 MGy. The comparison between Ge-free and Ge-doped fibers was highlighted.
Radiation Characterization of Optical Frequency Domain Reflectometry Fiber-Based Distributed Sensors
2016
International audience; We studied the responses of fiber-basedtemperature and strain sensors related to Optical FrequencyDomain Reflectometry (OFDR) and exposed to high γ-ray dosesup to 10 MGy. Three different commercial fiber classes areused to investigate the evolution of OFDR parameters withdose, thermal treatment and fiber core/cladding composition.We find that the fiber coating is affected by both thermal andradiation treatments and this modification results in anevolution of the internal stress distribution inside the fiber that influences its temperature and strain Rayleigh coefficients. These two environmental parameters introduce a relative error up to 5% on temperature and strain…
Transient and Steady-State Radiation Response of Phosphosilicate Optical Fibers: Influence of H2 Loading
2019
The radiation response of a phosphorus-doped multimode optical fiber is investigated under both transient (pulsed X-rays) and steady-state ( $\gamma $ - and X-rays) irradiations. The influence of a H2 preloading on the fiber radiation-induced attenuation (RIA) in the 300–2000-nm wavelength range has been characterized. To better understand the impact of this treatment, online behaviors of fiber samples containing different amounts of gas are compared from glass saturation (100%) to less than 1%. In addition to these in situ experiments, additional postirradiation spectroscopic techniques have been performed such as electron paramagnetic resonance or luminescence measurements to identify the…
Radiation hardening of FBG in harsh environments
2014
International audience; The difficulties encountered in the implementation of a temperature or strain sensor based on Fiber Bragg Grating in a harsh radiative environment are introduced. We present the choices made to select both a radiation-resistant fiber in terms of transmission and also the grating inscription conditions necessary to write radiation tolerant FBGs in such fibers with a femto-second laser. The response of different classes of gratings was also studied under radiation at high doses (>1MGy). The comparison between F- and Ge-doped fibers was highlighted.