Search results for "fiber"
showing 10 items of 2343 documents
Effect of UD carbon on the specific mechanical properties of glass mat composites for marine applications
2009
In this work the influence of a uniaxial carbon fabric layer on the mechanical performances of a glass mat/epoxy composite used for marine applications has been studied. All the structures have been made, at room temperature, by vacuum bagging technique. Tension and flexural tests have been carried out in order to evaluate the specific mechanical properties of the composite and to compare these with those of the marine aluminium alloy 6016-T4. The glass composites have higher specific strength but lower specific modulus than aluminium alloy. To increase the specific modulus of the composites, each layer of glass mat has been replaced with a layer of uniaxial carbon fabric. In addition, a s…
Strength and Damage of Elementary Flax Fibers Extracted from Tow and Long Line Flax
2009
Flax fibers possess high specific strength and stiffness, and thus are competitive in terms of mechanical properties with traditional reinforcing fibers used in polymer-matrix composite materials. For environmental and economical benefit, it would be preferable to apply nontextile grade fibers in composites provided their mechanical characteristics are acceptable. Elementary fibers have been extracted from long line flax, used as high-quality raw material for textile industry, and flax tow, and their strength distribution and damage level determined. It is shown that the elementary flax fibers coming from short flax fiber are not inferior to those of textile-quality flax in terms of streng…
X-ray irradiation effects on fluorine-doped germanosilicate optical fibers
2014
International audience; We report an experimental investigation on the effects of fluorine codoping on the radiation response of Ge-doped Optical Fibers (OFs) obtained by three different drawing conditions. The OFs were irradiated with 10 keV X-rays up to 300 Mrad and studied by online Radiation-Induced-Attenuation (RIA) measurements. Confocal Micro- Luminescence (CML) and Electron Paramagnetic Resonance (EPR) were also employed to investigate the permanent radiation-induced-defects. The variation of the Germanium-Lone-Pair-Center (GLPC) and Non-Bridging- Oxygen-Hole-Centers (NBOHC) concentration with the radiation dose is investigated by CML, whereas the ones of the induced Ge(1), Ge(2) an…
Influence of neutron and gamma-ray irradiations on rad-hard optical fiber
2015
We investigated point defects induced in rad-hard Fluorine-doped optical fibers using both a mixed source of neutrons (fluences from 1015 to 1017 n/cm2) and γ-rays (doses from 0.02 to 2 MGy) and by a γ-ray source (dose up to 10 MGy). By combining several complementary spectroscopic techniques such as radiation-induced attenuation, confocal micro-luminescence, time-resolved photo-luminescence and electron paramagnetic resonance, we evidenced intrinsic and hydrogen-related defects. The comparison between the two irradiation sources highlights close similarities among the spectroscopic properties of the induced defects and the linear correlation of their concentration up to 1016 n/cm2. These r…
Novel photoreception system in sponges?
2006
Abstract Sponges (phylum Porifera) of the classes Hexactinellida and Demospongiae possess a skeleton composed of siliceous spicules, which are synthesized enzymatically. The longest spicules are found among the Hexactinellida, with the stalk spicules (length: 30 cm; diameter: 300 μm) of Hyalonema sieboldi as prominent examples. These spicules are constructed around a central axial filament, which is formed by approximately 40 siliceous layers. The stratified spicules function as optical glass fibers with unique properties. If free-spaced coupled with a white light source (WLS), the entire fiber is illuminated. Special features of the light transmission: (i) only wavelengths between 615 and …
Light Scattering Measurements of Hemoglobin Critical Fluctuation and the Energy Landscape For Polymerization
2010
We have developed a novel method for measuring light scattering to observe critical fluctuations in hemoglobin (Hb) solutions. A small rectangular cell (0.2 x 4.0 x 30 mm) is filled with 24 μL of Hb solution. An optical fiber with outer diameter of 125 μm (62.5 μm core) is sealed into the cell in contact with the solution, and light scattering is measured at 90°. The flat faces of the cell permit measuring absorbance spectra to ensure sample integrity. The scattering source is a 785 nm laser diode that delivers 1.5 mW to the sample. Scattered light is detected by a Hamamatsu GaAs(Cs) PMT via a LWD microscope objective. Measured scattered light intensity agrees (±10%) with scattered intensit…
Photothermal nanofibrillar membrane based on hyaluronic acid and graphene oxide to treat Staphylococcus aureus and Pseudomonas aeruginosa infected wo…
2022
Here we reported the fabrication of an electrospun membrane based on a hyaluronic acid derivative (HA-EDA) to be used as a bandage for the potential treatment of chronic wounds. The membrane, loaded with graphene oxide (GO) and ciprofloxacin, showed photothermal properties and light-triggered drug release when irradiated with a near-infrared (NIR) laser beam. Free amino groups of HA-EDA derivative allowed autocrosslinking of the elec- trospun membrane; thus, a substantial enhancement in the hydrolytic resistance of the patch was obtained. In vitro antibacterial activity studies performed on Staphylococcus aureus and Pseudomonas aeruginosa revealed that such electrospun membranes, due to the…
Quinoa wet-milling: Effect of steeping conditions on starch recovery and quality
2019
Cereal starches play an important role in the food and non-food industries because of their low cost, availability, and ability to impart a wide range of techno-functional properties. The main objective of this research was to isolate starch, germ, protein, and fiber components from quinoa by a wet-milling procedure. The effect of steeping time and temperature on starch recovery and its quality was investigated. The quinoa steeping conditions, such as time (1, 5, and 9 h) and temperature (30, 40, and 50 °C), in SO2 solution with lactic acid were investigated using a 32 factorial design in order to optimize the starch separation and its quality. The effect of steeping conditions on starch wa…
Effect of Cholesterol on Electrostatics in Lipid−Protein Films of a Pulmonary Surfactant
2010
We report the changes in the electrical properties of the lipid-protein film of pulmonary surfactant produced by excess cholesterol. Pulmonary surfactant (PS) is a complex lipid-protein mixture that forms a molecular film at the interface of the lung's epithelia. The defined molecular arrangement of the lipids and proteins of the surfactant film gives rise to the locally highly variable electrical surface potential of the interface, which becomes considerably altered in the presence of cholesterol. With frequency modulation Kelvin probe force microscopy (FM-KPFM) and force measurements, complemented by theoretical analysis, we showed that excess cholesterol significantly changes the electri…
ANALYTICAL DETERMINATION OF INITIAL CONDITIONS LEADING TO FIRING IN NERVE FIBERS
2007
International audience; An analytical solution characterizing initial conditions leading to action potential firing in smooth nerve fibers is determined, using the bistable equation. In the first place, we present a nontrivial stationary solution wave, then, using the perturbative method, we analyze the stability of this stationary wave. We show that it corresponds to a frontier between the initiation of the travelling waves and a decay to the resting state. Eventually, this analytical approach is extended to FitzHugh-Nagumo model.