Search results for "COATINGS"
showing 10 items of 2386 documents
Surface versus bulk composition of a phosphate glass
1994
Transmission and conversion electron Mossbauer spectroscopy as well as photoelectron spectroscopy were applied to study alterations of the surface layer of an iron containing industrial phosphate glass as compared with its bulk. In the surface layer, after polishing and exposure to ambient atmosphere, Fe 2+ is partially oxidized to Fe 3+ . This oxidation, however, does not increase the O/P ratio in this layer, because it goes along with a strong leaching of network modifiers. This leaching leads to a net decrease of the O/P ratio because it overcompensates the relative oxygen increase by Fe 2+ oxidation and by uptake of water
Modelling electric field control of the spin state in the mixed-valence polyoxometalate [GeV14O40]8−
2013
International audience; : The two-electron reduced mixed-valence polyoxometalate [GeV14O40](8-) presents an unusual paramagnetic behaviour as a consequence of the partial trapping of these electrons. The effect of applying an electric field is that of inducing antiferromagnetic coupling between the two delocalized electronic spins.
Hybrid Chemical Vapour Deposition: Gold and Vanadium Dioxide Nano-composites for Smart Windows
2009
Electronic structure of adsorbed organic molecules
1997
We report on investigations of chiral organic molecules in the gas phase and physisorbed on graphite. The measurements were carried out by means of angle-resolving VUV photoelectron spectroscopy. The emission from specific orbitals in oriented molecules can be forbidden because of dipole selection rules. Due to the lack of certain features in the spectra, it was possible to determine the adsorption geometry of cyclohexanone and camphor as being with their ring system parallel to the surface. By comparison of gas-phase and adsorbate spectra of ethyl benzene derivatives, adsorption could be proved to be molecular without decomposition. For amino acids on graphite, the occurrence of characteri…
Low-temperature molecular layer deposition using monifunctional aromatic precursors and ozone-based ring-opening reactions
2017
Molecular layer deposition (MLD) is an increasingly used deposition technique for producing thin coatings consisting of purely organic or hybrid inorganic-organic materials. When organic materials are prepared, low deposition temperatures are often required to avoid decomposition, thus causing problems with low vapor pressure precursors. Monofunctional compounds have higher vapor pressures than traditional bi- or trifunctional MLD precursors, but do not offer the required functional groups for continuing the MLD growth in subsequent deposition cycles. In this study, we have used high vapor pressure monofunctional aromatic precursors in combination with ozone-triggered ring-opening reactions…
Water Adsorption in Flexible Gallium-Based MIL-53 Metal–Organic Framework
2014
Understanding the adsorption of water in metal–organic frameworks (MOF), and particularly in soft porous crystals, is a crucial prerequisite before considering MOFs for industrial applications. We report here a joint experimental and theoretical study on the behavior of a gallium-based breathing MOF, Ga-MIL-53, upon water adsorption. By looking at the energetics and thermodynamics of Ga-MIL-53, we demonstrate why it behaves differently from its sibling Al-MIL-53, showing a different phase at room temperature (a nonporous phase) and the presence of a hydrated narrow-pore structure at gas saturation pressure. Moreover, we present a complete water vapor pressure vs temperature phase diagram of…
One-sensor electronic olfactometer for rapid sorting of fresh fruit juices
2001
Abstract A low-cost electronic olfactometer was developed, based on virtual sensors array (an array of signals from a single metal oxide sensor) and on our proprietary semi-automated sampling system. This concept enables us to drastically improve the sensitivity and selectivity of the entire olfactometer to make it suited to food products analysis. Each step of the prototype was checked separately in earlier work, and finally the system performance was evaluated first on pure chemicals, and then at-line for grape juice during grape-harvesting in Champagne. It is shown that over a 3-week vintage period, the drift of the unique-sensor was quite low (absolute baseline value: avg., 2152; std., …
Time-resolving Analysis of Cryotropic Gelation of Water/Poly(Vinyl Alcohol) Solutions via Small Angle Neutron Scattering
2007
The structural transformations occurring in initially homogeneous aqueous solutions of poly(vinyl alcohol) (PVA) through application of freezing (-13 degrees C) and thawing (20 degrees C) cycles is investigated by time resolving small-angle neutron scattering (SANS). These measurements indicate that formation of gels of complex hierarchical structure arises from occurrence of different elementary processes, involving different length and time scales. The fastest process that could be detected by our measurements during the first cryotropic treatment consists of the crystallization of the solvent. However, solvent crystallization is incomplete, and an unfrozen liquid microphase more concentr…
Mesoscopic and Microscopic Investigation on Poly(vinyl alcohol) Hydrogels in the Presence of Sodium Decylsulfate
2007
The structure of poly(vinyl alcohol) (PVA) hydrogels formed as a result of freeze/thaw treatments of aqueous solutions of the polymer (11 wt % PVA) in the freshly prepared state is analyzed through the combined use of small (SANS) and ultrasmall (USANS) angle neutron scattering techniques. The structure of these hydrogels may be described in terms of polymer rich regions, with dimensions of the order of 1-2 microm, dispersed in a water rich phase, forming two bicontinuous phases. The PVA chains in the polymer rich phase form a network where the cross-linking points are mainly crystalline aggregates of PVA having average dimensions of approximately 45 A. The structural organization of freeze…
Resist-based silver nanocomposites synthesized by lithographic methods
2010
In this work, the formation of silver metal nanoparticles inside a negative-tone resist based on poly(vinyl alcohol) is achieved by electron beam lithography. The chemistry of this sensitive resist allows the production of nanoparticles as well as the polymer crosslinking by the electron radiation. Due to the presence of the silver nanoparticles, the final composite exhibits a plasmonic behavior, which was characterized by measuring the absorbance. The lithographic properties of the resist have been characterized. The technique has also been exported to UV lithography, where silver nanoparticles are obtained inside the polymeric patterns after optical lithography.