Search results for "Diode"
showing 10 items of 469 documents
Perovskite nanoparticles : synthesis, properties, and novel applications in photovoltaics and LEDs
2018
Solar cells and light-emitting diodes (LEDs) based on metal-halide perovskites are transitioning from promising performers to direct competitors to well-established technologies, with cost-effectiveness as a strong advantage. Nanostructured perovskites have yielded record LEDs due to their higher versatility in the local management of charge carriers, which has enabled photoluminescence quantum yields (PLQYs) close to 100%. However, these perovskite nanostructures are yet to be fully exploited in other applications such as photovoltaics, where they can also present competitive advantages as they enable feasible routes to surpass the Shockley–Queisser limit by means of multiexciton generatio…
VUV irradiance measurement of a 2.45 GHz microwave-driven hydrogen discharge
2015
Absolute values of VUV-emission of a 2.45 GHz microwave-driven hydrogen discharge are reported. The measurements were performed with a robust and straightforward method based on a photodiode and optical filters. It was found that the volumetric photon emission rate in the VUV-range (80-250 nm) is $10^{16}$-$10^{17}$ 1/cm$^3$s, which corresponds to approximately 8% dissipation of injected microwave power by VUV photon emission. The volumetric emission of characteristic emission bands was utilized to diagnostics of molecular plasma processes including volumetric rates of ionization, dissociation and excitation to high vibrational levels and metastable states. The estimated reaction rates impl…
Effects of 5 MeV electron irradiation on deep traps and electroluminescence from near-UV InGaN/GaN single quantum well light-emitting diodes with and…
2020
The electrical properties, electroluminescence (EL) power output and deep trap spectra were studied before and after 5 MeV electron irradiation of near-UV single-quantum-well (SQW) light-emitting diodes (LED) structures differing by the presence or absence of InAlN superlattice underlayers (InAlN SL UL). The presence of the underlayer is found to remarkably increase the EL output power and the radiation tolerance of LEDs, which correlates with a much lower and more slowly changing density of deep traps in the QW region with radiation dose, and the higher lifetime of charge carriers, manifested by higher short-circuit current and open-circuit voltage in current–voltage characteristics under …
Current rectification in a single molecule diode: the role of electrode coupling.
2015
We demonstrate large rectification ratios (> 100) in single-molecule junctions based on a metal-oxide cluster (polyoxometalate), using a scanning tunneling microscope (STM) both at ambient conditions and at low temperature. These rectification ratios are the largest ever observed in a single-molecule junction, and in addition these junctions sustain current densities larger than 10^5 A/cm^2. By following the variation of the I-V characteristics with tip-molecule separation we demonstrate unambiguously that rectification is due to asymmetric coupling to the electrodes of a molecule with an asymmetric level structure. This mechanism can be implemented in other type of molecular junctions u…
Relative Humidity Dependent Resistance Switching of Bi2S3Nanowires
2017
Electrical properties of Bi2S3nanowires grown using a single source precursor in anodic aluminum oxide templates are sensitive to the relative humidity in an inert gas environment. Dynamic sensing dependency is obtained and shows presence of spontaneous resistance switching effect between low and high relative humidity states. Employing the thermionic field emission theory, heights of Schottky barriers are estimated from the current-voltage characteristics and in relation to the humidity response. The change of Schottky barrier height is explained by local changes in physically adsorbed water molecules on the surface of the nanowire.
Suppression of electron trapping by quantum dot emitters using a grafted polystyrene shell
2019
A fundamental problem of adding chromophores to an organic host is that their smaller band gap leads to severe trapping of either electrons or holes, resulting in strongly unbalanced transport. We demonstrate that electron trapping by an inorganic quantum dot (QD) in a conjugated polymer host can be suppressed by functionalizing its shell with a thin insulating polystyrene layer. The polystyrene shell not only reduces trapping, but also suppresses detrapping of captured electrons, resulting in increased charging of the QDs with subsequent voltage scans, after initial charging, a red-emitting hybrid polymer:QD light-emitting diode is obtained with voltage independent electroluminescence spec…
Effect of the precursor's stoichiometry on the optoelectronic properties of methylammonium lead bromide perovskites
2017
International audience; Methylammonium lead bromide (MAPbBr 3) perovskites have been widely studied in applications such as lasers and light-emitting diodes, thanks to their favorable bandgap, efficient charge transport, and the possibility of processing by simple solution methods. The film morphology has a large impact on the optical and electronic properties of the material; hence the deposition methods and the type of precursors used are crucial in the preparation of efficient optoelectronic devices. Here we studied the effect of the precursor´s stoichiometry of solution processed MAPbBr 3 thin films on their optical and electronic properties. We found a drastic effect of the stoichiomet…
Efficient Perovskite Light-Emitting Diodes: Effect of Composition, Morphology, and Transport Layers
2018
Organic-inorganic metal halide perovskites are emerging as novel materials for light-emitting applications due to their high color purity, band gap tunability, straightforward synthesis, and inexpensive precursors. In this work, we improve the performance of three-dimensional perovskite light-emitting diodes (PeLEDs) by tuning the emissive layer composition and thickness and by using small-molecule transport layers. Additionally, we correlate PeLED efficiencies to the perovskite structure and morphology. The results show that the PeLEDs containing perovskites with an excess of methylammonium bromide (MABr) to lead bromide (PbBr2) in a 2:1 ratio and a layer thickness of 80 nm have the highes…
Hybrid organic-inorganic light emitting diodes: effect of the metal oxide
2010
Hybrid organic-inorganic light emitting diodes (HyLEDs), employing metal oxides as the electron injecting contacts, are interesting as an alternative to OLEDs. Until recently, the metal oxide of choice was either titanium dioxide or zinc oxide. In this work two wide bandgap metal oxides, HfO2 and MgO, are employed as electron injecting layer in HyLEDs. It is demonstrated that both the current density and the luminance values obtained are directly related to the barriers for electron injection (from the ITO to the metal oxide) and for hole transfer to the same metal oxide, outlining a new design rule for the optimization of HyLEDs. Record device efficacies (3.3 cd/A, >10000 cd/m2) using the …
Logic gates using nanofluidic diodes based on conical nanopores functionalized with polyprotic acid chains.
2009
Single-track conical nanopores functionalized with polyprotic acid chains have pH-sensitive fixed charge groups and show three levels of conductance that allow integrating several functions on a single nanofluidic diode. Nanometer-scaled pores have previously been employed in separation and sensing but not in logic devices, despite the fact that biological ion channels with pH-dependent fixed charges are known to be responsible for information processing in biophysical structures. As a preliminary application, we propose a logic gate scheme where binary and multivalued logical functions are implemented.