Search results for "Microscale chemistry"

2019

A probabilistic discrete model for 2D protein crystal growth is presented. This model takesinto account the available space and can describe growing processes of a different nature due to theversatility of its parameters, which gives the model great flexibility. The accuracy of the simulation istested against a real recrystallization experiment, carried out with the bacterial protein SbpA fromLysinibacillus sphaericus CCM2177, showing high agreement between the proposed model and theactual images of the crystal growth. Finally, it is also discussed how the regularity of the interface(i.e., the curve that separates the crystal from the substrate) affects the evolution of the simulation.

Numerical model for the shear rheology of two-dimensional wet foams with deformable bubbles

2014

Shearing of two-dimensional wet foam is simulated using an introduced numerical model, and results are compared to those of experiments. This model features realistically deformable bubbles, which distinguishes it from previously used models for wet foam. The internal bubble dynamics and their contact interactions are also separated in the model, making it possible to investigate the effects of the related microscale properties of the model on the macroscale phenomena. Validity of model assumptions was proved here by agreement between the simulated and measured Herschel-Bulkley rheology, and shear-induced relaxation times. This model also suggests a relationship between the shear stress and…

The use of microcapillary techniques to study the corrosion resistance of AZ91 magnesium alloy at the microscale

2011

Abstract The AZ91 alloy is composed of Mg 17 (Al, Zn) 12 precipitates, an eutectic phase around these precipitates, AlMn intermetallic particles and an α-Mg solid solution (matrix). The corrosion behaviour of AZ91 was investigated at the microscale by means of the electrochemical microcell technique, which uses extremely small capillaries (diameters between 5 and 10 μm). Experiments were conducted in 0.1 M NaClO 4 at 25 °C. The β-Mg 17 (Al, Zn) 12 precipitates were found to have the highest corrosion resistance, whereas the eutectic phase was very active (pitting potential of approximately −1400 mV vs. Ag/AgCl). The α-Mg solid solution displayed better corrosion resistance than the eutectic…

Effect of microstructure and chemical composition on localized corrosion resistance of a AISI 304L stainless steel after nanopulsed-laser surface mel…

2015

Abstract Changes induced in the surface properties of AISI 304L stainless steel when it is treated with a nanopulsed ytterbium-doped fiber laser were investigated to determine the microscale distribution of its physico-chemical properties. A Gaussian energy distribution was created with a radius of 71 μm (1/e2) at the focal point. Local investigations were carried out using transmission electron microscopy to consider the effect of overlapping individual laser impacts. The results obtained reveal that laser surface melting leads to changes in the crystallographic structure of the steel through the formation of a δ-ferritic phase. It also results in the creation of an oxide layer that increa…

Lattice Boltzmann simulations in microfluidics: probing the no-slip boundary condition in hydrophobic, rough, and surface nanobubble laden microchann…

2009

In this contribution we review recent efforts on investigations of the effect of (apparent) boundary slip by utilizing lattice Boltzmann simulations. We demonstrate the applicability of the method to treat fundamental questions in microfluidics by investigating fluid flow in hydrophobic and rough microchannels as well as over surfaces covered by nano- or microscale gas bubbles.

Resistive switching in microscale anodic titanium dioxide-based memristors

2018

Licence CC BY-NC-ND The potentiality of anodic TiO2 as an oxide material for the realization of resistive switching memory cells has been explored in this paper. Cu/anodic-TiO2/Ti memristors of different sizes, ranging from 1 × 1 μm2 to 10 × 10 μm2 have been fabricated and characterized. The oxide films were grown by anodizing Ti films, using three different process conditions. Measured IV curves have shown similar asymmetric bipolar hysteresis behaviors in all the tested devices, with a gradual switching from the high resistance state to the low resistance state and vice versa, and a R_OFF/R_ON ratio of 80 for the thickest oxide film devices.

X-ray micro-tomography based FEM modelling of hygroexpansion in PLA composites reinforced with birch pulp fibres

2017

This article presents a microscale modelling approach coupled with X-ray computed micro-tomography for the evaluation of material properties of polylactic acid (PLA) reinforced by birch pulp fibers under the effect of moisture. The results in terms of elastic moduli and hygroexpansion deformation were found in good agreement with the measurements taken at different levels of water uptake.

Femtosecond laser fragmentation from water-dispersed microcolloids: toward fast controllable growth of ultrapure Si-based nanomaterials for biologica…

2020

International audience; An ultrashort laser-assisted method for fast production of concentrated aqueous solutions of ultrapure Si-based colloidal nanoparticles is reported. The method profits from the 3D geometry of femtosecond laser ablation of water-dispersed microscale colloids, prepared preliminarily by the mechanical milling of a Si wafer, in order to avoid strong concentration gradients in the ablated material and provide similar conditions of nanocluster growth within a relatively large laser caustics volume. We demonstrate the possibility for the fast synthesis of non-aggregated, low-size-dispersed, crystalline Si-based nanoparticles, whose size and surface oxidation can be controll…

Real-time monitoring of graphene patterning with wide-field four-wave mixing microscopy

2016

The single atom thick two-dimensional graphene is a promising material for various applications due to its extraordinary electronic, optical, optoelectronic, and mechanical properties. The demand for developing graphene based applications has entailed a requirement for development of methods for fast imaging techniques for graphene. Here, we demonstrate imaging of graphene with femtosecond wide-field four-wave mixing microscopy. The method provides a sensitive, non-destructive approach for rapid large area characterization of graphene. We show that the method is suitable for online following of a laser patterning process of microscale structures on single-layer graphene. peerReviewed

Promising Dendritic Materials: An Introduction to Hyperbranched Polymers

2011

In nature and universe from living to nonliving things, branching occurs anywhere and anytime, such as the Crab Nebula, forked lightning, river basins, trees, nerves, veins, snow crystals, nervures, and proteoglycan ranging from light-years to kilometers, and to microscale and nanoscales (see Figure 1.1 for selected branching patterns). Hence, branching is a general and important phenomenon that could result in faster and more efficient transfer, dissipation, and distribution of energy and/or matter.