Search results for "Surfaces"

Structural Characterization of Surfactant-Coated Bimetallic Cobalt/Nickel Nanoclusters by XPS, EXAFS, WAXS, and SAXS

2011

Cobalt nickel bimetallic nanoparticles were synthesized by changing the sequence of the chemical reduction of Co(II) and Ni(II) ions confined in the core of bis(2-ethylhexyl)phosphate (2)., and Ni(DEHP)(2). The reduction was carried out by mixing, sequentially or contemporaneously, fixed amounts of n-heptane solution of Co(DEHP)2 and Ni(DEHP)2 micelles with a solution of sodium borohydride in ethanol at a fixed (reductant)/(total metal) molar ratio. This procedure involves the rapid formation of surfactant-coated nanoparticles, indicated as Co/Ni (Co after Ni), Ni/Co (Ni after Co), and Co + Ni (simultaneous), followed by their slow separation as nanostructures embedded in a sodium bis(2-eth…

Diastereomeric control of enantioselectivity: evidence for metal cluster catalysis

2014

Enantioselective hydrogenation of tiglic acid effected by diastereomers of the general formula [(μ-H)2Ru3(μ3-S)(CO)7(μ-P–P*)] (P–P* = chiral Walphos diphosphine ligand) strongly supports catalysis by intact Ru3 clusters. A catalytic mechanism involving Ru3 clusters has been established by DFT calculations. peerReviewed

Results on performance and ageing of solar modules based on Elkem Solar Silicon (ESS™) from installations at various locations

2014

Abstract The present study aims to present the current status of the results obtained using Elkem Solar Silicon (ESS™) as feedstock basis for solar cell and modules. It is shown that solar cells based on ESS™ are able to follow the development of the solar industry obtaining comparable efficiencies to standard polysilicon based cells. The characteristics of ESS™ based solar cells, having normally higher V oc and FF and lower I sc , seem to give clear advantages in the field for solar modules located at high irradiance areas. Results from several locations show enhanced electricity production of ESS™ based solar modules compared to polysilicon at increasing solar irradiance. This is explaine…

Distribution and generation of traps in SiO2/Al2O3 gate stacks

2007

In this work we combine charge-pumping measurements with positive constant voltage stress to investigate trap generation in SiO2/ Al2O3 n-MOSFET. Trap density has been scanned either in energy or in position based on charge-pumping (CP) measurements performed under different operating conditions in terms of amplitude and frequency of the gate pulse. Our results have revealed that the traps are meanly localized shallow in energy level, deeper in spatial position and they are mostly generated near the Si/SiO2 interface. (C) 2007 Elsevier Ltd. All rights reserved.

Gas-Phase Hydrogenation of Propionitrile Catalyzed by LnCu2 (Ln = La, Ce, Pr, Nd)

2007

The hydrogenation of propionitrile over binary copper−lanthanide intermetallic compounds (LnCu2, Ln = La, Ce, Pr, Nd) was studied in the gas phase. The results show that the reaction main product is the primary amine, the n-propylamine. To our knowledge, it is the first time that such behavior is reported for copper catalysts.

Politik der Debatte

2023

Tetracyclic silaheterocycle formed through a pericyclic reaction cascade including a two-fold intramolecular C–C bond activation

2022

Reductive debromination of the tribromoamidosilane 2 gave the tetracyclic silaheterocycle 3 through a unique reaction cascade involving unprecedented two-fold intramolecular cycloaddition by transient silylenes. Experimental and computational analyses of the reaction mechanism allowed the identification of the key intermediates that lead to the silaheterocycle 3 or, alternatively, to the cyclotrisilene 19. peerReviewed

Tribological properties of thin films made by atomic layer deposition sliding against silicon

2018

Interfacial phenomena, such as adhesion, friction, and wear, can dominate the performance and reliability of microelectromechanical (MEMS) devices. Here, thin films made by atomic layer deposition (ALD) were tested for their tribological properties. Tribological tests were carried out with silicon counterpart sliding against ALD thin films in order to simulate the contacts occurring in the MEMS devices. The counterpart was sliding in a linear reciprocating motion against the ALD films with the total sliding distances of 5 and 20 m. Al2O3 and TiO2 coatings with different deposition temperatures were investigated in addition to Al2O3-TiO2-nanolaminate, TiN, NbN, TiAlCN, a-C:H [diamondlike car…

A simple methodology for comparing cost-benefit of traditional, green and cool roofs

2019

Energy policy makers, architects and researchers, when designing new buildings or rehabilitating the existing ones, are engaged in the attempt of limiting the energy needs for climatization (NZEB buildings) and the environmental pressure exerted by buildings (EU Climate Action). The pursuit of this demanding assignment calls for innovative solutions in conceiving the building envelope and its energy systems. Recently, among the most effective tools for improving the energy and environmental performances of buildings, the technical interventions regarding the roofs are gaining a rising attention. Indeed, covers of buildings are responsible of a relevant part of their energy losses and, on th…

Green approach to corrosion inhibition of stainless steel in phosphoric acid of Artemesia herba albamedium using plant extract

2019

Essential oil from aerial parts of Artemisia herba-alba from Morocco was hydrodistilled and its chemical composition oil was investigated by capillary GC and GC/MS. The major components were 1,8-cineole (35.6%) and camphor (24.1%). Artemisia herba-alba essential oil AHAO was tested as corrosion inhibitor of stainless steel (SS) in 1M H3PO4 using potentiodynamic polarization (PDP) and electrochemical impedance spectroscopy measurements (EIS) and scanning electronically microscopy (SEM) studies. The results obtained showed that the essential oil of Artemisia reduces the corrosion rate. Tafel polarization method indicates that the plant extract behaves as a mixed type inhibitor. The inhibition…