Search results for "IRRADIANCE"
showing 10 items of 152 documents
Experimental characterization of Ruthenium-based Dye Sensitized Solar Cells and study of light-soaking effect impact on performance
2016
In this paper, we present an experimental investigation on the performance of Ruthenium-based Dye Sensitized Solar Cells (DSSCs) at different irradiance levels, incident wavelengths and hours of illumination. In particular, the measurements have been aimed at studying the performance variation due to light soaking effect since this phenomenon has noteworthy practical implications, such as stability tests of DSSCs. Our results show that the short circuit current density, the open circuit voltage and the conversion efficiency η increase with the hours of light soaking. Finally, the observed phenomenon is reversible, and thus the performance decreases again when the cell is kept in the dark.
Characterization of laser ablation of copper in the irradiance regime of laser-induced breakdown spectroscopy analysis
2014
Abstract The LIBS signal depends both on the ablated mass and on the plasma excitation temperature. These fundamental parameters depend in a complex manner on laser ablation and on laser–plasma coupling. As several works in the literature suggest that laser ablation processes play a predominant role compared to plasma heating phenomena in the LIBS signal variations, this paper focuses on the study of laser ablation. The objective was to determine an interaction regime enabling to maximally control the laser ablation. Nanosecond laser ablation of copper at 266 nm was characterized by scanning electron microscopy and optical profilometry analysis, in air at 1 bar and in the vacuum. The laser …
FluorMODgui V3.0 : a graphic user interface for the spectral simulation of leaf and canopy chlorophyll fluorescence
2006
The FluorMODgui Graphic User Interface (GUI) software package developed within the frame of the FluorMOD project Development of a Vegetation Fluorescence Canopy Model is presented in this manuscript. The FluorMOD project was launched in 2002 by the European Space Agency (ESA) to advance the science of vegetation fluorescence simulation through the development and integration of leaf and canopy fluorescence models based on physical methods. The design of airborne or space missions dedicated to the measurement of solar-induced chlorophyll fluorescence using remote-sensing instruments require physical methods for quantitative feasibility analysis and sensor specification studies. The FluorMODg…
Influence of low power CW laser irradiation on skin hemoglobin changes
2012
Influence of low power laser irradiance on healthy skin using diffuse reflectance spectroscopy and multispectral imaging was studied. Changes of diffuse reflectance spectra in spectral range from 500 to 600 nm were observed after 405 nm, 473 nm and 532 nm laser provocation, leading to conclusion that the content of skin hemoglobin has changed. Peaks in spectral absorbance (optical density) curves corresponded to well-known oxy-hemoglobin absorbance peaks at 542 and 577 nm.
Production of hydrogen negative ions in an ECR volume source: balance between vibrational excitation and ionization
2018
International audience; The operation of an ECR-driven (2.45 GHz) hydrogen negative ion source is studied. Electron densities and temperatures are investigated with electrostatic probes and negative ion densities are measured with laser photodetachment. Vacuum ultraviolet irradiance measurements are focused on molecular transitions to the ground state while high-resolution visible emission spectroscopy is used to study the transitions between excited states for both molecules and atoms. The standalone operation of the source is found to be more efficient in higher pressures (12 mTorr) where negative ion densities are as high as 4×109 cm−3. Further investigation on the operation of the sou…
Modeling and parameter identification of crystalline silicon photovoltaic devices
2011
This paper tests the standard single-exponential model of the electrical characteristics of crystalline-Si photovoltaic devices, focusing on the (apparent) shunt current. Measured characteristics of illuminated polycrystalline-Si photovoltaic modules are modeled, and the apparent shunt current is analyzed. It is shown that an Ohmic-like behavior only takes place at voltages well below the maximum-power point. At higher voltages, the apparent shunt current quickly drops to negligible values. Modeling a crystalline-Si PV device with a fixed shunt resistance may therefore lead to underestimation of the maximum power exceeding 10% at certain irradiance levels.
Modeling and parameter identification of crystalline silicon photovoltaic devices
2011
In this paper the physical correctness of the standard single-exponential (one-diode) model of crystalline-Si photovoltaic devices is examined. In particular, we focus on the shunt current. I-V curves of in situ illuminated polycrystalline-Si photovoltaic modules are measured, and based on these measurements, we extract the shunt current. There is a certain voltage range in which the shunt current shows an Ohmic-like behavior, but the value of the resistance varies with irradiance and the quality of illumination. In addition, the Ohmic behavior takes place at voltages well below the maximum-power point (MPP). At higher voltages, the shunt current drops to negligible values. We conclude that…
Laser Beam Induced Current measurements on Dye Sensitized Solar Cells and thin film CIG(S,SE)<inf>2</inf> modules
2017
Calculating the efficiency of a solar cell depends on a precise knowledge of its area. Indeed, the photoresponse uniformity is essential to improve the manufacturing process. In this work we report on Laser Beam Induced Current measurements performed on CIG(S,Se) 2 modules and Dye Sensitized Solar Cells. These measurements, performed via a green and a red HeNe lasers both operating at an optical irradiance of 1 Sun, allowed to obtain an accurate photoresponse map of the specimens and highlighted the non-uniformities with a spatial resolution of 400 µm and 80 µm, respectively.
Irradiance Dependent Temperature Coefficients for MC Solar Cells from Elkem Solar Grade Silicon in Comparison with Reference Polysilicon
2014
Abstract An increase in sun intensity enhances the output power of the solar cells, but at the same time the rise of cell temperature affects its electrical performance negatively. The present authors have made a comparative study on temperature coefficients at various irradiances of multicrystalline solar cells made from the standard Siemens process and from material produced by a metallurgical route – the Elkem Solar Silicon (ESS®) process. Such temperature coefficients measured while exposed to various irradiance levels are essential to build a better understanding and prediction of field performance of solar cells manufactured from various feedstock types. In the current experiment, the…
Investigation of temperature coefficients of PV modules through field measured data
2021
Abstract Varying broadband irradiance and temperature are generally known as the major factors influencing the performance of PV modules, but studies have also shown the substantial impact of spectral variations. In this work, a simple and efficient method to calculate the temperature coefficient using long term data is demonstrated. Temperature coefficients of PV modules are estimated from long term performance data following IEC 60891 standard with additional spectral correction, and are compared against the datasheet values. Significant improvement of correlation coefficient from −0.89 to −0.97 is observed during the regression for maximum power temperature coefficient of two poly-crysta…