Search results for "visual_art"

Improved Preparations of Molybdenum Coordination Compounds from Tetrachlorobis(diethyl ether)molybdenum(IV)

2001

International audience; The reduction of MoCl5 with metallic tin in diethyl ether provides a rapid and convenient entry to [MoCl4(OEt2)2] This compound can be transformed easily and in high yields into a variety of other useful synthons. The loss of ether in the solid state affords a new and reactive form of MoCl4. Treatment with THF, PMe3 or LiOtBu affords [MoCl4(THF)2], [MoCl4(PMe3)3] or [Mo(OtBu)4] in high isolated yields. Treatment with metallic tin in THF affords [MoCl3(THF)3] All of these reactions can be carried out under simple experimental conditions and represent significant improvements relative to previously reported syntheses of the same compounds.

Partial Discharge Tests Using CIGRE Method II Upon Nanocomposite Epoxy Resins

2007

Nanocomposite polymers are becoming a new family of dielectric materials with promising insulating properties. In order to apply this technology to insulation systems, a study about the material longterm endurance (life) is needed. In this paper results from comparative life tests performed upon base and nanostructured epoxy resin samples are presented. The nanofiller is a organophillic-modified ultra-clean montmorillonite. Specimens were subjected to ageing under surface discharge phenomena using a standard electrode configuration, that is the CIGRE method II. Life data and partial discharge phase resolved patterns, acquired during time under stress, are presented and commented, in order t…

Bio-inspired Resorbable Calcium Phosphate-Polymer Nanocomposites for Bone Healing Devices with Controlled Drug Release

2011

In orthopedic research, increasing attention is being paid to bioresorbable composite materials as an attractive alternative to permanent metal bone healing devices. Typical composites consist of a biodegradable polyester matrix loaded with bioactive calcium phosphate ceramic particles (tricalcium phosphate, TCP or hydroxyapatite, HA) added to improve the biological response and mechanical properties of the neat polymer. The mechanical behavior of such particle-reinforced composites, however, falls far short of the expected performance in high-load bearing situations. Replicating some features of nacre—a strong and tough natural nanocomposite with a very high content of brittle inorganic ph…

Experimental Studies for Modelling the Phase Behaviour of Monomer/Polymer/Disc Composites

2010

Nanoparticles do not stabilize the mixtures of epoxy monomer (prepolymer)/thermoplastic modifier (PS) and the ones of thermoplastic modifier dispersed within cured epoxy matrix. A small amount of thermoplastic co-polymer poly(styrene-b-methyl methacrylate) [P(S-b-MMA)] of MMA 4-22 wt.%, mixed with PS, makes compatible the mixtures with monomer epoxy precursor and cured epoxy matrix. The mixtures of cured epoxy matrix with thermoplastic consisting of PS and P(S-b-MMA), with nanofil 1%, are stable: the instability produced by the nanofil is overcome by the stability provided by the co-polymer. A model by Balazs' group to explain the phase behaviour of polymer/clay composites is extended.

Metal nanoparticle/polymer superlattice films: Fabrication and control of layer structure

1997

Über die verschiedenen mittelwerte des molekulargewichts und die uneinheitlichkeit von naturkautschuk und synthetischem cis-polyisopren

1969

An Naturkautschuk und einem cis-Polyisopren von annahernd gleichem [η]-Wert wurden Molekulargewichtsbestimmungen durch Diffusion-Sedimentation, Osmose und Lichtstreuung gemacht. Aus den Mittelwerten Mn (osmotisch) und Mw (Lichtstreuung) wird die molekulare Uneinheitlichkeit bestimmt. Bei etwa gleichem Mw (2·106) ist das osmotische Molekulargewicht Mn bei Naturkautschuk 3,0·105 und beim synthetischen cis-Polyisopren 6,2·105. Auserdem macht sich beim Naturkautschuk ein nur schwer entfernbarer Anteil von Mikrogelen bemerkbar. Da die Tragheitsradien und die Wechselwirkungsparameter mit den Losungsmitteln fur Natur- und Synthesekautschuk sich nur wenig unterscheiden, konnen technologische Unters…

Properties and morphology of PMMA/ABN blends obtained via MMA in situ polymerisation through γ-rays

2001

Abstract Methylmethacrylate polymerisation in the presence of 4 wt% butadiene-acrylonitrile rubber was carried out at fixed dose-rate and temperature. The effect of irradiation was investigated with respect to the mechanical and dynamic-mechanical properties in the solid state. A general increase of the “compatibilisation” on irradiation is obtained. In fact both rubber and polymethylmethacrylate glass transition temperatures, determined through dynamic-mechanical analysis, reveal the presence of strong interactions between the components. Furthermore an improvement of the mechanical tensile properties of the blends is observed when irradiation is continued after polymerisation, at least un…

Influence of the position of two dehydro-amino acids residues in the oligopeptide sequence on the binding ability towards Cu(II) ions

2005

Abstract Studies on the binding ability of bis-dehydro-hexa- and pentapeptides have shown that the hexapeptides bind Cu+2 with similar efficacy as pentapeptides. The increase of distance between two dehydro-amino acid residues in the peptide backbone has no impact on the efficacy in metal ion binding. The type of isomeration [(Z) or (E)] has an influence on the coordination of the metal ion only to the first amide nitrogen.

Oxidative cyclization of some aldehyde semicarbazones induced by metallic salts

1993

The oxidative cyclization of some aldehyde semicarbazones 10 with four different oxidizing agents has been effected. The structure of the semicarbazones and the nature of cyclizing agent affected the rate and yield of cyclization but they did not show any influence on the regiochemistry of reaction. In fact, 1,2,4-triazoline 20 was the only heterocyclic ring obtained by the cyclization reaction.

ChemInform Abstract: Oxidative Cyclization of Some Aldehyde Semicarbazones Induced by Metallic Salts.

2010

The oxidative cyclization of some aldehyde semicarbazones 10 with four different oxidizing agents has been effected. The structure of the semicarbazones and the nature of cyclizing agent affected the rate and yield of cyclization but they did not show any influence on the regiochemistry of reaction. In fact, 1,2,4-triazoline 20 was the only heterocyclic ring obtained by the cyclization reaction.