Search results for "Detection limit"
showing 10 items of 810 documents
Simultaneous determination of Folpet and Metalaxyl in pesticide formulations by flow injection Fourier transform infrared spectrometry
2003
Fourier transform infrared (FTIR) spectrometric methodology has been developed for the simultaneous determination of Folpet and Metalaxyl in pesticide formulations. The method involves the extraction of both active principles by sonication of the sample with CHCl3 and direct measurement of the absorbance using peak height values at 1798 cm −1 corrected with a baseline defined at 1810 cm −1 for Folpet, and peak area data established from 1677 to 1667 cm −1 corrected using a baseline from 1692 to 1628 cm −1 for Metalaxyl. Limits of detection (3 s) values of 17 and 16 gg −1 were found for Folpet and Metalaxyl, respectively, with results comparable with those found by liquid chromatography with…
Sequential injection spectrophotometric determination of oxybenzone in lipsticks
2001
A sequential injection (SI) procedure for the spectrophotometric determination of oxybenzone in lipsticks is reported. The colorimetric reaction between nickel and oxybenzone was used. SI parameters such as sample solution volume, reagent solution volume, propulsion flow rate and reaction coil length were studied. The limit of detection was 3 microg ml(-1). The sensitivity was 0.0108+/-0.0002 ml microg(-1). The relative standard deviations of the results were between 6 and 12%. The real concentrations of samples and the values obtained by HPLC were comparable. Microwave sample pre-treatment allowed the extraction of oxybenzone with ethanol, thus avoiding the use of toxic organic solvents. E…
Simultaneous detection of three antiviral and four antibiotic compounds in source-separated urine with liquid chromatography
2013
An analytical method for the simultaneous screening of three antiviral agents (nevirapine, zidovudine, lamivudine), four antibiotics (sulfamethoxazole, trimethoprim, ciprofloxacin, rifampicin) and one reference compound (carbamazepine) in human urine was developed. Separation was achieved with a Kinetex XB-C18 (75 × 4.6 mm, 2.6 μm) column after the extraction of pharmaceuticals from urine with SPE. Gradient elution with a mobile phase consisting of acetonitrile and 10 mM KH2 PO4 (pH 2.5), and diode array detection with monitoring at 210 and 264 nm was applied. The developed method was validated in terms of selectivity, linearity, stability and sensitivity. Repeatability (n = 3) and between-…
Indicator-free electrochemical DNA hybridization biosensor
1998
A new electrochemical hybridization biosensor protocol without an external indicator is described. The biosensor format involves the immobilization of inosine-substituted (guanine-free) probe onto the carbon paste transducer, and a direct chronopotentiometric detection of the duplex formation by the appearance of the guanine oxidation peak of the target. Such a use of the intrinsic DNA electrochemical response for monitoring hybridization events offers several advantages (over the common use of external indicators), including the appearance of a new peak, a flat background, or simplicity. A 4 min short hybridization period allows a detection limit around 120 ng/ml. Performance characteristi…
High performance liquid chromatography—atomic fluorescence spectrometric determination of arsenic species in beer samples
2003
Abstract A method has been developed for the direct determination of As(III), dimethylarsinic acid (DMA), monomethylarsonic acid (MMA) and As(V) in beers by hydride generation—atomic fluorescence spectrometry after separation of arsenic species by high performance liquid chromatography. Compounds were separated by anion-exchange chromatography with isocratic elution using KH 2 PO 4 /K 2 HPO 4 as mobile phase with elution times of 1.67, 2.08, 6.52 and 10.72 min for As(III), DMA, MMA and As(V), respectively. Parameters affecting the hydride generation of all arsenic species were studied and the best conditions were established as a reaction coil of 150 cm, for a sample injected volume of 100 …
Determination of total arsenic in soft drinks by hydride generation atomic fluorescence spectrometry
2007
Abstract A highly sensitive and simple method has been developed for the determination of total arsenic, by continuous hydride generation and atomic fluorescence spectrometry (HGAFS), in refreshing drink samples as colas, teas and fruit juices. Samples were mixed with concentrated HCl and KI to obtain final concentrations of 2 mol l−1 and 1%, respectively. These solutions were aspirated and merged with a reducing NaBH4 3% (m/v) solution, with sample and NaBH4 flow rates of 12.5 and 1.5 ml min−1, respectively. The hydride generated in a 170 cm reaction coil was transported to the detector with an Ar flow of 400 ml min−1. The recovery values of added concentrations, from 0.1 to 0.9 ng ml−1, o…
Determination of arsenite, arsenate, monomethylarsonic acid and dimethylarsinic acid in cereals by hydride generation atomic fluorescence spectrometry
2007
Abstract A fast, sensitive and simple non-chromatographic analytical method was developed for the speciation analysis of toxic arsenic species in cereal samples, namely rice and wheat semolina. An ultrasound-assisted extraction of the toxic arsenic species was performed with 1 mol L− 1 H3PO4 and 0.1% (m/v) Triton XT-114. After extraction, As(III), As(V), dimethylarsinic acid (DMA) and monomethylarsonic acid (MMA) concentrations were determined by hydride generation atomic fluorescence spectrometry using a series of proportional equations corresponding to four different experimental reduction conditions. The detection limits of the method were 1.3, 0.9, 1.5 and 0.6 ng g− 1 for As(III), As(V)…
Selective determination of clenbuterol residues in urine by molecular imprinted polymer—Ion mobility spectrometry
2017
Abstract Clenbuterol is banned for sports use and strictly regulated in livestock industry. In this study, a procedure for the determination of clenbuterol residues in water and urine has been developed using selective supports combined with ion mobility spectrometry (IMS) determination. A molecular imprinted polymer (MIP) was used for efficient clean-up and preconcentration of clenbuterol followed to a dispersive liquid-liquid microextraction (DLLME) in order to improve selectivity and sensitivity of IMS determinations. Quantitative recoveries from 81 to 99% were obtained for water and spiked urine samples using MIP-DLLME-IMS method. A precision of 4.5%, established as the relative standar…
Simultaneous determination of olanzapine, clozapine and demethylated metabolites in serum by on-line column-switching high-performance liquid chromat…
2001
An automated method for simultaneous routine quantification of the antipsychotic drugs clozapine, olanzapine and their demethylated metabolites is described. The method included adsorption on a cyanopropyl (CPS) coated clean-up column (10 microm; 10 x 2.0 mm I.D.), washing off interfering serum constituents to waste, and separation on C18 ODS Hypersil reversed phase material (5 microm; 250 x 4.6 mm I.D.) using acetonitrile-water-tetramethylethylenediamine (37:62.6:0.4, v/v/v) adjusted to pH 6.5 with concentrated acetic acid. UV-detection was performed at 254 nm. The limit of quantification was 10-20 ng/ml. Relative day to day standard variations ranged between 4.5 and 13.5%. The method is s…
Screening and authentication of tea varieties based on microextraction-assisted voltammetry of microparticles
2015
Abstract A simple electrochemical methodology for screening and authentication of green, black and red tea varieties is proposed. It is based on the record of the voltammetric response of microparticulate films of antioxidant compounds resulting from an ethanolic micro-extraction of commercial tea herbal preparations in contact with aqueous buffers. The obtained voltammetric responses led us to differentiate between diverse tea varieties upon application of bivariant and multivariant chemometric techniques, including discrimination of mixtures of teas with sensitivity estimated of 5.0 μA mg −1 with a detection limit of 0.01 mg of tea sample. Under the proposed conditions 100% discrimination…