Search results for "Microscopy"

Localization of Ca(2+)-stores and tissue compartments with a Ca(2+)-binding capacity in the organ of Corti of the guinea-pig by electron energy-loss …

1992

SUMMARY The addition of 10 mM CaCl2 to glutaraldehyde fixative leads to the formation of small electron-dense deposits in the organ of Corti of the guinea-pig. These precipitates are mainly attached to cell membranes in contact with different extracellular lymphatic fluids. A higher number of precipitates is localized in the acellular parts of tectorial and basilar membrane. Electron energy-loss spectroscopy (EELS) was used to determine the elemental composition of the deposits formed. The spectra showed a prominent signal at the Ca2+ L2,3 ionization edge. Oxygen could also be detected in all the precipitates analysed. EELS analysis of mitochondria of the inner and outer hair cells after co…

Alkaline hydrolysis/methylation-acetylation: a new technique for ultrastructural DNA cytochemistry.

1991

SUMMARY A new technique for the visualization of DNA-containing structures in electron microscopy is described. Samples of glutaraldehyde-fixed bone marrow from rats were subjected to alkaline hydrolysis to remove RNA and the phosphate of phospho-proteins, followed by a combined blockage of protein carboxyl and amino groups through methylation-acetylation. After uranyl acetate staining of epoxy-embedded ultrathin sections, chromatin from all cell types showed a highly selective and intense electron opacity. Staining methods for DNA were also positive in semithin sections. This simple procedure could be very useful in ultrastructural cytochemistry of DNA and chromatin.

2019

Atomic force microscopy (AFM) is today an established tool in imaging and determination of mechanical properties of biomaterials. Due to their complex organization, those materials show intricate properties such as viscoelasticity. Therefore, one has to consider that the loading rate at which the sample is probed will lead to different mechanical response (properties). In this work, we studied the dependence of the mechanical properties of endothelial cells on the loading rate using AFM in force spectroscopy mode. We employed a sharp, four-sided pyramidal indenter and loading rates ranging from 0.5 to 20 μm/s. In addition, by variation of the load (applied forces from 100 to 10,000 pN), the…

Reconstruction of 3D grain boundaries from rock thin sections, using an advanced polarised-light microscopy method

2017

Grain boundaries play a significant role in materials by initiating reactions and collecting impurities. Here we present FAGO (Fabric Analyser Grain boundary recOnstruction), a first step towards the automatic determination of three-dimensional (3D) grain boundary geometry using polarised light. The trace of the grain boundaries from 2D rock thin sections are determined primarily from data acquired using an automatic fabric analyser microscope and the FAME software (fabric analyser-based microstructure evaluation; Peternell and colleagues and Hammes and Peternell). Based on the Fabric Analyser G50's unique arrangement of nine differently oriented light sources the retardation can be determi…

Optical-sectioning improvement in two-color excitation scanning microscopy

2004

We present a new beam-shaping technique for two-color excitation fluorescence microscopy. We show that by simply inserting a properly designed shaded-ring filter in the illumination beam of smaller wavelength, it is possible to improve the effective optical sectioning capacity of such microscopes by 23%. Such an improvement is obtained at the expense of only a very small increasing of the overall energy in the point-spread-function sidelobes. The performance of this technique is illustrated by a numerical imaging simulation.

High-pass energy-filtered photoemission electron microscopy imaging of dopants in silicon.

2008

Differently doped areas in silicon can show strong electron-optical contrast in dependence on the dopant concentration and surface conditions. Photoemission electron microscopy is a powerful surface-sensitive technique suitable for fast imaging of doping-induced contrast in semiconductors. We report on the observation of Si (100) samples with n- and p-type doped patterns (with the dopant concentration varied from 10(16) to 10(19) cm(-3)) on a p- and n-type substrate (doped to 10(15) cm(-3)), respectively. A high-pass energy filter of the entire image enabled us to obtain spectroscopic information, i.e. quantified photo threshold and related photoyield differences depending on the doping lev…

Measuring (biological) materials mechanics with atomic force microscopy. 2. Influence of the loading rate and applied force (colloidal particles)

2020

Atomic force microscopy (AFM) is the most often used tool to study the mechanical properties of eukaryotic cells. Due to their complex assembly, cells show viscoelastic properties. When performing experiments, one has to consider the influence of both loading rate and maximum load on the measured mechanical properties. Here, we employed colloidal particles of various sizes (from 2 to 20 μm diameter) to perform force spectroscopy measurements on endothelial cells at loading rates varying from 0.1 to 50 μm/s, and maximum loads ranging from 1 to 25 nN. We were able to determine the non-linear dependence of cell viscoelastic properties on the loading rate which followed a weak power law. In add…

Photonic nanopatterns of gold nanostructures indicate the excitation of surface plasmon modes of a wavelength of 50-100 nm by scanning near-field opt…

2003

Scanning near-field optical microscopy images of metal nanostructures taken with the tetrahedral tip (T-tip) show a distribution of dark and bright spots at distances in the order of 25-50 nm. The images are interpreted as photonic nanopatterns defined as calculated scanning near-field optical microscopy images using a dipole serving as a light-emitting scanning near-field optical microscopy probe. Changing from a positive to a negative value of the dielectric function of a sample leads to the partition of one spot into several spots in the photonic nanopatterns, indicating the excitation of surface plasmons of a wavelength in the order of 50-100 nm in metal nanostructures.

Scanning probe microscopies applied to the study of the domain wall in a ferroelectric crystal.

2007

Summary Scanning near-field optical microscopy is capable of measuring the topography and optical signals at the same time. This fact makes this technique a valuable tool in the study of materials at nanometric scale and, in particular, of ferroelectric materials, as it permits the study of their domains structure without the need of chemical etching and, therefore, not damaging the surface (as will be demonstrated later). We have measured the scanning near-field optical microscopy transmission, as well as the topography, of an RbTiOPO4 single crystalline slab, which exhibits two different of macroscopic ferroelectric domains. A chemical selective etching has been performed to distinguish b…

Laboratory phase‐contrast nanotomography of unstained Bombus terrestris compound eyes

2021

Imaging the visual systems of bumblebees and other pollinating insects may increase understanding of their dependence on specific habitats and how they will be affected by climate change. Current high-resolution imaging methods are either limited to two dimensions (light- and electron microscopy) or have limited access (synchrotron radiation x-ray tomography). For x-ray imaging, heavy metal stains are often used to increase contrast. Here, we present micron-resolution imaging of compound eyes of buff-tailed bumblebees (Bombus terrestris) using a table-top x-ray nanotomography (nano-CT) system. By propagation-based phase-contrast imaging, the use of stains was avoided and the microanatomy co…