Search results for "X-ray photoelectron spectroscopy"
showing 10 items of 416 documents
Structural and thermal stability of graphene oxide-silica nanoparticles nanocomposites
2017
Abstract The investigation of the thermal stability up to 400 °C of Graphene Oxide (GO) and GO-silica nanoparticles (n-SiO2) composites prepared by direct mixture of GO and n-SiO2 is reported. Using Scanning Electron Microscopy, X-ray Photoelectron Spectroscopy, Energy Dispersive X-ray analysis, Atomic Force Microscopy, Raman and Infrared absorption measurements a thorough characterization of the prepared materials is carried out. By deepening the changes induced in the 2D Raman spectral region of GO at about 2900 cm−1 the comprehension of an interplay, driven by the thermally induced changes of the material, between inter-valley and intra-valley vibrational transitions is elucidated. This …
Optical modeling of nickel-base alloys oxidized in pressurized water reactor
2012
International audience; The knowledge of the aging process involved in the primary water of pressurized water reactor entails investigating a mixed growth mechanism in the corrosion of nickel-base alloys. A mixed growth induces an anionic inner oxide and a cationic diffusion parallel to a dissolution-precipitation process forms the outer zone. The in situ monitoring of the oxidation kinetics requires the modeling of the oxide layer stratification with the full knowledge of the optical constants related to each component. Here, we report the dielectric constants of the alloys 600 and 690 measured by spectroscopic ellipsometry and fitted to a Drude-Lorentz model. A robust optical stratificati…
Investigation of pitting resistance of titanium based on a modified point defect model
2011
Abstract The pitting resistance of titanium was studied under potential control in solutions containing chloride ions. The results evidenced that Cl − concentration had an effect on the metastable pitting intensity, but no significant influence on the uniform corrosion. XPS characterization revealed that some Cl − ions were present in the outer hydroxide layer, but few in the inner oxide layer, indicating that the inner oxide layer was impervious to Cl − ions. A cation–anion-vacancy condensation mechanism was considered for pit initiation based on the point defect model (PDM). The experimental results analyzed by the charge integration technique were in agreement with the derived relations.
X-ray photoemission studies of the electronic structure of single-crystalline CdO(100)
2007
The electronic structure of single-crystalline CdO is investigated using X-ray photoemission spectroscopy. The surface is prepared by in situ Ar+ ion bombardment and annealing (IBA). The core level spectra before and after the IBA are presented, and reveal a dramatic reduction in the surface contamination. The semi-core Cd 4d level and valence band region following the IBA are also shown. The surface Fermi level is pinned 1.3 +/- 0.10 eV above the valence band maximum. (c) 2007 Elsevier Ltd. All rights reserved.
Inhibition of Cor-Ten steel corrosion by “green” extracts of Brassica campestris
2018
Abstract Extract of Brassica campestris was tested as potential corrosion inhibitor for Cor-Ten steel in NaCl and acidic solutions, simulating a marine and an urban-industrial environment, respectively. Potentiodynamic polarization and electrochemical impedance spectroscopy (EIS) were performed both in absence and in presence of the extract at room temperature. The surface chemical analysis was investigated by X-ray Photoemission Spectroscopy (XPS), before and after corrosion. Electrochemical results demonstrated that a very small concentration of Brassica campestris extracts can inhibit Cor-Ten corrosion in NaCl solution (inhibition efficiency of 80–84%) better than in acidic solutions. Su…
Structure and chemical bonds in reactively sputtered black Ti–C–N–O thin films
2011
The evolution of the nanoscale structure and the chemical bonds formed in Ti–C–N–O films grown by reactive sputtering were studied as a function of the composition of the reactive atmosphere by increasing the partial pressure of an O2+N2 gas mixture from 0 up to 0.4 Pa, while that of acetylene (carbon source) was constant. The amorphisation of the films observed by transmission electron microscopy was confirmed by micro- Raman spectroscopy, but it was not the only effect associated to the increase of the O2+N2 partial pressure. The chemical environment of titanium and carbon, analysed by X-ray photoemission spectroscopy, also changes due to the higher affinity of Ti towards oxygen and nitro…
Non-linear optical study of hierarchical 3D Al doped ZnO nanosheet arrays deposited by successive ionic adsorption and reaction method
2020
Abstract Successive ionic layer adsorption and reaction (SILAR) method is based on the adsorption and reaction of the ions in the cationic solution and the ionic solution, respectively. This method is simple, inexpensive, large-scale deposition, effective way for deposition on 3D substrates, low-temperature process and represents an easy way for the preparation of doped, composite and heterojunction materials. To take advantage of this method and the ZnO nanostructures, various parameters have been optimized. Undoped and Aluminum (Al) doped ZnO nanostructures were prepared by the SILAR technique. The characterization of the nanostructures prepared was carried out using X-ray diffraction (XR…
Electronic structure of delta-doped $La:SrTiO_{3}$ layers by hard X-ray photoelectron spectroscopy
2012
We have employed hard x-ray photoemission (HAXPES) to study a delta-doped SrTiO3 layer that consisted of a 3-nm thickness of La-doped SrTiO3 with 6% La embedded in a SrTiO3 film. Results are compared to a thick, uniformily doped La:SrTiO3 layer. We find no indication of a band offset for the delta-doped layer, but evidence of the presence of Ti3+ in both the thick sample and the delta-layer, and indications of a density of states increase near the Fermi energy in the delta-doped layer. These results further demonstrate that HAXPES is a powerful tool for the non-destructive investigation of deeply buried doped layers.
3d impurities in Al: density functional results
1980
Self-consistent spin density functional calculations have been carried out for 3d transition metal impurities in aluminium. The width of the virtual level decreases as it moves away from the Fermi energy with increasing occupancy. The results are compared with recent XPS measurements.
A nondestructive analysis of the B diffusion in Ta–CoFeB–MgO–CoFeB–Ta magnetic tunnel junctions by hard x-ray photoemission
2010
This work reports on hard x-ray photoelectron spectroscopy (HAXPES) of CoFeB based tunnel junctions. Aim is to explain the role of the boron diffusion for the observed improvement of the tunneling magnetoresistance ratio with increasing annealing temperature. The high bulk sensitivity of HAXPES was used as a nondestructive technique to analyze CoFeB–MgO–CoFeB magnetic tunnel junctions. The investigated samples were processed at different annealing temperatures from 523 to 923 K. Hard x-ray core level spectroscopy reveals an enforced diffusion of boron from the CoFeB into the adjacent Ta layer with increasing annealing temperature. The dependence of the tunneling magnetoresistance on the ann…