0000000000069923
AUTHOR
Somjai Sangyuenyongpipat
Mobility determination of lead isotopes in glass for retrospective radon measurements rad
In retrospective radon measurements, the 22-y half life of 210Pb is used as an advantage. 210Pb is often considered to be relatively immobile in glass after alpha recoil implanted by 222Rn progenies. The diffusion of 210Pb could, however, lead to uncertain wrong retrospective radon exposure estimations if 210Pb is mobile and can escape from glass, or lost as a result of cleaning-induced surface modification. This diffusion was studied by a radiotracer technique, where 209Pb was used as a tracer in a glass matrix for which the elemental composition is known. Using the ion guide isotope separator on-line technique, the 209Pb atoms were implanted into the glass with an energy of 39 keV. The di…
Wettability and compositional analysis of hydroxyapatite films modified by low and high energy ion irradiation
Abstract Hydroxyapatite-like thin films on silicon substrate were deposited using atomic layer deposition and were subjected to irradiation with Ar ions accelerated through 0.6–1.2 kV as well as 2 MeV 16 O + ions. After low energy Ar irradiation a significant reduction in contact angle was observed. However, the Ca/P atomic ratio remained unchanged. No reduction in contact angle was seen for high energy 16 O + irradiation. Atomic force microscopy showed the enhancement of floral-like pattern after low energy Ar bombardment while high energy oxygen irradiation lead to raised islands on as-deposited films.
Mobility determination of lead isotopes in glass for retrospective radon measurements
In retrospective radon measurements, the 22-y half life of (210)Pb is used as an advantage. (210)Pb is often considered to be relatively immobile in glass after alpha recoil implanted by (222)Rn progenies. The diffusion of (210)Pb could, however, lead to uncertain wrong retrospective radon exposure estimations if (210)Pb is mobile and can escape from glass, or lost as a result of cleaning-induced surface modification. This diffusion was studied by a radiotracer technique, where (209)Pb was used as a tracer in a glass matrix for which the elemental composition is known. Using the ion guide isotope separator on-line technique, the (209)Pb atoms were implanted into the glass with an energy of …
Development of micro-contact printing of osteosarcoma cells using MeV ion beam lithography
Abstract For investigation of spatial effects in signalling between cells and also signal substances that trigger cell proliferation and behaviour we are developing a micro Contact Printing process ( μ CP ) . In order to allow printing of cells stamps with high aspect ratio are required and these have been fabricated using Programmed Proximity Aperture Lithography (PPAL) with 3 MeV 4 He 2 + ions to produce PMMA masters for casting the stamps in PDMS. A simple printing device was developed and the first results using this to print human osteosarcoma cells is demonstrated.