Search results for "Semiconductor"
showing 10 items of 974 documents
Corrosion behaviour of a highly alloyed austenitic alloy UB6 in contaminated phosphoric acid
2013
The influence of temperature (20–80°C) on the electrochemical behaviour of passive films anodically formed on UB6 stainless steel in phosphoric acid solution (5.5 M H3PO4) has been examined by using potentiodynamic curves, electrochemical impedance spectroscopy, and Mott-Schottky analysis. UB6 stainless steel in contaminated phosphoric acid is characterised by high interfacial impedance, thereby, illustrating its high corrosion resistance. The obtained results show that the films behave as n-type and p-type semiconductors in the potential range above and below the flat band potential, respectively. This behaviour is assumed to be the consequence of the semiconducting properties of the iron …
Relative Humidity Dependent Resistance Switching of Bi2S3Nanowires
2017
Electrical properties of Bi2S3nanowires grown using a single source precursor in anodic aluminum oxide templates are sensitive to the relative humidity in an inert gas environment. Dynamic sensing dependency is obtained and shows presence of spontaneous resistance switching effect between low and high relative humidity states. Employing the thermionic field emission theory, heights of Schottky barriers are estimated from the current-voltage characteristics and in relation to the humidity response. The change of Schottky barrier height is explained by local changes in physically adsorbed water molecules on the surface of the nanowire.
Dual-source vacuum deposition of pure and mixed halide 2D perovskites: thin film characterization and processing guidelines
2020
The dual-source vacuum deposition of 2D perovskite films of the type PEA2PbX4, (PEA = phenethylammonium and X = I−, Br−, or a combination of both) is presented. Low-temperature deposited 2D perovskite films showed high crystallinity with the expected trend of bandgap as a function of halide type and concentration. Importantly, we observed an unavoidable halide cross-contamination among different deposition runs, as well as a strong dependence of the material quality on the type of halide precursors used. These findings should be taken into account in the development of vacuum processing for low-dimensional mixed halide perovskites.
Quantum size confinement in gallium selenide nanosheets: band gap tunability versus stability limitation
2017
Abstract Gallium selenide is one of the most promising candidates to extend the window of band gap values provided by existing two-dimensional semiconductors deep into the visible potentially reaching the ultraviolet. However, the tunability of its band gap by means of quantum confinement effects is still unknown, probably due to poor nanosheet stability. Here, we demonstrate that the optical band gap band of GaSe nanosheets can be tuned by ∼120 meV from bulk to 8 nm thick. The luminescent response of very thin nanosheets (<8 nm) is strongly quenched due to early oxidation. Oxidation favors the emergence of sharp material nanospikes at the surface attributable to strain relaxation. Simul…
Effect of the precursor's stoichiometry on the optoelectronic properties of methylammonium lead bromide perovskites
2017
International audience; Methylammonium lead bromide (MAPbBr 3) perovskites have been widely studied in applications such as lasers and light-emitting diodes, thanks to their favorable bandgap, efficient charge transport, and the possibility of processing by simple solution methods. The film morphology has a large impact on the optical and electronic properties of the material; hence the deposition methods and the type of precursors used are crucial in the preparation of efficient optoelectronic devices. Here we studied the effect of the precursor´s stoichiometry of solution processed MAPbBr 3 thin films on their optical and electronic properties. We found a drastic effect of the stoichiomet…
Optical and photovoltaic properties of indium selenide thin films prepared by van der Waals epitaxy
2001
Indium selenide thin films have been grown on p-type gallium selenide single crystal substrates by van der Waals epitaxy. The use of two crucibles in the growth process has resulted in indium selenide films with physical properties closer to these of bulk indium selenide than those prepared by other techniques. The optical properties of the films have been studied by electroabsorption measurements. The band gap and its temperature dependence are very close to those of indium selenide single crystals. The width of the fundamental transition, even if larger than that of the pure single crystal material, decreases monotonously with temperature. Exciton peaks are not observed even at low temper…
Semiconducting properties of passive films and corrosion layers on weathering steel
2020
Abstract Anodic films were grown on Weathering Steel by potentiostatic polarization in slightly alkaline solution. The photoelectrochemical results reveal that they are n-type iron oxide with Eg = 2.0 eV. Rust layer grown by atmospheric corrosion are n-type semiconductors with a band gap higher than that estimated for the anodic film attributed to the formation of γ-lepidocrocite. The electrochemical impedance spectra allow to evidence that rust layers have a higher conductivity with respect to anodic films due to the presence of highly doped iron oxide layers. The use of Mott-Schottky theory to model the dependence of oxide capacitance as function of potential is critically discussed.
Photocurrent spectroscopy in passivity studies
2018
The aim of this article is to present photocurrent spectroscopy as useful in situ technique for the physicochemical characterization of passive films and corrosion layers. The response of (both amorphous and crystalline) semiconductor/electrolyte junction under irradiation is treated and discussed in order to get information about solid-state properties such as band gap and flat band potential. The possibility to use Photocurrent Spectroscopy (PCS), in a quantitative way, to get information on the composition of corrosion layers is discussed through a semiempirical correlation between the band gap of the oxides (or hydroxides) and the difference of electronegativity of their constituents. F…
Pressure effects on the electronic and optical properties ofAWO4wolframites (A =Cd, Mg, Mn, and Zn): The distinctive behavior of multiferroic MnWO4
2012
The electronic band-structure and band-gap dependence on the $d$ character of ${A}^{2+}$ cation in $A$WO${}_{4}$ wolframite-type oxides is investigated for different compounds ($A$ $=$ Mg, Zn, Cd, and Mn) by means of optical-absorption spectroscopy and first-principles density-functional calculations. High pressure is used to tune their properties up to 10 GPa by changing the bonding distances establishing electronic to structural correlations. The effect of unfilled $d$ levels is found to produce changes in the nature of the band gap as well as its pressure dependence without structural changes. Thus, whereas Mg, Zn, and Cd, with empty or filled $d$ electron shells, give rise to direct and…
Novel 2D boron nitride with optimal direct band gap: A theoretical prediction
2022
Abstract A novel structurally stable 2D-boron nitride material, namely di-BN, is predicted by means of the first-principles simulations. This monolayer BN system is composed of the azo (N-N) and diboron (B-B) groups. Its in-plane stiffness is close to the monolayer h-BN. Usually, the boron nitride materials are semiconductors with large band gaps. However, the monolayer di-BN possesses a moderate direct band gap of 1.622 eV obtained from our HSE06 calculation. Although the GW correction enlarges the band gap to 2.446 eV, this value is still in the range of the visible light. The detailed investigation of its band arrangement reveals that this material is able to product hydrogen molecules i…