Search results for "Electrical Circuits"
showing 10 items of 91 documents
Active snubber network design and implementation on the primary side of an isolated Ćuk converter realizing soft-switching for efficiency …
2008
This paper describes the process of improving the efficiency of an existing isolated DC/DC converter based on CUK topology with secondary side synchronous rectification, by means of the introduction of an active snubber network on the primary side. The snubber circuit reduces to zero the switching losses during the off-time interval of secondary SR. In particular, the efficiency improvement is due to the elimination of the primary MOSFET Coss output capacitance losses, and mainly of the reverse recovery losses on the secondary SR MOSFET. However, the insertion of the active snubber creates itself additional losses in the circuit, and therefore to measure the really introduced benefit it is …
Designing Frame Relay WAN Networks with Trade-Off between Link Cost and Performance
2014
This paper is focused on the problem of designing a Wide Area Network topology with trade-off between link cost and response time to users. The L2 technology chosen for the research is a Frame Relay based solution. The link capacities in the network and the routes used by packets are determined in a way to minimize network cost and response time at the same time. In FR networks link capacity corresponds directly to CIR parameter which makes the presented numerical results very useful in practice, especially during preliminary network design in the Design Phase of the PPDIOO methodology.
Demonstration of background rejection using deep convolutional neural networks in the NEXT experiment
2021
[EN] Convolutional neural networks (CNNs) are widely used state-of-the-art computer vision tools that are becoming increasingly popular in high-energy physics. In this paper, we attempt to understand the potential of CNNs for event classification in the NEXT experiment, which will search for neutrinoless double-beta decay in Xe-136. To do so, we demonstrate the usage of CNNs for the identification of electron-positron pair production events, which exhibit a topology similar to that of a neutrinoless double-beta decay event. These events were produced in the NEXT-White high-pressure xenon TPC using 2.6 MeV gamma rays from a Th-228 calibration source. We train a network on Monte Carlo-simulat…
A dynamic load-balancing algorithm for molecular dynamics simulation on multi-processor systems
1991
Abstract A new algorithm for dynamic load-balancing on multi-processor systems and its application to the molecular dynamics simulation of the spinodal phase separation are presented. The load-balancer is distributed among the processors and embedded in the application itself. Tests performed on a transputer network show that the load-balancer behaves almost ideally in this application. The same approach can be easily extended to different multi-processor topologies or applications.
Optimal Integration of Hybrid Supercapacitor and IPT System for a Free-Catenary Tramway
2019
The aim of the paper is the study of an optimal integration of a supercapacitor-based storage system and inductive power transfer system for the free-catenary operation of a tramway. Starting from the definition of the topology of inductive power transfer system, we propose and analyze a design procedure for the pads of the inductive power system. In the second part of the paper, an optimal integration strategy for the correct size of on-board supercapacitors and the power of the inductive energy transfer are proposed. The results obtained by means of numerical simulations are discussed. © 2018 IEEE.
A hierarchical architecture for increasing efficiency of large photovoltaic plants under non-homogeneous solar irradiation
2019
Abstract Under non-homogeneous solar irradiation, photovoltaic (PV) panels receive different solar irradiance, resulting in a decrease in efficiency of the PV generation system. There are a few technical options to fix this issue that goes under the name of mismatch. One of these is the reconfiguration of the PV generation system, namely changing the connections of the PV panels from the initial configuration to the optimal one. Such technique has been widely considered for small systems, due to the excessive number of required switches. In this paper, the authors propose a new method for increasing the efficiency of large PV systems under non-homogeneous solar irradiation using Series-Para…
Technical and economical comparison between different topologies of PV plant under mismatch effect
2014
This paper presents a technical and economical comparative analysis between two topology of photovoltaic plant. In particular the performances of series-parallel (SP) and total cross tied (TCT), topologies are taken into account, referring to a partially shaded photovoltaic plant. Thanks to a simulation model developed, in the paper the mismatch effects due to three different shading conditions, for SP and TCT topology plant, are quantified. Since the TCT solution, even though increase the energy production, raise the complexity of plants as well as their costs, an evaluation of the individual costs of each component of a SP and TCT plant topology, as PV modules, support structure, inverter…
Topology of multiplex heterogeneous networks of Hodgkin-Huxley-type of models with bistability leading to stabilization stable equilibrium
2021
The dynamics of a multiplex heterogeneous networks of oscillators is studied. Two types of very similar models based on the Hodgkin-Huxley formalism are used as the basic elements of the network: the first one demonstrates bursting oscillations; the second one manifests bistability between bursting oscillations and stable equilibrium. Multiplex networks were developed and investigated, assuming more active communication between models with bistability. Different topologies of the networks are studied. It is shown that in this case it is enough to have one element with bistability in the subnetworks in order to stabilize the equilibrium state in the entire network.
On the design of a multiple-output DC/DC converter for the PHI experiment on-board of solar orbiter
2013
Power converters for experiments that have to fly on board space missions (satellite, launchers, etc.) have very stringent requirements due to its use in a very harsh environment. The selection of a suitable topology is therefore not only based on standard requirements but additional more strict ones have also to be fulfilled. This work shows the design procedure followed to build the Power Converter Module (PCM) for the Polarimetric and Helioseismic Imager (SO/PHI), experiment on board the Solar Orbiter Satellite. The selected topology has been a Push-Pull, for a power level of approximately 35 W and with seven output voltages. Galvanic isolation is needed from primary to secondary, but no…
Tapered Two-Wire Waveguide for Time-Domain Integration of Broadband Terahertz Pulses
2021
We show the time-domain integration of terahertz pulses achieved in a sub-wavelength, tapered two-wire waveguide. Both simulation and experimental results prove the time integration functionality of this waveguide topology.