Search results for "REAGENT"
showing 10 items of 699 documents
Evaluation and elimination of the “blank bias error” using the H-point standard addition method
1992
Abstract The basis of the H-point standard addition method in the cases where the analyte determination requires the use of an absorbent reagent is considered. The method evaluates and eliminates the blank bias error present in such procedures by using the absorbance increment at two selected wavelengths as the analytical signal of the calibration graphs. Three different determinations were tested: the determination of proteins with the biuret method, thorium with thoron and of magnesium with Titan Yellow. These procedures are better described by the proposed method than by the traditional approach using absorbance values against reagent blank.
Sub- and supercritical fluid extraction of trichloropyridinol from soil prior to immunoassay
1997
A comparative study on the extraction of TCP (3,5,6-trichloro-2-pyridinol, a metabolite of chlorpyrifos) from soil with CO2 and H2O is reported. The polarity of the analyte requires the presence of both a cosolvent (methanol) and an ion-pair reagent [(1R)-(-)-10-camphorsulfonic acid ammonium salt] for 95% extraction in 30 min when supercritical CO2 at 40 degrees C and 383 bar is used as extractant. Subcritical water (250 degrees C and 200 bar) enables complete extraction within 15 min without additives. Quantitation of the target analyte is performed by specific immunoassay using a non-commercial monoclonal antibody which provides a linear determination range between 0.005 and 5 micrograms/…
On-Line Derivatization into Precolumns for the Determination of Drugs by Liquid Chromatography and Column Switching: Determination of Amphetamines i…
1996
A chromatographic system for the on-line derivatization of drugs using column switching is described. The system uses a 20 mm × 2.1 mm i.d. precolumn packed with a unmodified ODS stationary phase. This column is used for sample cleanup and enrichment of the analytes. Next, the trapped analytes are derivatized by injection of the derivatization reagent into the precolumn. Finally, the derivatives are transferred to the analytical column for their separation under reversed-phase conditions. The influence of several parameters such as the reaction time, the amount of derivatization reagent, or the system design has been studied using some amphetamines as model compounds and three derivatizatio…
Evaluation and elimination of the blank bias error using the H-point standard additions method (HPSAM) in the simultaneous spectrophotometric determi…
1997
Abstract The aim of this report is to demonstrate the usefulness of the HPSAM in all instances where the determination of two analytes requires the use of an absorbent reagent, particularly when it does not present a constant analytical signal because of its consumption. This problem can be treated as a ternary mixture by the HPSAM method and then, the fundamentals of the method for resolving these kind of mixtures can be applied. The method can calculate the concentration of one species from spectral data at two wavelengths where the two other species present the same absorbance relationship. These wavelength pairs are easily found, and can be selected to give the most precise results. The…
o-Phthalaldehyde–N-acetylcysteine polyamine derivatives: formation and stability in solution and in C18 supports
2001
A comparative study of different derivatization procedures has been performed in order to improve the stability of the reaction products o-phthalaldehyde-N-acetylcysteine (OPA-NAC) polyamines. Procedures such as solution derivatization, solution derivatization followed by retention on a packing support, derivatization on different packing supports and on-column derivatization, have been optimized and compared. The degradation rate constant (k) of the derivative was dependent on the procedure used and on the analyte. For the spermine (the most unstable isoindol tested) k was 8 +/- 2 x 10(-2) min(-1) in solution versus 7.7 +/- 1.1 x 10(-4) min(-1) on the (C18) solid support. The results obtai…
Determination of the Herbicide Fluometuron by Photo‐induced Chemiluminescence in a Continuous‐flow Multicommutation Assembly
2007
Abstract This study was dealing with the chemiluminometric determination of the selective herbicide Fluometuron or 1,1‐dimethyl‐3‐(α,α,α‐trifluoro‐m‐tolyl)urea, (C10H11F3N2O) with a molecular weight 232.29 belongs to the phenyl urea herbicides family. The analytical strategy is based on the continuous‐flow manifold, multicommutation and the analyte pre‐treatment, the photo‐degradation. The optimization of chemical (pH, medium, temperature, and organized media) and hydrodynamic parameters (volume of reagents and flow rate) was performed by univariant and multiparametric simplex procedure respectively. Analytical figures of merit and the effect of foreign substances were studied. The method r…
Enhancement of retention predictions in reversed-phase liquid chromatography using reference compounds
2004
Abstract The use of reference compounds to correct errors associated with the preparation of mobile phase is studied, in order to enhance modelling of retention for optimisation purposes in reversed-phase liquid chromatography. The method fits individual retention models for a set of reference compounds, which are present in all injections. In second step, mobile-phase composition is corrected for each chromatogram, according to the fitted models of the reference compounds. The enhanced precision provided by the large number of replicates for the reference compounds is partially propagated to the retention models of the analytes. The approach is assayed in the separation of amino acids, aft…
Determination of titratable acidity and ascorbic acid in fruit juices in continuous-flow systems
1993
Two continuous-flow systems for the determination of titratable acidity and ascrobic acid in fruit juice samples are described. The assemblies permit on-line dialysis of analytes prior to the reaction step, thus improving selectivity and performing sample dilution. Flow systems are built with a channel carrying the donor phase (sample in both determinations) and another channel carrying an acceptor phase, both of them entering the dialyser. The outcoming stream transporting the dialysed sample fills the valve loop, permitting its injection into a carrier stream which continuously passes through the spectrophotometric detector. For the titratable acidity, acceptor phase and carrier are disti…
Application of solid-phase microextraction combined with derivatization to the enantiomeric determination of amphetamines.
2005
Abstract The utility of combining chiral derivatization and solid-phase microextraction (SPME) for the enantiomeric analysis of primary amphetamines by liquid chromatography has been investigated. Different derivatization/extraction strategies have been evaluated and compared using the chiral reagent o -phthaldialdehyde (OPA)– N -acetyl- l -cysteine (NAC) and fibres with a Carbowax-templated resin coating. Amphetamine, norephedrine and 3,4-methylenedioxyamphetamine (MDA) were used as model compounds. On the basis of the results obtained, a new method is presented based on the derivatization of the analytes in solution followed by SPME of the OPA–NAC derivatives formed. The proposed conditio…
A tailor-made nucleoside-based colourimetric probe of formic acid
2014
A ratiometric, specific probe of formic acid has been developed. It is based on intermolecular nucleobase-pairing of inosine-capped plasmonic nanoparticles to form nucleoside channels, which are destabilised by the analyte.