Search results for "Surfaces"
showing 10 items of 2837 documents
VUV irradiance measurement of a 2.45 GHz microwave-driven hydrogen discharge
2015
Absolute values of VUV-emission of a 2.45 GHz microwave-driven hydrogen discharge are reported. The measurements were performed with a robust and straightforward method based on a photodiode and optical filters. It was found that the volumetric photon emission rate in the VUV-range (80-250 nm) is $10^{16}$-$10^{17}$ 1/cm$^3$s, which corresponds to approximately 8% dissipation of injected microwave power by VUV photon emission. The volumetric emission of characteristic emission bands was utilized to diagnostics of molecular plasma processes including volumetric rates of ionization, dissociation and excitation to high vibrational levels and metastable states. The estimated reaction rates impl…
Heusler compounds as ternary intermetallic nanoparticles: Co2FeGa
2009
This work describes the preparation of ternary nanoparticles based on the Heusler compound Co2FeGa. Nanoparticles with sizes of about 20?nm were synthesized by reducing a methanol impregnated mixture of CoCl2 ? 6H2O, Fe(NO3)3 ? 9H2O and Ga(NO3)3 ? xH2O after loading on fumed silica. The dried samples were heated under pure H2 gas at 900??C. The obtained nanoparticles?embedded in silica?were investigated by means of x-ray diffraction (XRD), transmission electron microscopy, temperature dependent magnetometry and M??bauer spectroscopy. All methods clearly revealed the Heusler-type L21 structure of the nanoparticles. In particular, anomalous XRD data demonstrate the correct composition in addi…
Intregrating metallic wiring with three-dimensional polystyrene colloidal crystals using electron-beam lithography and three-dimensional laser lithog…
2017
We demonstrate a method to fabricate narrow, down to a few micron wide metallic leads on top of a three-dimensional colloidal crystal self-assembled from polystyrene (PS) nanospheres of diameter 260 nm, using electron-beam lithography. This fabrication is not straightforward due to the fact that PS nanospheres cannot usually survive the harsh chemical treatments required in the development and lift-off steps of electron-beam lithography. We solve this problem by increasing the chemical resistance of the PS nanospheres using an additional electron-beam irradiation step, which allows the spheres to retain their shape and their self-assembled structure, even after baking to a temperature of 16…
Three-ring filters increase the effective NA up to 1.46 in optical sectioning fluorescence microscopy
2003
Single-photon fluorescence confocal microscopy techniques can be combined with the use of specific binary filters in order to increase their optical sectioning capability. We present a novel class of axially super-resolving binary pupil filters specially designed to reach this aim. These filters let us to obtain a relevant compression of the z-response together with the reduction of the photo-bleaching effect typically inherent to apodization techniques. The fact of joining both the three-ring filters we propose in the illumination path, and the confocal detection gives rise to an important effective increase of lenses of effective numerical aperture.
Thickness dependence of anomalous Hall conductivity in L10-FePt thin film
2019
L10 ordered alloys are ideal models for studying the anomalous Hall effect (AHE), which can be used to distinguish the origin from intrinsic (from band structure) or from extrinsic effects (from impurity scatterings). In the bulk limit of L10 ordered FePt films, the AHE is considered to be dominated by the intrinsic contribution, which mainly comes from the strong spin-orbit interaction (SOI) of Pt atoms and exchange-splitting of Fe atoms. The study of anomalous Hall conductivity (AHC) of L10-FePt thin films is of particular interest for its application in spintronic devices. In order to reduce the effects of defects such as grain boundaries, we chose SrTiO3 as the substrate which has a ver…
Laser irradiation of carbon–tungsten materials
2014
Carbon–tungsten layers deposited on graphite by thermionic vacuum arc (TVA) were directly irradiated with a femtosecond terawatt laser. The morphological and structural changes produced in the irradiated area by different numbers of pulses were systematically explored, both along the spots and in their depths. Although micro-Raman and Synchrotron-x-ray diffraction investigations have shown no carbide formation, they have shown the unexpected presence of embedded nano-diamonds in the areas irradiated with high fluencies. Scanning electron microscopy images show a cumulative effect of the laser pulses on the morphology through the ablation process. The micro-Raman spatial mapping signalled an…
Low-frequency band gap in cross-like holey phononic crystal strip
2018
International audience; A silicon-based cross-like holey phononic crystal (PnC) strip is proposed for the control of elastic waves in the field of micro-electro-mechanical systems (MEMS). The goal is to obtain a broad bandgap at low frequencies with a lightweight structure. In this respect, the effects of varying the in-plane and the out-of-plane geometry parameters are discussed. After design, a gap-to-midgap ratio of 47% is obtained with an intermediate filling fraction of the solid material and a small thickness of the strip. The band gap can be moved to an extremely low frequency range while keeping the strip significantly smaller than previously reported PnC strips. The transmission pr…
Effects of 5 MeV electron irradiation on deep traps and electroluminescence from near-UV InGaN/GaN single quantum well light-emitting diodes with and…
2020
The electrical properties, electroluminescence (EL) power output and deep trap spectra were studied before and after 5 MeV electron irradiation of near-UV single-quantum-well (SQW) light-emitting diodes (LED) structures differing by the presence or absence of InAlN superlattice underlayers (InAlN SL UL). The presence of the underlayer is found to remarkably increase the EL output power and the radiation tolerance of LEDs, which correlates with a much lower and more slowly changing density of deep traps in the QW region with radiation dose, and the higher lifetime of charge carriers, manifested by higher short-circuit current and open-circuit voltage in current–voltage characteristics under …
Non-radiative recombination centres in catalyst-free ZnO nanorods grown by atmospheric-metal organic chemical vapour deposition
2013
We have investigated the cathodoluminescence (CL) emission and the Raman spectra along individual ZnO nanorods grown by a catalyst-free method. The spatial correlation between the CL emission and the defect related Raman modes permits establishing a correspondence between the non-radiative recombination centres (NRRCs) and the defects responsible for the 275 cm−1 Raman band. According to this relation, the NRRCs in these nanorods are tentatively associated with complexes of zinc interstitials.
The multi-effects of K2TiF6 additive on the properties of PEO coatings on AZ31 Mg alloy
2020
Abstract Plasma electrolytic oxidation of AZ31 Mg alloy was performed in an alkaline silicate-based solution containing various concentrations of K2TiF6 using unipolar waveform at a constant voltage. The surface morphology of all coatings was rough and contained a micro-pore network, micro-cracks, and granules of oxide compounds in different diameters and micro-pore levels. The coating is composed of MgO, MgF2, Mg2SiO4, SiO2 (amorphous), and TiO2 (crystalline and amorphous) phases. The average thickness of the coatings was increased by adding the K2TiF6, where EDS results showed that a skinny fluoride-rich passive layer forms. With increasing time and reaching the final potential, the TiO2 …