Search results for "SURFACE PLASMON"
showing 10 items of 393 documents
Surface plasmon-polariton amplifiers
2012
Propagation of surface plasmons at metal surfaces is receiving much interest nowadays because of its broad range of potential applications, like subwavelength photonics or biosensing. Although plasmonic devices achieve unique properties, surface plasmons suffer from high attenuation because of the absorption losses in the metal. This limitation can be overcome by providing the material adjacent to the metal with optical gain. Under these conditions, absorption losses are compensated and the propagation length of the plasmon is significantly increased. In this work, a review of plasmonic amplifiers is presented. To this end, the state of the art of such devices and the propagation characteri…
Effect of IL-13 receptor α2 levels on the biological activity of IL-13 variant R110Q
2007
Background IL-13 is a key cytokine associated with the asthmatic phenotype. IL-13 signals via its cognate receptor, a complex of IL-13 receptor (IL-13R) α 1 chain with IL-4 receptor α; however, a second protein, IL-13Rα2, also binds IL-13. Recently a polymorphic variant of IL-13 (R110Q) has been shown to be associated with atopy. Objective To investigate the binding properties of this IL-13 variant to its cognate receptors. Methods We used surface plasmon resonance to measure the binding kinetics of R110Q to its receptors. Primary human fibroblasts were grown from endobronchial biopsies obtained from volunteers. Receptor levels were measured by fluorescence-activated cell sorting. Results T…
Plasmonic effects of ultra-thin Mo films on hydrogenated amorphous Si photovoltaic cells
2012
We report on the improvement of short circuit current (JSC), fill factor (FF), and open circuit resistance (ROC) in hydrogenated amorphous silicon (a-Si:H) photovoltaic cells with a p-type/intrinsic/n-type structure, achieved by the addition of an ultra-thin molybdenum film between the p-type film and the transparent conductive oxide/glass substrate. For suitable conditions, improvements of ≈10% in average internal quantum efficiency and up to 5%–10% under standard illumination in JSC, FF, and ROC are observed. These are attributed to the excitation of surface plasmon polariton modes of the a-Si:H/Mo interface.
Plasmonic modes in molybdenum ultra-thin films suitable for hydrogenated amorphous silicon thin film solar cells
2014
We have recently demonstrated that molybdenum ultra-thin films interposed between hydrogenated amorphous silicon (a-Si:H) and SnO2:F transparent conductive oxide (TCO) in thin film solar cells show light trapping effects which enhance the solar cells performances. The effect of this improvement may be attributed to surface plasmon polariton (SPP) modes excited at the molybdenum interface by the solar radiation. In this paper we show direct evidence of such SPP modes in the case of the molybdenum/air interface by using the attenuated total reflection (ATR) technique, pioneered by Kretschmann, and we evaluate the dielectric constant of molybdenum at 660 nm. (C) 2013 The Authors. Published by …
Optical gain, spontaneous and stimulated emission of surface plasmon polaritons in confined plasmonic waveguide
2010
International audience; We develop a theoretical model to compute the local density of states in a confined plasmonic waveguide. Based on this model, we derive a simple formula with a clear physical interpretation for the lifetime modification of emitters embedded in the waveguide. The gain distribution within the active medium is then computed following the formalism developed in a recent work [Phys. Rev. B 78, 161401 (2008)], by taking rigorously into account the pump irradiance and emitters lifetime modifications in the system. We finally apply this formalism to describe gain–assisted propagation in a dielectric–loaded surface plasmon polariton waveguide.
Convection, diffusion and reaction in a surface-based biosensor: Modeling of cooperativity and binding site competition on the surface and in the hyd…
2005
We study theoretically the transport and kinetic processes underlying the operation of a biosensor (particularly the surface plasmon sensor "Biacore") used to study the surface binding kinetics of biomolecules in solution to immobilized receptors. Unlike previous studies, we concentrate mainly on the modeling of system-specific phenomena rather than on the influence of mass transport limitations on the intrinsic kinetic rate constants determined from binding data. In the first problem, the case of two-site binding where each receptor unit on the surface can accommodate two analyte molecules on two different sites is considered. One analyte molecule always binds first to a specific site. Sub…
Gold Nanorods as Plasmonic Sensors for Particle Diffusion.
2016
Plasmonic gold nanoparticles are normally used as sensor to detect analytes permanently bound to their surface. If the interaction between the analyte and the nanosensor surface is negligible, it only diffuses through the sensor’s sensing volume, causing a small temporal shift of the plasmon resonance position. By using a very sensitive and fast detection scheme, we are able to detect these small fluctuations in the plasmon resonance. With the help of a theoretical model consistent with our detection geometry, we determine the analyte’s diffusion coefficient. The method is verified by observing the trends upon changing diffusor size and medium viscosity, and the diffusion coefficients obtai…
In-tube solid phase microextraction coupled to miniaturized liquid chromatography for both, noble metal nanoparticle assessment and sensitive plasmon…
2021
Abstract Colorimetric localized surface plasmon resonance (LSPR) as analytical response is applied for a wide number of chemical sensors and biosensors. However, the dependence of different factors, such as size distribution of nanoparticles (NPs), shape, dielectric environment, inter-particle distance and matrix, among others, can provide non-reliable results by UV–vis spectrometry in complex matrices if NP assessment is not carried out, particularly at low levels of analyte concentrations. Miniaturized liquid chromatography, capillary (CapLC) and nano (NanoLC), coupled on line with in-tube solid phase microextraction (IT-SPME) is proposed for the first time for both, controlling suitabili…
Affinity Sensors for the Diagnosis of COVID-19
2021
The coronavirus disease 2019 (COVID-19) outbreak caused by severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) was proclaimed a global pandemic in March 2020. Reducing the dissemination rate, in particular by tracking the infected people and their contacts, is the main instrument against infection spreading. Therefore, the creation and implementation of fast, reliable and responsive methods suitable for the diagnosis of COVID-19 are required. These needs can be fulfilled using affinity sensors, which differ in applied detection methods and markers that are generating analytical signals. Recently, nucleic acid hybridization, antigen-antibody interaction, and change of reactive oxyge…
Multiplexed plasmon sensor for rapid label-free analyte detection.
2013
Efficient and cost-effective multiplexed detection schemes for proteins in small liquid samples would bring drastic advances to fields like disease detection or water quality monitoring. We present a novel multiplexed sensor with randomly deposited aptamer functionalized gold nanorods. The spectral position of plasmon resonances of individual nanorods, monitored by dark-field spectroscopy, respond specifically to different proteins. We demonstrate nanomolar sensitivity, sensor recycling, and the potential to upscale to hundreds or thousands of targets.