Search results for " layer"
showing 10 items of 1022 documents
The Effect of Electronic Properties of Anodized and Hard Anodized Ti and Ti6Al4V on Their Reactivity in Simulated Body Fluid
2022
The electronic properties of barrier and porous layers on Ti and Ti6Al4V were studied. Barrier anodic oxides grown to 40 V on Ti and on Ti6Al4V are both n-type semiconductors with a band gap of 3.3 eV and 3.4 eV respectively, in agreement with the formation of amorphous TiO2. Anodizing to 200 V at 20 mA cm−2 in calcium acetate and β-glycerol phosphate disodium pentahydrate leads to the formation of Ca and P containing porous films with a photoelectrochemical behaviour dependent on the metallic substrate. A band gap of 3.2 eV and the flat band potential of −0.5 V vs Ag/AgCl were measured for the porous oxide on Ti, while optical transitions at 2.15 eV and a significantly more positive flat b…
Influence of the electro-optical properties of an a-Si:H single layer on the performances of a pin solar cell
2012
We analyze the results of an extensive characterization study involving electrical and optical measurements carried out on hydrogenated amorphous silicon (α-Si:H) thin film materials fabricated under a wide range of deposition conditions. By adjusting the synthesis parameters, we evidenced how conductivity, activation energy, electrical transport and optical absorption of an α-Si:H layer can be modified and optimized. We analyzed the activation energy and the pre-exponential factor of the dark conductivity by varying the dopant-to-silane gas flow ratio. Optical measurements allowed to extract the absorption spectra and the optical bandgap. Additionally, we report on the temperature dependen…
Identification of conjugation and cleavage products in the thiolytic metabolism of the anticancer drug 4'-(9-acridinylamino)methanesulfon-m-anisidide.
1981
Conjugation and cleavage products in the thiolytic metabolism of the anticancer drug 4′ -(9-acridinyl amino)methanesulfon-m-anisidide were identified primarily by high-pressure liquid chromatography in combination with field desorption mass spectrometry. The spontaneous metabolic pathway of the drug, as related to its susceptibility to nucleophilic attack by endogenous thiols at the 9-carbon atom of the acridine moiety, has been studied. Among the metabolite fraction of 4′-(9-acridinylamino)methanesulfon-m-anisidide excreted in rat bile after administration of a therapeutic dose, a conjugate was identified as the 9-acridinyl thioether of glutathione. This conjugation product and the corresp…
Zero Viscosity Limit for Analytic Solutions of the Primitive Equations
2016
The aim of this paper is to prove that the solutions of the primitive equations converge, in the zero viscosity limit, to the solutions of the hydrostatic Euler equations. We construct the solution of the primitive equations through a matched asymptotic expansion involving the solution of the hydrostatic Euler equation and boundary layer correctors as the first order term, and an error that we show to be \({O(\sqrt{\nu})}\). The main assumption is spatial analyticity of the initial datum.
Anatase nanoparticles boundaries resulting from titanium tetrachloride hydrolysis
2017
An important factor that governs solar energy transformation into electrical or chemical energy, when using nanoparticles-based devices, is the spatial location of traps limiting electron transport. Evidences have been presented indicating that the electron diffusion is strongly influenced by nanoparticle boundaries, whose characteristics depend on the particles preparation. In the present work we have studied the role of hydrated excess proton structures in the formation of anatase nanoparticles boundaries in samples prepared by TiCl4 hydrolysis at low temperature and strong acidic conditions. The samples, constituted by anatase nanocrystals but, mainly, by amorphous titania, are studied b…
The effect of the surface disordered layer on the photoreactivity of titania nanoparticles
2017
It is well known that the surface of metal oxide catalysts presents, usually, non-crystalline species containing impurities and low coordinated cations, which are observed in HRTEM images as a disordered layer of amorphous phase. Despite of being these species more accessible and less stable than the crystalline catalysts components, they have been rarely considered when analysing the catalyst activity. In this work, we have studied the effect of a treatment with HCl solution at pH = 0 on the characteristics of the disordered layer in two commercial anatase TiO2 samples, using techniques such as TGA, 1H MAS-NMR and HRTEM, and by determining these sample photocatalytic activity for the 4-nit…
TiO2 anatase films obtained by direct liquid injection atomic layer deposition at low temperature
2014
International audience; TiO2 thin films were grown by direct liquid injection atomic layer deposition (DLI-ALD) with infrared rapid thermal heating using titanium tetraisopropoxide and water as precursors. This titanium tetraisopropoxide/water process exhibited a growth rate of 0.018 nm/cycle in a self-limited ALD growth mode at 280 degrees C. Scanning electron microscopy and atomic force microscopy analyses have shown a smooth surface with a low roughness. XPS results demonstrated that the films were pure and close to the TiO2 stoichiometric composition in depth. Raman spectroscopy revealed that the films were crystallized to the anatase structure in the as-deposited state at low temperatu…
Tailoring the Structural, Optical, and Photoluminescence Properties of Porous Silicon/TiO2 Nanostructures
2015
The structural, optical, and photoluminescence properties of porous silicon (PSi)/titanium dioxide (TiO2) nanostructures were investigated. PSi structures consisting of macro- and mesoporous layers were fabricated by metal-assisted chemical etching, and then TiO2 was introduced inside the PSi matrix using the atomic layer deposition technique. We performed scanning electron microscopy, transmission electron microscopy (TEM), X-ray diffraction, energy dispersive X-ray spectroscopy, Raman spectroscopy, ellipsometry, and photoluminescence (PL) spectroscopy to characterize the prepared and annealed PSi/TiO2 nanostructures. TEM and Raman analyses revealed that TiO2 had a crystalline anatase stru…
Comparison of aerosol size distributions measured at ground level and calculated from inversion of solar radiances
2005
Ground-based sunphotometry measurements can be used to investigate atmospheric aerosol optical properties, such as the volume size distribution, an important parameter in the study of the effect of aerosol on atmospheric processes. Most inversion algorithms assume constant aerosol optical characteristics over the whole air column. In this work we present observational evidence of the limitations of this simplifying assumption in cases where the aerosol vertical structure is highly inhomogeneous. During the field campaign VELETA 2002, carried out in Granada (Spain), a quite complete characterization of the atmospheric aerosol was obtained by simultaneously measuring the columnar aerosol char…
Concentrations and forms of heavy metals in Slovak soils
2005
The risk assessment of heavy-metal contamination in soils requires knowledge of the controls of metal concentrations and speciation. We tested the relationship between soil properties (pH, CEC, Corg, oxide concentrations, texture) and land use (forest, grassland, arable) and the partitioning of Al, Cd, Cr, Cu, Fe, Mn, Ni, Pb, and Zn among the seven fractions of a sequential extraction procedure in 146 A horizons from Slovakia. Using a cluster analysis, we identified 92 soils as representing background metal concentrations while the remaining 54 soils showed anthropogenic contamination. Among the background soils, forest soils had the lowest heavy-metal concentrations except for Pb (highest)…