Search results for "integrated circuit"
showing 10 items of 130 documents
An electrical current smart transducer based on PSoC platform and integrated spin-valve sensor with embedded thin film Ruthenium temperature sensor
2011
This work presents an intelligent electrical current sensor that combines a programmable system on chip (PSoC) with a microfabrication of a giant magnetoresistance sensor (GMR) and resistive temperature detector (RTD). Four spin-valve GMR elements configured in a Wheatstone bridge sense the electrical current, while a thin film RTD based on Ruthenium measures the temperature for spin-valve bridge sensitivity thermal compensation. The mixed signal PSoC allows implement in a single chip all electronic circuits needed to design a smart transducer: the spin-valve biasing, conditioning signal, analog to digital converter, digital signal processing and ports for communications. In the experimenta…
Power monitoring in dielectric-loaded plasmonic waveguides with internal Wheatstone bridges
2013
We report on monitoring the mode power in dielectric-loaded surface plasmon polariton waveguides (DLSPPWs) by measuring the resistance of gold electrodes, supporting the DLSPPW mode propagation, with internal (on-chip) Wheatstone bridges. The investigated DLSPPW configuration consisted of 1-μm-thick and 10-μm-wide cycloaliphatic acrylate polymer ridges tapered laterally to a 1-μm-wide ridge placed on a 50-nm-thin and 4-um wide gold stripe, all supported by a ~1.7-µm-thick Cytop layer deposited on a Si wafer. The fabricated DLSPPW power monitors were characterized at telecom wavelengths, showing very high responsivities reaching up to ~6.4 μV/μW (for a bias voltage of 245 mV) and the operati…
Cluster matching in time resolved imaging for VLSI analysis
2014
International audience; If scaling has the benefit of enabling manufacturers to design tomorrow's integrated circuits, from the failure analyst point of view it also has the drawback of making devices more complex. The test sequence for modern VLSI can be quite long, with thousands of vector. Dynamic photon emission databases can contain millions of photons representing thousands of state changes in the region of interest. Finding a candidate location where to perform physical analysis is quite challenging, especially if the fault occurs on a single vector. In this paper, we suggest a new methodology to find single vector fault in dynamic photon emission database. The process is applied at …
Near-field spectroscopy of low-loss waveguide integrated microcavities
2006
International audience; A scanning near-field spectroscopy method is used to observe loss reduction and Q-factor enhancement due to transverse-mode profile matching within photonic-crystal microcavities. Near-field measurements performed directly on cavity modes are compared with three-dimensional calculations and quantitative agreement is observed. (c) 2006 American Institute of Physics.
Interface engineering for improved light transmittance through photonic crystal flat lenses
2010
In this paper, we present photonic crystal flat lenses with interfaces engineered to improve the light transmittance thanks to a broad angles impedance matching. The interface engineering consists in the realization of antireflection gratings on the edges of the lenses which are designed to reduce the propagative waves reflectivity over a wide range of incident angles. The fabricated structures were measured in optical near-field and a four times enhancement of the light transmission efficiency is reported.
Dielectric-loaded plasmonic waveguide-ring resonators
2009
International audience; Using near-field microscopy, the performance of dielectric-loaded plasmonic waveguide-ring resonators (WRRs) operating at telecom wavelengths is investigated for various waveguide-ring separations. It is demonstrated that compact ( footprint similar to 150 mu m(2)) and efficient ( extinction ratio similar to 13 dB) WRR-based filters can be realized using UV-lithography. The WRR wavelength responses measured and calculated using the effective-index method are found in good agreement. (c) 2009 Optical Society of America
Bloch mode coupling investigation in silicon-on-insulator W1 photonic crystal waveguide
2004
We report in this paper the study of a W1 photonic crystal waveguide which supports two Bloch modes having different parity. A monomode ridge waveguide etched in a Silicon-On-Insulator substrate and connecting to the photonic crystal waveguide allows us to excite the even Bloch mode. Transmission measurements, performed on a broad spectral range, evidence the even mode propagation along the defect line and experimental spectrum is discussed in light of band diagram and FDTD calculations. Then spectrally resolved near-field patterns obtained by using a scanning near field optical microscope in collection mode for wavelengths inside and outside the multimode region of the photonic crystal wav…
A near-field actuated optical nanocavity
2008
International audience; We demonstrate here that switching and tuning of a nanocavity resonance can be achieved by approaching a sub-micrometer tip inside its evanescent near-field. The resonance energy is tuned over a wide spectral range (Δλ/λ~10-3) without significant deterioration of the cavity peak-transmittance and of the resonance linewidth. Such a result is achieved by taking benefits from a weak tip-cavity interaction regime in which the tip behaves as a pure optical path length modulator.
Bend- and splitting loss of dielectric-loaded surface plasmon-polariton waveguides.
2008
International audience; The design, fabrication, characterization, and modeling of basic building blocks of plasmonic circuitry based on dielectric- loaded surface polariton waveguides, such as bends, splitters, and Mach- Zehnder interferometers are presented. The plasmonic components are realized by depositing subwavelength dielectric ridges on a smooth gold film using mass-production- compatible UV-photolithography. The near-field characterization at telecommunication wavelengths shows the strong mode confinement and low radiation and bend losses. The performance of the devices is found in good agreement with results obtained by full vectorial three-dimensional finite element simulations.…
Dielectric-loaded surface plasmon-polariton waveguides at telecommunication wavelengths: Excitation and characterization
2008
International audience; The excitation and propagation of strongly confined surface plasmon-polariton (SPP) waveguide modes, supported by 500-nm-wide and 550-nm-high dielectric ridges fabricated on smooth gold films, are investigated at telecommunication wavelengths using a scanning near-field optical microscope. Different tapering structures for coupling of SPPs, excited at bare gold surfaces, into dielectric-loaded SPP waveguide (DLSPPW) modes are considered. The DLSPPW mode confinement and propagation loss are characterized. The DLSPPW mode propagation along an S bend having the smallest curvature radius of 2.48 mu m is shown, demonstrating the potential of DLSPPW technology for the real…