Search results for "Energy"

showing 10 items of 30133 documents

ABSOLUTE THERMOELECTRIC POWER OF Pb–Sn ALLOYS

2011

International audience; In this work, absolute thermoelectric power (ATP) of Pb, Sn, Pb-20 wt.% Sn, Pb-40 wt.% Sn, Pb-60 wt.% Sn, Pb-80 wt.% Sn are measured. Measurements are performed in a temperature gradient furnace from 20 degrees C to 500 degrees C, for both solid and liquid states. Temperatures are measured with T-type copper-constantan thermocouples, while voltage signal between copper electrodes of those thermocouples is recorded in order to calculate ATP of the sample metal.

010302 applied physicsMaterials scienceAnalytical chemistryStatistical and Nonlinear Physics[CHIM.MATE]Chemical Sciences/Material chemistry02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter Physics7. Clean energy01 natural sciencesMetalCopper electrodeTemperature gradientThermocouplevisual_artSeebeck coefficient0103 physical sciencesvisual_art.visual_art_medium0210 nano-technologyVoltageModern Physics Letters B
researchProduct

Ultra-Wide Band Gap in Two-Dimensional Phononic Crystal with Combined Convex and Concave Holes

2017

A phononic crystal with an ultra‐wide band gap is proposed, whose unit cell consists of a cross‐like concave hole in the center and four square convex holes at the corners. The dispersion relations, modal kinetic energy ratio, and eigenmodes at edges of the band gaps are investigated by using the finite element method. The influence of the geometrical parameters of the convex and concave holes on the band gaps is further analyzed. After optimization, an ultra‐wide band gap with gap‐to‐midgap ratio of 156.0% is achieved, with the filling fraction keeping a relative small value. Numerical results illustrate that the combination of convex and concave holes is a practicable direction for struct…

010302 applied physicsMaterials scienceCondensed matter physicsBand gapRegular polygonUltra-wideband02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter PhysicsKinetic energy01 natural sciencesSquare (algebra)Finite element methodCrystalDispersion relation0103 physical sciencesGeneral Materials Science0210 nano-technologyphysica status solidi (RRL) - Rapid Research Letters
researchProduct

Half-Heusler materials as model systems for phase-separated thermoelectrics

2015

Semiconducting half-Heusler compounds based on NiSn and CoSb have attracted attention because of their good performance as thermoelectric materials. Nanostructuring of the materials was experimentally established through phase separation in (T1−x′Tx″)T(M1−yMy′) alloys when mixing different transition metals (T, T′, T″) or main group elements (M, M′). The electric transport properties of such alloys depend not only on their micro- or nanostructure but also on the atomic-scale electronic structure. In the present work, the influence of the band structure and density of states on the electronic transport and thermoelectric properties is investigated in detail for the constituents of phase-sepa…

010302 applied physicsMaterials scienceCondensed matter physicsFermi energy02 engineering and technologySurfaces and InterfacesElectronic structureCubic crystal system021001 nanoscience & nanotechnologyCondensed Matter PhysicsThermoelectric materials01 natural sciencesSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsPhase (matter)0103 physical sciencesThermoelectric effectMaterials ChemistryDensity of statesElectrical and Electronic Engineering0210 nano-technologyElectronic band structurephysica status solidi (a)
researchProduct

Acoustic vibrations of monoclinic zirconia nanocrystals

2011

International audience; Polarized low-frequency Raman spectra originating from confined acoustic vibrations are reported for monoclinic ZrO2 nanoparticles with a narrow size distribution synthesized from a continuous supercritical water process. The monoclinic lattice structure is taken into account for the interpretation of the spectra by comparing with isotropic and anisotropic continuum elasticity calculations for monodomain nanocrystals. The various mechanisms leading to the broadening of the Raman peaks are discussed. We demonstrate that an accurate determination of the size distribution of the nanoparticles is possible using the Raman peak due to the fundamental breathing vibration wh…

010302 applied physicsMaterials scienceCondensed matter physicsIsotropy[ PHYS.COND.CM-MS ] Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]02 engineering and technologyCrystal structure021001 nanoscience & nanotechnology01 natural sciencesSpectral lineSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsCrystallographysymbols.namesakeGeneral Energy0103 physical sciencessymbols[PHYS.COND.CM-MS]Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]Cubic zirconiaPhysical and Theoretical ChemistryElasticity (economics)0210 nano-technologyAnisotropyRaman spectroscopyMonoclinic crystal system
researchProduct

Influence of magnetization on the applied magnetic field in various AMR regenerators

2017

International audience; The aim of this work is to assess the influence of a magnetic sample on the applied magnetic field inside the air gap of a magnetic circuit. Different magnetic sources including an electromagnet, a permanent magnet in a soft ferromagnetic toroidal yoke, as well as 2D and 3D Halbach cylinders are considered, using a numerical model. Gadolinium is chosen as magnetic material for the sample, due to its strong magnetocaloric properties and its wide use in magnetic refrigeration prototypes. We find that using uniform theoretical demagnetizing factors for cylinders or spheres results in a deviation of less than 2% in the calculation of internal magnetic fields at temperatu…

010302 applied physicsMaterials scienceElectromagnetMagnetic domainMagnetic energyCondensed matter physics[SPI.NRJ]Engineering Sciences [physics]/Electric powerDemagnetizing fieldGeneral Physics and Astronomy02 engineering and technology021001 nanoscience & nanotechnology01 natural sciences[SPI.AUTO]Engineering Sciences [physics]/Automaticlaw.inventionCondensed Matter::Materials ScienceMagnetizationRemanencelaw0103 physical sciences[PHYS.MECA.THER]Physics [physics]/Mechanics [physics]/Thermics [physics.class-ph]Magnetic pressure[PHYS.MECA.MEFL]Physics [physics]/Mechanics [physics]/Fluid mechanics [physics.class-ph]Single domain0210 nano-technologyJournal of Applied Physics
researchProduct

Structural characterization of TiO2/TiN O (δ-doping) heterostructures on (1 1 0)TiO2 substrates

2003

Abstract TiO2/TiNxOy δ-doping structures were grown on the top of (1 1 0)TiO2 rutile substrates by low pressure metal-organic vapor phase epitaxy (LP-MOVPE) technique at 750 °C. The samples were analyzed by high resolution transmission electron microscopy (HRTEM), electron energy loss spectroscopy (EELS) and X-ray diffraction techniques (rocking curves and φ-scans). The presence of satellites in the (1 1 0)TiO2 rocking curve revealed the epitaxial growth of 10 period δ-doping structures. The thickness of the TiO2 layers, 84 nm, was deduced from the satellites period. HRTEM observations showed around 1.5 nm thick δ-doping layers, where the presence of nitrogen was detected by EELS. The analy…

010302 applied physicsMaterials scienceElectron energy loss spectroscopyGeneral Physics and Astronomy02 engineering and technologySurfaces and InterfacesGeneral Chemistry021001 nanoscience & nanotechnologyCondensed Matter PhysicsEpitaxy01 natural sciencesElectron spectroscopySurfaces Coatings and FilmsCrystallographySurface coatingTransmission electron microscopy0103 physical sciencesX-ray crystallography[PHYS.COND.CM-MS]Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]Metalorganic vapour phase epitaxy0210 nano-technologyHigh-resolution transmission electron microscopyComputingMilieux_MISCELLANEOUS
researchProduct

How activator ion concentration affects spectroscopic properties on Ba4Y3F17: Er3+, Yb3+, a new perspective up-conversion material

2018

Abstract Ba4Y3F17 with Er3+ and Yb3+, a promising material for up-conversion luminescence, was synthesized. Excellent isomorphic capacity was detected. Low-temperature measurements show that erbium ions are incorporated in multiple lattice positions, which is inconsistent with the current model of Ba4Y3F17 crystal lattice structure. Activator ion concentration has a different impact on 4S3/2 and 4F9/2, states (for the green and red luminescence, respectively) depopulation. Energy transfer from Er3+ 4S3/2 state to Yb3+ is observed even at low temperature (15 K) while Er-Er cross-relaxation is observed from 120 K and above. Yb3+ concentration has a great impact to red-to-green up-conversion l…

010302 applied physicsMaterials scienceEnergy transferBiophysicsAnalytical chemistryQuantum yield02 engineering and technologyGeneral ChemistryCrystal structure021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesBiochemistryAtomic and Molecular Physics and OpticsIonLattice (order)0103 physical sciencesActivator (phosphor)Up conversion0210 nano-technologyLuminescenceJournal of Luminescence
researchProduct

A quartz amplifier for high-sensitivity Fourier-transform ion-cyclotron-resonance measurements with trapped ions

2019

Single-ion sensitivity is obtained in precision Penning-trap experiments devoted to light (anti)particles or ions with low mass-to-charge ratios, by adding an inductance coil to an amplifier connected to the trap, both operated at 4 K. However, single-ion sensitivity has not been reached on heavy singly or doubly charged ions. In this publication, we present a new system to reach this point, based on the use of a quartz crystal as an inductance, together with a newly developed broad-band (BB) amplifier. We detect the reduced-cyclotron frequency of 40Ca+ ions stored in a 7-tesla open-ring Penning trap. By comparing the detected electric signal obtained with the BB amplifier and the fluoresce…

010302 applied physicsMaterials scienceEquivalent series resistanceAmplifierPenning trap01 natural sciences7. Clean energySignalFourier transform ion cyclotron resonance010305 fluids & plasmasIonCrystal0103 physical sciencesAtomic physicsInstrumentationSensitivity (electronics)Review of Scientific Instruments
researchProduct

Melting temperature prediction by thermoelastic instability: An ab initio modelling, for periclase (MgO)

2021

Abstract Melting temperature (TM) is a crucial physical property of solids and plays an important role for the characterization of materials, allowing us to understand their behavior at non-ambient conditions. The present investigation aims i) to provide a physically sound basis to the estimation of TM through a “critical temperature” (TC), which signals the onset of thermodynamic instability due to a change of the isothermal bulk modulus from positive to negative at a given PC-VC-TC point, such that (∂P/∂V)VC,TC = -(∂2F/∂V2) VC,TC = 0; ii) to discuss the case of periclase (MgO), for which accurate melting temperature observations as a function of pressure are available. Using first princip…

010302 applied physicsMaterials scienceGeneral Chemical EngineeringAnharmonicity0211 other engineering and technologiesAb initioThermodynamics02 engineering and technologyGeneral ChemistryFunction (mathematics)engineering.material01 natural sciencesInstabilityComputer Science ApplicationsPhysical propertysymbols.namesakeThermoelastic dampingHelmholtz free energy0103 physical sciencessymbolsengineeringPericlase021102 mining & metallurgy
researchProduct

Experimental evidence on photo-assisted O− ion production from Al2O3 cathode in cesium sputter negative ion source

2020

The production of negative ions in cesium sputter ion sources is generally considered to be a pure surface process. It has been recently proposed that ion pair production could explain the higher-than-expected beam currents extracted from these ion sources, therefore opening the door for laser-assisted enhancement of the negative ion yield. We have tested this hypothesis by measuring the effect of various pulsed diode lasers on the O − beam current produced from Al 2O 3 cathode of a cesium sputter ion source. It is expected that the ion pair production of O − requires populating the 5d electronic states of neutral cesium, thus implying that the process should be provoked only with specific …

010302 applied physicsMaterials scienceGeneral Physics and Astronomy02 engineering and technologyPhoton energy021001 nanoscience & nanotechnologyLaser01 natural sciencesCathodeIon sourceIonlaw.inventionPhysics::Plasma PhysicslawSputtering0103 physical sciencesAtomic physics0210 nano-technologyBeam (structure)DiodeJournal of Applied Physics
researchProduct