Search results for "Photoelectron spectroscopy"
showing 10 items of 439 documents
Chemical heterogeneities in nanometric titanomagnetites prepared by soft chemistry and studied ex situ : evidence for fe-segregation and oxidation ki…
2001
Nanocrystalline Fe-based spinels with composition Fe3-xTixO4 are synthesized using soft chemistry. Two steps are involved: precipitation in an aqueous solution followed by thermal annealing under a reducing mixture of N2/H2/H2O gases. Fe-segregation is found inside stoichiometric particles when the powders are studied ex situ; they exhibit a strong surface iron enrichment. This heterogeneity is related to kinetic effects linked to the difference of mobility between Fe2+ and Ti4+ cations during the partial oxidation of cations occurring ex situ. Stresses in the grains induced by oxidation govern the oxidation kinetics and lead to an abrupt compositional variation inside each particle. These…
In-situ characterisation of organosilane films formation on aluminium alloys by electrochemical quartz crystal microbalance and in-situ ellipsometry
2005
Abstract Organosilane pre-treatments have been studied intensively during the last years in order to replace hexavalent chromium conversion treatments. The aim of this study is to follow in-situ the formation of this organosilane layer in solution. Two in-situ techniques, spectroscopic ellipsometry and electrochemical quartz crystal microbalance, were used to investigate the mechanism and the kinetics of this protective film formation. In-situ measurements highlight that the organosilane film observed after the drying process is not formed into the solution, but during the emersion and drying step. Hence, it has been possible to characterise the presence of a very thin organosilane layer in…
Influence of annealing atmosphere on photoelectrochemical response of TiO2 nanotubes anodized under controlled hydrodynamic conditions
2021
[EN] The influence of three annealing atmospheres (air, nitrogen and argon) and the use of controlled hydrodynamic conditions (from 0 to 5000 rpm) on morphological, structural, chemical and photoelectrochemical properties of TiO2 nanotubes have been evaluated. For this purpose, different characterization techniques have been used: Field Emission Scanning Electron Microscopy, Raman Confocal Laser Spectroscopy, X-Ray Diffraction, X-Ray Photoelectron Spectroscopy, Incident Photon-to-electron Conversion Efficiency measurements, ultraviolet-visible absorption spectra, Mott-Schottky analysis and photoelectrochemical water splitting tests. According to the results, it can be concluded that both hy…
Superficial defects induced by argon and oxygen bombardments on (110) TiO2 surfaces
1998
Abstract Compositional and chemical changes of titanium dioxide monocrystalline surfaces induced by bombardment with 4 keV argon and oxygen ions have been studied by AES, XPS and AFM. Argon ion bombardment induced strong changes in the composition and chemical state of the surface: loss of oxygen due to preferential sputtering occurred, and, related to this, Ti4+ species were reduced to Ti3+ and Ti2+. During oxygen bombardment, competition between preferential sputtering of oxygen ions of the oxide surface and oxygen implantation was observed. This phenomenon was found to be strongly dependent upon the incidence angle of the oxygen ions. Moreover, an oxygen bombardment with normal incidence…
Ab initio angle- and energy-resolved photoelectron spectroscopy with time-dependent density-functional theory
2012
We present a time-dependent density-functional method able to describe the photoelectron spectrum of atoms and molecules when excited by laser pulses. This computationally feasible scheme is based on a geometrical partitioning that efficiently gives access to photoelectron spectroscopy in time-dependent density-functional calculations. By using a geometrical approach, we provide a simple description of momentum-resolved photoemission including multiphoton effects. The approach is validated by comparison with results in the literature and exact calculations. Furthermore, we present numerical photoelectron angular distributions for randomly oriented nitrogen molecules in a short near-infrared…
Metal-support and preparation influence on the structural and electronic properties of gold catalysts
2006
Abstract Nanostructured gold catalysts supported on CeO2 and SiO2 were prepared by the deposition–precipitation (DP) and the solvated metal atom dispersion (SMAD) techniques. The structural and electronic properties of the catalysts were investigated by X-ray diffraction (XRD), X-ray absorption spectroscopy (XAS) and X-ray photoelectron spectroscopy (XPS). Gold was found as small metal nanoparticles (cluster size ∼2 nm) in the SMAD-prepared samples and in ionic state in the DP catalysts. The catalytic activity of the samples was tested in the reaction of low temperature CO oxidation. Gold nanosized particles in a pure metallic state exhibited a worse catalytic performance, both on ceria and…
Surface spectroscopic study of the corrosion of ultrathin57Fe-evaporated and Langmuir-Blodgett films in humid SO2 environments
2000
Integral conversion electron Mossbauer spectroscopy (ICEMS), x-ray photoelectron spectroscopy (XPS), Auger electron spectroscopy (AES) and scanning electron microscopy (SEM) have been used to carry out a comparative study of the corrosion resistance against humid SO2-aggressive environments of ultrathin 57Fe films. These films, having a thickness ≤ 2.5 nm, have been prepared by evaporation of 57Fe under vacuum and by 57Fe coating by a Langmuir–Blodgett (LB) technique on SiO2/Si wafers. The results have shown that the corrosion resistance of the evaporated films is similar to that of massive Fe. However, the LB films show a remarkably higher corrosion resistance. Thus, although the Fe films …
Iron deposition on TiO2(110): effect of the surface stoichiometry and roughness
1999
Abstract Characterizations of ultra-thin iron films deposited on TiO 2 (110) surfaces with different stoichiometries, roughnesses and crystallinities have been carried out by X-ray photoelectron spectroscopy (XPS) and Auger electron spectroscopy (AES). For a high initial roughness of the substrate, a 2D growth mode is observed up to three monolayers. But, if the initial roughness is low, clusters grow on the TiO 2 surface. Whatever the initial surface stoichiometry, electronic exchanges occur between titanium and iron leading to a reduction of titanium and an oxidation of iron. This interaction between iron and titanium dioxide surface takes place only at the interface between the metal and…
Structural properties of the quaternary Heusler compound Co2 Cr1−x Fex Al
2006
Abstract The structural and chemical properties of the quaternary Heusler compound Co2 Cr1−x Fex Al were investigated comparing powder and bulk samples. The long range order was determined by means of X-ray diffraction, while the site specific (short range) order was proved by the extended X-ray absorption fine structure method (EXAFS). The chemical composition was analysed by means of X-ray photo emission spectroscopy (XPS) combined with Auger electron spectroscopy (AES) depth profiling. The results from these methods are compared to get a detailed idea about the differences between surface and bulk properties and appearance of disorder in such alloys.
Angular-resolved electron spectroscopy from (110) surfaces of ternary Ce-based intermetallics: CePd2Si2 and CeNi2Ge2
1997
Investigations of electronic properties were carried out for the ternary Ce-based intermetallic systems CeT2X2 (T = Ni, Pd; X = Ge, Si). To produce well-ordered and atomically clean surfaces, preparation is carried out in UHV. The polycrystalline substance was evaporated on a W(110) substrate with subsequent annealing. The single-crystalline layers obtained are characterised by MEED (thickness), AES (surface stoichiometry), LEED and SEM (surface structure). For electron-spectroscopic investigations, ARUPS (angle-resolved photoemission spectroscopy) was used. In the photoemission spectra, dispersion effects could be detected by variation of the detection angle.