Search results for "Spect"

showing 10 items of 28650 documents

The α and γ plasma modes in plasma-enhanced atomic layer deposition with O2-N2 capacitive discharges

2017

Two distinguishable plasma modes in the O2–N2 radio frequency capacitively coupled plasma (CCP) used in remote plasma-enhanced atomic layer deposition (PEALD) were observed. Optical emission spectroscopy and spectra interpretation with rate coefficient analysis of the relevant processes were used to connect the detected modes to the α and γ modes of the CCP discharge. To investigate the effect of the plasma modes on the PEALD film growth, ZnO and TiO2 films were deposited using both modes and compared to the films deposited using direct plasma. The growth rate, thickness uniformity, elemental composition, and crystallinity of the films were found to correlate with the deposition mode. In re…

010302 applied physicsMaterials scienceAcoustics and UltrasonicsCapacitive sensingAnalytical chemistry02 engineering and technologyPlasma021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesSpectral lineSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsAtomic layer depositionCrystallinity0103 physical sciencesDeposition (phase transition)plasma modesCapacitively coupled plasmaRadio frequency0210 nano-technologyplasma-enhanced atomic layer deposition
researchProduct

A review on LiNixCo1−2xMnxO2 (0.1 ≤ x ≤ 0.33) cathode materials for rechargeable Li-ion batteries

2021

Abstract Electrochemical and physical properties of LiNixCo1−2xMnxO2 (0.1 ≤ x ≤ 0.33) electrode materials prepared by self-combustion were investigated. Pure LiNixCo1−2xMnxO2 (x = 0.1, 0.2, 0.33) materials with single phase and R-3 m layered structure were obtained as confirmed by X-ray diffraction. Energy Dispersive Spectroscopy, Scanning Electron Microscopy are commonly used to determine the chemical composition and the distribution of particle size of the three samples. The electrochemical performances of the samples were measured at different current rates in the 3–4.5 V potential range. The studied materials exhibit good discharge capacity. The magnetic susceptibility measurements and …

010302 applied physicsMaterials scienceAnalytical chemistryEnergy-dispersive X-ray spectroscopyFonts d'energia02 engineering and technology021001 nanoscience & nanotechnology01 natural sciencesMagnetic susceptibilityCathodeIonlaw.inventionElectroquímicaParamagnetismlaw0103 physical sciencesDiamagnetism0210 nano-technologySpectroscopyElectron paramagnetic resonanceMaterials
researchProduct

New low-temperature phosphate glasses as a host for Europium Ions

2021

Abstract Artificial lightining, especially that of light emitting diodes, and telecommunications are penetrating every part of human lives daily. Different compositions phosphate glasses were suggested as a suitable host material for Eu3+ ions. Here rare earth metal ions act as luminescent centers also perturbing the bond order of phosphate glass network comprised of (PO4)3−, [−(O)PO3]2−, [−(O)2PO2]−, [−(O)3PO] structural units, which is indicated by Raman spectroscopy, confirming successful integration of aforementioned ions into the glass material. Glasses doped with Eu3+ ions show their typical photoluminescence spectra in low symmetry environment, consisting of the highest intensity 5D0…

010302 applied physicsMaterials scienceBorosilicate glassMetal ions in aqueous solutionInorganic chemistryDopingchemistry.chemical_elementGermanium02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesElectronic Optical and Magnetic MaterialsPhosphate glasssymbols.namesakechemistry0103 physical sciencesMaterials ChemistryCeramics and Compositessymbols0210 nano-technologyEuropiumLuminescenceRaman spectroscopyJournal of Non-Crystalline Solids
researchProduct

Synthesis of ZnO–Ag2CO3–Fe3O4@rGO core–shell structure: magnetically separable photocatalyst for degradation of MB using the Box–Behnken design

2020

In this work, a simple microwave method was utilized to prepare ZnO sheet linked with Fe3O4@rGO core–shell and of Ag2CO3 through formation of the quadri-photocatalytic with high activity. The microstructure, morphology, spectroscopic, and magnetic characteristics of the prepared samples were assessed using XRD, SEM, PL, TEM, FT-IR, DLS, and VSM analysis. The photocatalytic activity of the material was evaluated for photodegradation of methylene blue dye under the UV and visible light with home-made photoreactor. The response surface method in a Box–Behnken design was utilized to design the experiments. The parameters affecting the efficiency of the degradation including, pH (5–9), photocata…

010302 applied physicsMaterials scienceCondensed Matter PhysicsMicrostructure01 natural sciencesBox–Behnken designAtomic and Molecular Physics and OpticsElectronic Optical and Magnetic MaterialsCatalysischemistry.chemical_compoundchemistryChemical engineering0103 physical sciencesPhotocatalysisDegradation (geology)Fe3O4 magnetically separable photocatalyst photocatalysis photodegradationElectrical and Electronic EngineeringPhotodegradationMethylene blueVisible spectrumJournal of Materials Science: Materials in Electronics
researchProduct

High-pressure study of the infrared active modes in wurtzite and rocksalt ZnO

2011

International audience; We present a high-pressure study of ZnO carried out in the mid- to far-infrared frequency domain with the aim of characterizing the optic modes of wurtzite and rocksalt ZnO. We obtained the pressure coefficients of the E1(TO), E1(LO), A1(TO), and A1(LO) modes of the low-pressure wurtzite phase and compare them with previous Raman measurements. The optical modes of the high-pressure rocksalt phase are infrared active, so we were able to determine their wave numbers and pressure dependencies. In the wurtzite phase, high pressure induces a slight decrease in both longitudinal and transverse effective charges. The decrease is more pronounced in the rocksalt phase.

010302 applied physicsMaterials scienceCondensed matter physicsInfraredbusiness.industry02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesElectronic Optical and Magnetic MaterialsTransverse planesymbols.namesakeSemiconductorOpticsFrequency domainPhase (matter)[PHYS.COND.CM-GEN]Physics [physics]/Condensed Matter [cond-mat]/Other [cond-mat.other]0103 physical sciencessymbolsPACS : 78.30.Fs 64.70.kgWavenumber0210 nano-technologyRaman spectroscopybusinessWurtzite crystal structure
researchProduct

Acoustic vibrations of monoclinic zirconia nanocrystals

2011

International audience; Polarized low-frequency Raman spectra originating from confined acoustic vibrations are reported for monoclinic ZrO2 nanoparticles with a narrow size distribution synthesized from a continuous supercritical water process. The monoclinic lattice structure is taken into account for the interpretation of the spectra by comparing with isotropic and anisotropic continuum elasticity calculations for monodomain nanocrystals. The various mechanisms leading to the broadening of the Raman peaks are discussed. We demonstrate that an accurate determination of the size distribution of the nanoparticles is possible using the Raman peak due to the fundamental breathing vibration wh…

010302 applied physicsMaterials scienceCondensed matter physicsIsotropy[ PHYS.COND.CM-MS ] Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]02 engineering and technologyCrystal structure021001 nanoscience & nanotechnology01 natural sciencesSpectral lineSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsCrystallographysymbols.namesakeGeneral Energy0103 physical sciencessymbols[PHYS.COND.CM-MS]Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]Cubic zirconiaPhysical and Theoretical ChemistryElasticity (economics)0210 nano-technologyAnisotropyRaman spectroscopyMonoclinic crystal system
researchProduct

The influence of Cr and Ni doping on the microstructure of oxygen containing diamond-like carbon films

2021

Abstract Non-hydrogenated diamond-like carbon (DLC) films doped with metals and oxygen were deposited by direct current magnetron sputtering. The influence of chromium and nickel on the surface morphology, elemental composition, bonding structure, adhesion force, optical transmittance and nanohardness of the films was characterized by atomic force microscopy (AFM), energy dispersive X-ray spectroscopy (EDX), multi-wavelength Raman spectroscopy, UV–VIS–NIR spectrophotometry and nanoindenter. The surface roughness was reduced with the addition of Cr (7.4 at. %) or Ni (8.9 at. %) into DLC films. The EDX measurements indicated that the addition of Cr increased the oxygen content by ~37%, while …

010302 applied physicsMaterials scienceDiamond-like carbonDopingAnalytical chemistrychemistry.chemical_element02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter PhysicsMicrostructure01 natural sciencesSurfaces Coatings and FilmsChromiumNickelsymbols.namesakechemistry0103 physical sciencessymbolsSurface roughness0210 nano-technologyRaman spectroscopyInstrumentationCarbonVacuum
researchProduct

Structural characterization of TiO2/TiN O (δ-doping) heterostructures on (1 1 0)TiO2 substrates

2003

Abstract TiO2/TiNxOy δ-doping structures were grown on the top of (1 1 0)TiO2 rutile substrates by low pressure metal-organic vapor phase epitaxy (LP-MOVPE) technique at 750 °C. The samples were analyzed by high resolution transmission electron microscopy (HRTEM), electron energy loss spectroscopy (EELS) and X-ray diffraction techniques (rocking curves and φ-scans). The presence of satellites in the (1 1 0)TiO2 rocking curve revealed the epitaxial growth of 10 period δ-doping structures. The thickness of the TiO2 layers, 84 nm, was deduced from the satellites period. HRTEM observations showed around 1.5 nm thick δ-doping layers, where the presence of nitrogen was detected by EELS. The analy…

010302 applied physicsMaterials scienceElectron energy loss spectroscopyGeneral Physics and Astronomy02 engineering and technologySurfaces and InterfacesGeneral Chemistry021001 nanoscience & nanotechnologyCondensed Matter PhysicsEpitaxy01 natural sciencesElectron spectroscopySurfaces Coatings and FilmsCrystallographySurface coatingTransmission electron microscopy0103 physical sciencesX-ray crystallography[PHYS.COND.CM-MS]Physics [physics]/Condensed Matter [cond-mat]/Materials Science [cond-mat.mtrl-sci]Metalorganic vapour phase epitaxy0210 nano-technologyHigh-resolution transmission electron microscopyComputingMilieux_MISCELLANEOUS
researchProduct

EPR in glass ceramics

2019

Abstract The development of novel materials requires a profound understanding of the relationship between a material's performance and its structural properties. Electron paramagnetic resonance (EPR) is a well-established technique for a direct detection and identification of paramagnetic defects in solids. This chapter provides an overview of the applicability of continuous wave EPR spectroscopy in the studies of glass ceramics focusing on transition metal (Mn2 +, Cu2 +, Cr3 +) and rare earth (Gd3 +, Eu2 +, Er3 +, Yb3 +) ion local structure analysis. EPR spectra features of the above-mentioned paramagnetic probes in glasses and glass ceramics are compared and discussed in detail. The chapt…

010302 applied physicsMaterials scienceGlass-ceramic02 engineering and technology021001 nanoscience & nanotechnology01 natural sciencesSpectral lineIonlaw.inventionParamagnetismTransition metallawvisual_art0103 physical sciencesvisual_art.visual_art_mediumContinuous wavePhysical chemistryCeramic0210 nano-technologyElectron paramagnetic resonance
researchProduct

Effect of surface finishing on the oxidation behaviour of a ferritic stainless steel

2017

Abstract The corrosion behaviour and the oxidation mechanism of a ferritic stainless steel, K41X (AISI 441), were evaluated at 800 °C in water vapour hydrogen enriched atmosphere. Mirror polished samples were compared to as-rolled K41X material. Two different oxidation behaviours were observed depending on the surface finishing: a protective double (Cr,Mn) 3 O 4 /Cr 2 O 3 scale formed on the polished samples whereas external Fe 3 O 4 and (Cr,Fe) 2 O 3 oxides grew on the raw steel. Moreover, isotopic marker experiments combined with SIMS analyses revealed different growth mechanisms. The influence of surface finishing on the corrosion products and growth mechanisms was apprehended by means o…

010302 applied physicsMaterials scienceHydrogenMetallurgyGeneral Physics and AstronomyPolishingchemistry.chemical_element02 engineering and technologySurfaces and InterfacesGeneral Chemistry021001 nanoscience & nanotechnologyCondensed Matter PhysicsMicrostructure01 natural sciencesElectron spectroscopySurfaces Coatings and FilmsCorrosionX-ray photoelectron spectroscopychemistryResidual stress0103 physical sciences0210 nano-technologySurface finishingApplied Surface Science
researchProduct